Instruction/ maintenance manual of the product 1150 Series Ultra Start
Go to page of 8
1150 Series R emote Star ter s -The system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no liability or responsibility for accidental starting of the vehicle.
INST ALLATION MANUAL REMOTE V EHICLE S T ARTER Page 2 If the remote starter has a failed st art attempt or if a safety input is activated the Diagnostic Memory will store up to four shutdowns in memory . This information can then be accessed to determine the source of the shutdown.
REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Page 3 The jumpers control the output from the white wire from the six pin harness. Place the jumpers in the following order to change the output. Note: The default setting is second ignition. * Connect only one of these wires for remote st art activation.
Page 4 INST ALLATION MANUAL REMOTE V EHICLE S T ARTER Y ellow Starter 30amp output 12volts during crank only . Green Heater 30amp output 12volts in accessory off during start. Red 12 power 30amp input Constant 12volt power at ignition harness. Red 12 power 30amp input Constant 12volt power at ignition harness.
REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Page 5 Y ellow St arter Output Connect T o The V ehicles S tarter Wire. Green Heater Output Connect T o The V ehicles Accessory Wire. Red 12 power Input Connect to Constant 12 V olt Power Source - High Current.
Page 6 INST ALLATION MANUAL REMOTE V EHICLE S T ARTER Programming Overview Entering Program Mode Changing the Programmable Settings SYSTEM RESET Program mode allows you to adjust the settings and options of your system. Y our system has been intelligently designed by installers with years of experience.
Page 7 REMOTE V EHICLE S T ARTER INST ALLATION MANUAL 1 T ype 1 1 Flash Pulse after start and with lock 2 T ype 2 2 Flashes Pulse after start only 3* Factory Re-arm 3 Flashes 0.
Page 8 INST ALLATION MANUAL REMOTE V EHICLE S T ARTER 1T ach Detection Mode 1 Flash Set for T ach Detection - Must Connect T ach Wire *2T achless Mode 2 Flashes No T ach connection required Press the .
An important point after buying a device Ultra Start 1150 Series (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Ultra Start 1150 Series yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Ultra Start 1150 Series - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Ultra Start 1150 Series you will learn all the available features of the product, as well as information on its operation. The information that you get Ultra Start 1150 Series will certainly help you make a decision on the purchase.
If you already are a holder of Ultra Start 1150 Series, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Ultra Start 1150 Series.
However, one of the most important roles played by the user manual is to help in solving problems with Ultra Start 1150 Series. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Ultra Start 1150 Series along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
