Instruction/ maintenance manual of the product ASR08T Technicolor - Thomson
Go to page of 16
2 T o take maximum advantage of all the features of your satellite receiver , please read this user manual very carefully . ASR 08 T SA TELLITE RECEIVER The package contains the following items : • .
3 ENGLISH Impor tant safety and operating information. This set was designed and manufactured in accordance with international safety standards. Y ou must nonetheless obser ve certain rules to guarantee optimum results and safety . Read this user manual before attempting to put the set into ser vice.
4 ENGLISH CONTENTS Page REMOTE CONTROL UNIT .................................................................................... 5 FRONT P ANEL KEYP AD ....................................................................................... 6 REAR P ANEL CONNECTIONS .
5 ENGLISH REMOTE CONTROL UNIT ST ANDBY key (Switch set on using the CH M /CH N keys, or 0 to 9) Parental lock. Numeric keypad : - Channel selection - Frequency entr y - T oturn on the receiver . Channel scrolling (zapping) and to turn on the receiver .
6 ENGLISH TV DECODER VCR L R IF INPUT MADE IN GERMANY A B WARNING! Shock Hazard Do not open j Mains socket to connect the set to the ac power supply . g SCART socket to connect a decoder e IF B input - socket to connect a second LNB (e.
7 ENGLISH A correctly installed satellite antenna is essential for the receiver to operate. The satellite antenna coaxial cable must be long enough to reach the desired receiver site. Install the receiver near your television set, making sure to leave ventilation space of about 15 cm to the sides and above the receiver .
8 ENGLISH INST ALLA TION OF SA TELLITE RECEIVER - Connect the LNB coaxial cable to Socket d IF INPUT A. - Y ou can, if applicable, connect a second LNB to IF INPUT B connector e . Plug F must be tightened by hand on the threading of the plug. Do not use any tools.
9 ENGLISH On/Standby Using set keypad: Press the On/Standby key . Using remote control: Switch the receiver on by pressing one of the numeric keys (0 to 9), or on the remote control keypad. If the set is switched on using the or keys, the last programme number active before switching off is called up, for example : " 13".
10 ENGLISH RECORDING SA TELLITE PROGRAMMES If your receiver is connected to a VCR, you can record satellite programmes. Paragraph 2 : Connection to a VCR in the INST ALLA TION OF SA TELLITE RECEIVER chapter of the present manual describes the procedure for connecting the VCR to the receiver .
11 ENGLISH Y our receiver is already programmed to receive the most important satellite signals. Y ou can, however , change the programming or add new channels at any time. T o store a new channel in memor y , you need the following information (found in specialist satellite TV magazines): 1.
12 ENGLISH PROGRAMMING A NEW CHANNEL 4. Audio mode selection Press the key to display the audio mode, e.g. : " T on1". Press several times to display all the available modes.
13 ENGLISH 1. Video Level This feature lets you adjust the video level to compensate for differences in level that may exist between the various satellites. Press the key to display the current mode, e.g. : " HI ". Press the key again to select the second mode.
14 ENGLISH 4. 22 kHz Switching Signal This signal can be used to control either a switching box or , for example, the LNB (high band/low band). Press the key briefly to display the current mode, e.g. : "22-". Press again to select the second mode.
15 ENGLISH CONVENIENCE FEA TURES 1. Parental Lock Used to restrict use of the set, or access to certain programmes. 1. Locking certain programmes. The programme can be selected, but the picture does not appear on screen. The programming cannot be altered.
16 ENGLISH TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE Display inoperative - Mains lead incorrectly connected - Power cut Unable to switch set on - Short circuit in the coaxial cable connected to the LNB No picture - SCAR T cable incorrectly connected. - Wrong LNB selection.
17 ENGLISH RF P ART - INPUT FREQUENCY : 900-2150 MHz (IN STEPS OF 1 MHz) - INPUT IMPEDANCE : 75 OHM - INPUT LEVEL : -60 dBm -30 dBm - INTERMEDIA TE FREQUENCY : 479.
An important point after buying a device Technicolor - Thomson ASR08T (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Technicolor - Thomson ASR08T yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Technicolor - Thomson ASR08T - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Technicolor - Thomson ASR08T you will learn all the available features of the product, as well as information on its operation. The information that you get Technicolor - Thomson ASR08T will certainly help you make a decision on the purchase.
If you already are a holder of Technicolor - Thomson ASR08T, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Technicolor - Thomson ASR08T.
However, one of the most important roles played by the user manual is to help in solving problems with Technicolor - Thomson ASR08T. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Technicolor - Thomson ASR08T along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
