Instruction/ maintenance manual of the product Platinum APS-875 Audiovox
Go to page of 16
Model APS-875 Owner ’ s Manual IMPORT ANT ! In order to provide you with the highest level of security to your vehicle, this system is equipped with selectable manual override circuitry . It is possible that you will need to override you security system if the transmitter becomes lost, or inoperative due to battery failure.
Page 2 w Intrusion Alert With Memory w Instant Siren Activation w Starter Disable Output w Additional Engine Immobilizer Output, (Optional Relay Required) w T rue Last Door Arming (Hardwire Only) w De.
Page 3 YOUR “ANTI CODE GRABBING“ TRANSMITTERS The transmitters included with your new security system use the most advanced and secure form of radio frequency transmission available on any current automo- tive security system.
Page 4 2 . Press and hold button the Lock/Arm button on the keychain transmitter for 2 seconds. þ The dash mounted LED begins to flash slowly . þ Parking Lights flash one time. þ Siren will not sound. If the siren sounds 3 chirps, then you have left a door , trunk, or hood lid ajar .
Page 5 drain, even when left unattended for extended periods. þ Whenever the system is triggered, the vehicle’s parking lights will flash for the full 30 second alarm cycle, attracting visual attention to the vehicle. þ Optional - Whenever the system is armed, the vehicle’ s starting circuit will be bypassed.
Page 6 SILENT DISARMING (Must be activated during programming) Note: If the optional 2 step door unlock circuit is installed, when the unlock transmitter button is activated, the drivers door only will unlock, pressing the unlock button a second time will cause all doors to unlock.
Page 7 device that may have been added to the system. If the LED is flashing two times...pause...two times...pause...etc., then an intrusion attempt was made to a hood or trunk pin switch that was added to the system, or to a light activated entry point if the alarm was installed using the voltage sensing feature.
the consumer to program a personal override code, offering a higher level of security . T o take advantage of this option, programmable feature # 10 must be selected for the Custom Code Option. Consult your installation center for programming details.
7. Within 10 seconds, begin to press and release the pushbutton switch to set the units digit. (As per the example, press and release 2 times to set the units digit to 2). 8. Turn the ignition switch to the of f position. Immediately observe the LED flash pattern.
NOTE: Whenever the chirps are bypassed, the 4-chirp intrusion indicator and 3 chirp defective zone indicator will always operate. Since these are important warnings to you that something has happened, they cannot be eliminated.
The full detect trigger duration will be reduced from 30 seconds to 15 seconds. NOTE: Setting the stage of the shock sensor will be effective for one arming cycle only . Once the system has been disarmed, the very next arming cycle will cause the sensor to default to the normal operation stage.
W ARNING! Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A running engine produces dangerous carbon monoxide fumes which can be harmful or fatal if prolonged exposure occurs. DO NOT remote start the vehicle if it is garaged.
OPERA TING ON AUTOMA TIC ST ART UP TIMER MODE The APS-875 has the ability to automatically start the vehicle every 2 or 4 hours over a 48 hour period. This feature is especially useful in cold climates where the only means to keep the engine and engine fluids warm is to periodically start the engine.
Page 14 ate transmitter button is depressed for 4 seconds. Optional devices that may be connected to this channel are; o Remote Electric T runk Release o Remote Car Starter o Remote Window Closure o R.
Page 15 o Remote Window Closure o Remote Garage Door Interface T o remotely operate the device indicated, momentarily press, or press and hold the appropriate transmitter button(s) as indicated above.
APS 875 SYSTEM FUNCTIONS A T A GLANCE DASH LED INDICA TORS RAPID FLASHING = P ASSIVE ARMING/ACTIVE REARMING SLOW FLASHING = ARMED OFF = DISARMED ON SOLID = V ALET MODE 3 FLASH.
An important point after buying a device Audiovox Platinum APS-875 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Audiovox Platinum APS-875 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Audiovox Platinum APS-875 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Audiovox Platinum APS-875 you will learn all the available features of the product, as well as information on its operation. The information that you get Audiovox Platinum APS-875 will certainly help you make a decision on the purchase.
If you already are a holder of Audiovox Platinum APS-875, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Audiovox Platinum APS-875.
However, one of the most important roles played by the user manual is to help in solving problems with Audiovox Platinum APS-875. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Audiovox Platinum APS-875 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
