Instruction/ maintenance manual of the product PI-400 Schumacher
Go to page of 13
00-99-000346/0805.
The advanced surge capacity of the PI-400 power invert- er gives it the means to start most electrical appliances including: Color televisions, TV/VCR combinations, microwaves, refrigeration units, small air conditioners.
T o calculate the starting load: Starting Load = 2 x W A TTS. In general, the start up load of the appliance or power tool determines whether your inverter has the capability to power it.
Incorrect operation of your inverter may result in damage and personal injury . Electrical current on a 1 10-volt circuit can be very dangerous. Y our inverter features include: A. ON/OFF Rocker Switch B. LED Indicator Light. (Green = Power ON, Red = Overload) C.
Y ou can use an extension cord from the inverter to the appliance without significantly decreasing the power being generated by the inverter . For best operating results, the extension cord should be no longer than 50 feet.
Affix one or several "Ferrite Data Line Filters" to the tele- vision power cord. Ferrite Data Line Filters can be pur- chased at most electronic supply stores including Radio Shack - Part Number 273-105. T ry grounding the inverter with an 18 A WG (minimum) wire, using as short a length as possible.
Power Source Y our average automobile or marine battery will provide an ample power supply to the inverter for 30 to 45 minutes even when the engine is off. The actual length of time the inverter will function depends on: 1. Age and condition of the battery .
2. The power input from the battery exceeds 15 volts. 3. The continuous load demand from the equipment or appliance being operated exceeds 400 watts. 4. The case temperature exceeds 145 ºF . Attention: The PI-400 is fitted with a cooling fan that runs as needed while the inverter is operating.
While in use, make sure there are several inches of clearance around the top and sides of the inverter . Do not use the inverter near inflammable materials. Do not place the inverter in areas such as battery compartments where fumes or gases may accumulate.
Make sure the power consumption of the appliance or equipment you want to operate is compatible with the capacity of the inverter , i.e. does not exceed 400 watts. If you are using the power inverter to operate battery charger , monitor the temperature of the battery charger for about 10 minutes.
PROBLEM: Red LED On Reason /Solution 1. Battery voltage below 11 volts. Recharge or replace battery . 2. Equipment being operated is drawing too much power . Use a higher capacity inverter or do not use this equipment. 3. Inverter is too hot (thermal shut down mode).
SPECIFICA TIONS: Maximum Continuous Power ...………………....400 W atts Surge Capability (Peak Power)………………… 800 W atts No Load Current Draw .............…………………......< 0.4A W ave form ...............…………….
Schumacher Electric Corporation, W arranty Service Department 1025 Thompson, Hoopeston, IL 60942 Phone: 800-621-5485 (Hours: 7 a.m. - 4:30 p.m. CST) Y ou will be responsible for all insurance and freight or other transportation charges to the factory or point of repair .
An important point after buying a device Schumacher PI-400 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Schumacher PI-400 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Schumacher PI-400 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Schumacher PI-400 you will learn all the available features of the product, as well as information on its operation. The information that you get Schumacher PI-400 will certainly help you make a decision on the purchase.
If you already are a holder of Schumacher PI-400, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Schumacher PI-400.
However, one of the most important roles played by the user manual is to help in solving problems with Schumacher PI-400. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Schumacher PI-400 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
