Instruction/ maintenance manual of the product PM-9805 Sherwood
Go to page of 11
.
PM-9805 TURN T ABLE OPERA TING INSTRUCTIONS TURN T ABLE.
PRECAUTIONS 1 Thank you for purchasing this fine product – STEREO TURNTABLE. Taking time to read these operation instructions carefully. Read this manual carefully before using the unit and be sure to store the manual in a safe place for future reference.
NAME OF THE PARTS 2 1. 45-rpm Adaptor 2. Slip Mat 3. Center Spindle 4. Strobe Dots 5. Power Switch / Strobe 6. Start/Stop Button 7. Taget Light 8. Headshell 9. Speed Select Buttons 10. Pitch Control Slider (+/– 10%) 11. Tonearm 12. Cueing Lever 13. Arm Rest 14.
CONTENTS 3 ASSEMBLY 1. Please unpack set as confirm following parts. • Turntable platter • Slip Mat • Dust Cover • 45-rpm adaptor • Counterweight • Headshell • Operating Instructions 2. Install the dust cover into Hinge pocket of the upper cabinet.
ADJUSTING THE TONEARM 4 Level Balance Adjustment 1. Set the ANTI-SKATE knob to “0”. 2. Release the arm clamp and move the tonearm to the space between the arm rest and the platter, taking care not to damage the stylus. 3. Set the CUEING lever to the down position.
CONTROLS AND OPERATION 5 1. Turn the (On/Off Switch) clockwise to turn on the power, the speed indicator and the strobe- illuminator, which is located beneath the On/Off switch, will light up. 2. Place a record on the slip mat. When playing a 45- rpm record with a large center hole, place the 45- rpm adapter on the center spindle.
CONNECTIONS 8 CONNECTIONS 6 This set’s phono cables and ground lead are attached to the rear panel of the turntable. The phono cable with the white plug is for the left channel and the one with the red plug is for the right channel. The thin wire with the Y-shaped connector at the end is the ground lead.
7 The life expectancy of the stylus tip is 500 hours. For the sake of maximum sound quality reproduction, we recommend replacement within the minimum time limit. 1. The stylus tip is replaced by grasping the stylus holder and pulling it away from the body of the cartridge.
8 GENERAL SPECIFICATION 1. APPLICATION : This spectftcation applies to the belt drive turntable unit PM-9805 2. STANDARD TEST CONDITION : 2-1 Ambient Temperrature 23 A 2LC 2-2 Relative Humidity 65% A 5% NOTE : Measurements can be carried out betwee 5LC and 45% to 85% relative humidity.
TROUBLE SHOOTING 9 Sometimes, an operational fault can be mistaken for a malfunction or failure. Check the following points and see if you can find the symptoms of the trouble below before you get in touch with the serviceman. If you cannot locate the symptoms, contact your nearest dealer.
An important point after buying a device Sherwood PM-9805 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Sherwood PM-9805 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Sherwood PM-9805 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Sherwood PM-9805 you will learn all the available features of the product, as well as information on its operation. The information that you get Sherwood PM-9805 will certainly help you make a decision on the purchase.
If you already are a holder of Sherwood PM-9805, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Sherwood PM-9805.
However, one of the most important roles played by the user manual is to help in solving problems with Sherwood PM-9805. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Sherwood PM-9805 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
