Instruction/ maintenance manual of the product 35XX Teac
Go to page of 24
Co v er s All 35xx and 36xx Series R emote Star ter s -The system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no liability or responsibility for accidental starting of the vehicle.
T a ble of Contents INST ALLATION MANUAL REMOTE V EHICLE ST ARTER Page 2 T able of Content s Page 2 Pre-Inst allation Page 3 Components Feature List Pre-Installation Inst allation Procedures Page 4 Wi.
R ecommended Pr e-Installation Procedur es F ea ture List - Control module - 2way & 1way remote transmitter - Antenna with built in - 6 pin main harness Program Button - 14 pin harness - 4 pin har.
R ecommended Installation Procedur es Under Hood Connections - Route the hood pin and tach wire through the firewall into the engine compartment. If possible route the wires through a factory rubber grommet. If drilling a hole through the firewall, BE CAREFUL .
REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Page 5 W iring Diag r am- 35xx Series T emperature Sensor Input (L T Series) S tarter Output (+) 30amp Output (+) 30amp Output (+) 30amp Input (+) 30amp I.
Page 6 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER Module Side V iew J umper Selections 12 3 The jumpers control the output from the White wire on the 6- pin harness. This is a 30amp relayed output . T o change the output of the wire access the jumpers by sliding the plastic cover of f the top of the case.
Page 7 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL 6-pin Description T est For Wire 1-Y ellow 30amp S tarter Output This wire will test 0volts in of f, accessory and in the ignition position.
Page 8 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER 14 Pin Connector - Continued F r om Pr e vious Page 1-Green Door Lock Door Lock Output - Programmable Menu 1 Setting 3. 2-Red 12vlt Output Output For Door Lock Module Only! 3-Blue Door Unlock Door Unlock Output - Programmable Menu 1 Setting 3.
Page 9 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Step 1 - Connect All Of the F ollowing W ir es 6 Pin P ow er Connector Y ellow 30amp S t arter Output 12volts during st art position only . Green 30amp Heater Output 12volt s in the accessory position off during start and 12volts during run.
Page 10 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER Manual T r ansmission “M” Models Never install an automatic transmission remote starter into a manual transmission vehicle!!! Doing so may result in serious injury or death.
Page 1 1 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Auto T ac h Lear n 1) T urn the ignition key to the “ON” position. (The park light s will turn on*).
Page 12 INST ALLATION MANUAL REMOTE V EHICLE S T ARTER Impor tant T ac h Notes T ach Learning the remote st arter is one of the most important step s in the installation process. Do not tach learn vehicle while the engine is in high idle. T o ensure the best possible tach setting, ensure that the vehicle is at low idle/ normal operating RPM.
Page 13 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Entering Pr og r am Mode 1) With the ignition in the OFF position, turn the ignition key from “Of f” to “On” 3 times, ON-OFF-ON-OFF-ON within three seconds. (Leave the key in the ON position) 2) Press and release the Program Button located on the antenna.
Page 14 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER System R eset Quic k View Pr og r amming * See the following p ages for more det ailed programming instructions. Menu 1 -Press Lock 1 Flash 2 Flashes 3 Flashes 1 Ignition Lock Enabled Lock Only Disabled 2 Horn Honk T ype 1 T ype 2 All Honks 3 Lock&Unlock Double Unlock 3 second .
Page 15 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Ignition ON-OFF-ON-OFF-ON Press & Release Program Button Press Lock Button Setting 1 Ignition Auto Lock 1) Ignition Lock & Unlock Enable 1 Flash/Honk Doors Lock/Unlock with Ignition key . 2) Ignition Lock Only 2 Flashes/Honks Doors Lock when ignition is turned ON only .
Page 16 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER Menu 2- Additional Settings Ignition ON-OFF-ON-OFF-ON Press & Release Program Button Press Unlock Setting 1 Secure V alet Mode - Length of tim.
Page 17 REMOTE V EHICLE S T ARTER INST ALLATION MANUAL Menu 3- Star ter Settings Ignition ON-OFF-ON-OFF-ON Press & Release Program Button Press S t art Button Setting 1 S pecial Door Lock/Unlock Operations (Factory Alarm Rearm) . 1) T ype 1 1 Flash/Honk Unlock pulse before start.
Page 18 INST ALLATION MANUAL REMOTE V EHICLE S T ARTER Menu 3- Star ter Settings - Continued F r om Pr e vious Page Setting 5 Maximum Crank T ime 1) 10 Seconds 1 Flash/Honk 10 sec max time that the st arter will st ay engaged. 2) 3 Seconds 2 Flashes/Honks 3 sec max time that the st arter will st ay engaged.
Page 19 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL Menu 4- T ach Settings Setting 1 Auto T ac h Lear n. 1) Perform a System Reset. See p age 15. 2) T urn the ignition key on. (Park lights will turn on). 3) S tart the vehicle, the LEDs on the antenna will come on when a proper tach signal is detected*.
Page 20 INST ALLATION MANUAL REMOTE V EHICLE ST ARTER A TTENTION: TO A VOID SERIOUS INJUR Y , this remote st art system must be set into Service Mode before any under hood servicing is st arted. Service Mode will prevent the vehicle from st arting while the vehicle is being serviced.
Page 21 REMOTE V EHICLE ST ARTER INST ALLATION MANUAL T r ansmitter Pr og r amming Ste p 1 - Within 3 seconds turn the ignition ON-OFF-ON-OFF-ON - Leaving Key ON Ste p 2 - Press and hold the Program Button - The park light s will turn ON and the siren will chirp once.
87 86 85 87a 30 87 86 85 87a 30 Lock Un lock V ehicle Lock/Unlock Switch T o Control Relay or Actuator Green Fused +12V Blue Ground Ne gativ e T ype Door Locks 250ma Ne gativ e Door Loc ks (Mor e T han 250ma) P ositiv e Type Door Loc ks Note: When installing relays always use a fused power source.
87 86 85 87a 30 87 86 85 87a 30 Blue Green Lock Un lock Ve hicle Lock/Unlock Switch T o Actuator Fused +12V x x Cut Cut 87 86 85 87a 30 Ground DIA GNOSTICS 13 87 86 85 87a 30 87 86 85 87a 30 Blue Gree.
DIA GNOSTICS If the remote starter does not activate when the st art button is pressed the park light s will flash a diagnostic to indicate what shutdown input has been triggered. For example when the start button is pressed the p ark lights flash 3 times slowly .
An important point after buying a device Teac 35XX (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Teac 35XX yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Teac 35XX - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Teac 35XX you will learn all the available features of the product, as well as information on its operation. The information that you get Teac 35XX will certainly help you make a decision on the purchase.
If you already are a holder of Teac 35XX, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Teac 35XX.
However, one of the most important roles played by the user manual is to help in solving problems with Teac 35XX. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Teac 35XX along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
