Instruction/ maintenance manual of the product Datacenter INT Tripp Lite
Go to page of 8
1 Copyright ©2000 Tripp Lite. All rights reserved. SmartPro ® is a registered trademark of Tripp Lite. Quic k Installation: p. 3 - 4 Basic Operation: p. 5 - 7 Storage & Service: p. 8 Specifications: p. 8 Safety: p. 2 1111 W. 35th Street Chicago, IL 60609 USA Customer Support: (773) 869-1234 www.
2 This manual contains important instructions and warnings that should be followed during the installation, operation and storage of all Tripp Lite UPS Systems. UPS Location W arnings • Install your UPS indoors, away from excess moisture or heat, dust or direct sunlight.
3 Quick Installation P osition y our External Batter y Pack(s). • If positioning multiple Battery Packs, place them side by side or stack them no more than three high. P osition your P ower Module . • The Module may be stacked on top of your Battery Packs or placed beside them.
4 DB9 P or t Connection –Optional–* Using the grey or tan Tripp Lite cable that came with your UPS, connect your primary server’s DB9 port to the single DB9 port labeled “LAN 4.1” or "Smart LAN Primary" (which provides complete intelligent RS-232 communications).
5 Basic Operation Switches System Switch (Middle Back Panel) This switch activates the UPS's battery charger and intelligent microprocessor. ALWAYS leave it in the “ENABLE” (RIGHT) position when your UPS is plugged in. Only set the switch to “DISABLE” (LEFT) to reduce battery drain when you unplug your UPS for storage or shipping.
6 Indicator Lights Light descriptions apply when the UPS is plugged into a wall outlet and turned ON. This green light will shine constantly to indicate AC power is available at the receptacles. It will flash to indicate AC power is not available. (See “System Enable Switch” and “On/Standby Switch” descriptions above.
7 Other UPS Features AC Receptacles (Rear Panel) These 230V IEC-320 receptacles provide your connected equipment with AC line power during normal operation and battery power during blackouts and brownouts. They also protect your equipment against damaging surges and line noise.
8 Storage & Service Storage Turn your UPS OFF: first engage the ON/Standby Switch and release it to place your UPS in the “Standby” mode, then move the System Enable Switch to the “DISABLE” (DOWN) position to prevent battery drain, then disconnect the UPS power cord from the wall outlet.
An important point after buying a device Tripp Lite Datacenter INT (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Tripp Lite Datacenter INT yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Tripp Lite Datacenter INT - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Tripp Lite Datacenter INT you will learn all the available features of the product, as well as information on its operation. The information that you get Tripp Lite Datacenter INT will certainly help you make a decision on the purchase.
If you already are a holder of Tripp Lite Datacenter INT, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Tripp Lite Datacenter INT.
However, one of the most important roles played by the user manual is to help in solving problems with Tripp Lite Datacenter INT. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Tripp Lite Datacenter INT along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center