Instruction/ maintenance manual of the product LCM500NP Audiovox
Go to page of 16
LCM500NP 5 Inch Monitor with 2 V ideo Input Capability Installation and Operation Manual EL E C T R O N I C S C O R P . ®.
Important Notice It is unlawful in most jurisdictions for a person t o drive a motor vehicle which is equipped with a television viewer or screen that is located in the motor vehicle at any point forward of the back of the driver's seat, or that is visible directly or indirectly , to the driver while op- erating the vehicle.
The Materials included in this package: -1- 1. LCM500NP Monitor (1pc) 2. Remote Control Unit (1pc) 3. Interconnection Box (A VX-6865) (1pc) 4. Monitor Cable Assembly 16 Feet (5 Meter s) (1pc) 5. Power Cable Assembl y (1pc) 6. Surface Mount (S2) (1pc) 7.
10) Locate the following: an accessory power source (+12VDC present when the ignition key is in the accessory and run positions). 0VDC should be present, when the ignition key is in the OFF position. A constant power source (+12VDC present at all times).
-3- T ools and Materials Required: • Utility knife or box cutter with sharp blade • Sharpie™ marker or similar • T ie Wraps Remove the headrest from the vehicle for easiest installation. Lay headrest on a flat surface Center trim collar on headrest as shown.
-4- Using your fingers, tear the foam out of the headrest leaving a recess where the shell will be inserted. At this point you will need to install the harness up through the area into the recess. It may be helpful to follow one of the posts and tie wrap it to the post for restraint.
-5- Lay the flaps of headrest material down into the recess and insert the clamshell into the recess. Check for fit. If it does not fit properly , you may need to remove some more foam. NOTE: The clamshell will need to be secured to the headrest, either by using tie straps, screws, ect.
-6- The supplied Release Key is for removing monitor from housing. Refer to the drawing below . MONITOR SURF ACE MOUNTING: 1. Slide the monitor onto the mount S2 and tighten using the fastener . 2. Firmly attach surface mount to a flat surface and adjust the viewing angle of the monitor by loosening the fastener on the side.
-7- LCM500NP SYSTEM WIRING DIAGRAM 1.) Make sure the LCM500NP has been installed properly , as described in the procedures as stated on pages 2, 3, and 5. 2.) Plug the 15 pin connector into the jack labelled -15 pin to MONITOR on the A VX-6865 Interconnection Box.
-8- Controls and Indicators Monitor Panel Controls.
-9- Remote Control Unit Remote Control Unit Controls.
KEY -10- Remote Control Unit Controls Continued KEY Press the to the desired setting Press the to the desired setting Press the MODE key to select the desired video source input (Input 1 or Input 2).
Display Mode 1. Press MENU to get the On Screen Display (OSD). 2. Select FORMA T . 3. Press the or the to switch the screen aspect ratio. FULL : 16:9 picture is fully displayed. ZOOM: Picture is stretched vertically and horizontally . CINEMA: Picture is displayed with uniform horizontal enlargement.
OPERA TING INSTRUCTIONS 1. POWER ON/OFF/MODE Press the POWER button to turn power on. Pressing the POWER button again momentarily will change video inputs. Press the for NTSC input. Press the for P AL input. Press and hold the POWER button for three seconds to turn power off.
MONITOR SPECIFICA TIONS 1. T ype : TFT Active Matrix LCD 2. Display Screen Size : 4.3 x 2.5 inches (109.2 x 63.5) (W x H) 3. Resolution: 1200 (W) x 234 (H) 4. P ix el s: 280,800 5. Back Light : Cold Cathode Fluorescent Lamp 6. Power Source : +12 VDC 7.
© Copyright 2001 Audiovox Electronics Corp. 150 Marcus Blvd. Hauppauge, NY 1 1788 128-6244 999 .audiovox.com For Custom er S er vi ce Vi si t O ur W ebsi t e A t Product I nf orm at i on, Phot os, F .
An important point after buying a device Audiovox LCM500NP (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Audiovox LCM500NP yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Audiovox LCM500NP - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Audiovox LCM500NP you will learn all the available features of the product, as well as information on its operation. The information that you get Audiovox LCM500NP will certainly help you make a decision on the purchase.
If you already are a holder of Audiovox LCM500NP, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Audiovox LCM500NP.
However, one of the most important roles played by the user manual is to help in solving problems with Audiovox LCM500NP. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Audiovox LCM500NP along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
