Instruction/ maintenance manual of the product 99200149 Travis Industries
Go to page of 8
ZC Kit – Large Pellet Insert (99200149) Page 1 of 8 10/9/06 © Travis Industries, Inc. Compatibility • Astoria Bay Pellet Insert • Yankee Bay Pellet Insert Packing List • ZC Can Rear Panel •.
ZC Kit – Large Pellet Insert (99200149) Page 2 of 8 10/9/06 © Travis Industries, Inc. Vent Requirements • Must be 4" diameter Type "L" (except for masonry fireplace installations) - or - connect the vent to a factory built type "A" chimney.
ZC Kit – Large Pellet Insert (99200149) Page 3 of 8 10/9/06 © Travis Industries, Inc. Vent Termination Requirements (See the illustration below) • Must have an approved cap (to prevent water from entering) or a 45 ° downturn.
ZC Kit – Large Pellet Insert (99200149) Page 4 of 8 10/9/06 © Travis Industries, Inc. Minimum Enclosure Dimensions Min. Max. Recommended Height* 29 ” 31 ” ** 30 ” Width 36 ” 43 ” ** 40 ” Depth*** 18 ” 22 ” **** 20 ” * The enclosure height must be raised the same amount as the floor protection (e.
ZC Kit – Large Pellet Insert (99200149) Page 5 of 8 10/9/06 © Travis Industries, Inc. Minimum Floor Protection • The insert must be placed on a non-combustible floor protector (cement board, sheet metal, etc.) a minimum .018 ” thick (26 gauge).
ZC Kit – Large Pellet Insert (99200149) Page 6 of 8 10/9/06 © Travis Industries, Inc. ZC Can Construction Construct the zc can as shown below. WARNING : The sheet metal edges are sharp.
ZC Kit – Large Pellet Insert (99200149) Page 7 of 8 10/9/06 © Travis Industries, Inc. ZC Can Placement • Place the zc can inside the enclosure. The zc can must be placed so the front edge of the mounting flanges are flush with the enclosure opening.
ZC Kit – Large Pellet Insert (99200149) Page 8 of 8 10/9/06 © Travis Industries, Inc. Insert Preparation and Placement • Place the extending hopper into its highest position (see the manual for details). This increases the pellet capacity of the heater.
An important point after buying a device Travis Industries 99200149 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Travis Industries 99200149 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Travis Industries 99200149 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Travis Industries 99200149 you will learn all the available features of the product, as well as information on its operation. The information that you get Travis Industries 99200149 will certainly help you make a decision on the purchase.
If you already are a holder of Travis Industries 99200149, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Travis Industries 99200149.
However, one of the most important roles played by the user manual is to help in solving problems with Travis Industries 99200149. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Travis Industries 99200149 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
