Instruction/ maintenance manual of the product AS-1785i SH Autostart
Go to page of 10
DOC : 1.00 – August 31, 2006 DL Lp Manufactured in Canada by Autostart MANUAL TRANSMISSION REMOTE STARTER AS-1785i SH User Guide WARNING It is the responsibility of the vehicle operator to ensure their vehicle is parked in a safe an d responsible manner.
User Guide P. 2 Table of Contents Introduction ........................................... 2 Using the Remote Control ................... 2 Vehicle Presets ..................................... 3 Heater & Heated Se at .............................
User Guide P. 3 Vehicle Presets Heater & Heated Seat When leaving the v ehicle it is recommended t o preset the access ory controls in preparatio n for the next remote start . Settings for t he blower motor ( fan), front and rear , as well as heated seats (if equipped) shoul d not be left on HIGH .
P. 4 User Guide Remaining In Ready Mode Once the vehicle i s in Ready Mode you can s tart and stop the vehicle at wis h. However, should any of the foll owing occur, the vehicle will exit Ready Mode .
User Guide P. 5 Caution!!! Do not leave ch ildren or pets un attended in a vehicle standin g in Idle Mo de. Ignition Valet This feature wil l allow you to remotely put yo ur system in to Valet Mode b y using the ig nition key instead of the Va let button as a bove.
P. 6 User Guide Quick Lockout TM (Also called Secu re Panic .) For fast protection in emergency situations, the system wil l LOCK a ll doors when you press the brake pedal while you hear the sound signal . ( Quick L ockout is only available when Panic Mode has been set off.
User Guide P. 7 Ignition-control led Door Locks This is an added sec urity feature. If your Remote Car Starter was ins talled with the Igni tion- Controlled Door Locks option, the doors will automa tically be locked as soon as the ignition key is turned to the IGNITION ON (RUN) position whil e the brakes are pres sed.
P. 8 User Guide • Within 3 sec., pres s and release the valet button The parking lights will flash twice an d the L.E.D. will c ome OUT . Note : Once Valet Mode is ac tivated, the r emote starter will be disabled.
User Guide P. 9 • Flashing LED ON : the L.E.D. will fl ash at all times (either un der active arming or und er passive arming) to indicat e that the Starter K ill is active. • Active Arming: the LED will flas h normally. • Passive Arming: the LED will flas h at a faster rate during th e countdown preced ing the activation of the Starter Kill.
P. 10 User Guide LIMITED LIFETIME WARRANTY REMOTE STARTERS: As the manufacturer, 160031 Canada Inc. (“Autostart”) warran ts to the original consumer purchaser only ( non- transferable ) that the r.
An important point after buying a device Autostart AS-1785i SH (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Autostart AS-1785i SH yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Autostart AS-1785i SH - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Autostart AS-1785i SH you will learn all the available features of the product, as well as information on its operation. The information that you get Autostart AS-1785i SH will certainly help you make a decision on the purchase.
If you already are a holder of Autostart AS-1785i SH, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Autostart AS-1785i SH.
However, one of the most important roles played by the user manual is to help in solving problems with Autostart AS-1785i SH. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Autostart AS-1785i SH along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
