Instruction/ maintenance manual of the product HEZ2650F RedMax
Go to page of 18
US-1 HEZ2650F U S OWNER 'S/ OPERA T OR'S MANUAL STICK EDGERS 848-A4M-93A0 (908) HEZ2650F APPLICABLE SERIAL NUMBERS : DRIVE UNIT 90800101 and up ENGINE UNIT 90800101 and up W ARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
US-2 HEZ2650F SAFETY FIRST Instructions contained in warnings within this manual marked with a symbol concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions carefully and follow them without fail.
US-3 HEZ2650F U S 1. Parts location 1 2 3 4 5 6 7 8 9 10 11 12 13 1. Loop handle 2. Stop switch 3. Throttle cable 4. Throttle lever 5. Blade guard 6. Blade 7. Wheel 8. Spark arrester 9. Starter knob 10. Fuel tank 11. Primer pump 12. Choke lever 13. Air cleaner cover 2.
US-4 HEZ2650F 3. W arning labels on the machine For safe operation and maintenance, symbols are carved in relief on the machine. According to these indications, please be careful not to take a mistake.
US-5 HEZ2650F U S •A brushcutter or trimmer can be dangerous if used incorrectly or carelessly, and can cause serious or fatal injury to the operater or others. It is extremely important that you read and understand the contents of this Owner's manual.
US-6 HEZ2650F contain dangerous carbon monoxide. 10. Never to touch the spark plug or plug cord while the engine is in operation Doing so may result in being subjected to an electrical shock.
US-7 HEZ2650F U S 5. For safe operation equipment, CLEAN UP! ■ Transport 1. Drain the fuel from the fuel tank before transporting or storing the product. 2. When hand-carrying the product, cover over the cutting part, lift up the product and carry it paying attention to the blade.
US-8 HEZ2650F 5. For safe operation muffler, and the ignition wiring. 4. When replacing the any other part, or any lubricant, always be sure to use only RedMax products or products which have been certified by RedMax for use with the RedMax product. 5.
US-9 HEZ2650F U S 6. Set up ■ MOUNTING OTHER PARTS 1. Insert the driveshaft into the clutch drum, then attach the gearbox to the shaft tube as aligning the positioning holes and fasten the screw (A). Fasten the clamp bolt (B) firmly. (SE1) (A) Screw (B) Clamp bolt (B) Tightning Torque: 52~69in-lbs (6~8N.
US-10 HEZ2650F 7. Fuel ■ FUEL • Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 10 ft (3 m) away from the fueling point before starting the engine.
US-11 HEZ2650F U S 7. Fuel test standard has been discontinued by API in 1995 and it no longer exists. • Gasoline/Oil mixture Storage Recommendations Store your gasoline or gasoline/oil mixture in a cool dry area in a tightly sealed approved container to limit the entry of moisture and additional air (oxygen).
US-12 HEZ2650F 8. Operation The RedMax stick edgers are designed for edging lawn in gardens, parks, roadsides and so on. Before starting the engine, take the operating position and adjust the handle position and the wheel height as necessary. ■ ADJUSTING WHEEL HEIGHT 1.
US-13 HEZ2650F U S 1. When restarting the engine immediately after stopping it, leave the choke open. 2. Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.
Maintenance, replacement, or repair of the emission control device and systems may be performed by any non-road engine repair establishment or individual. • Always be sure to stop the engine before inspecting the stick edger for problems or performing maintenance.
US-15 HEZ2650F U S • Make sure that the engine has stopped and is cool before performing any service to the machine. Contact with moving cutting head or hot muffler may result in a personal injury. ■ AIR FILTER • The air filter, if clogged, will reduce the engine performance.
US-16 HEZ2650F 9. Maintenance MA10 MA9 (1) (2) MA8 ■ BLADE (MA7) • Place the blade between holders (A) and (B) while locking the gear shaft by putting the bar, through the key holes on the holder(A) and the gearcase. Use the socket and the screwdriver to tighten the blade mounting bolt.
US-17 HEZ2650F U S Case 1. Starting failure CHECK PROBABLE CAUSES ACTION fuel tank ➞ incorrect fuel ➞ drain it and with correct fuel fuel filter ➞ fuel filter is clogged ➞ clean carburetor adj.
US-18 HEZ2650F The EPA (U.S. Environmental Protection Agency), CARB (California Air Resources Board), Environment Canada and RedMax / Zenoah America, Inc. are pleased to explain the emissions control system's warranty on your 2009 and later small off-road engine.
An important point after buying a device RedMax HEZ2650F (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought RedMax HEZ2650F yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data RedMax HEZ2650F - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, RedMax HEZ2650F you will learn all the available features of the product, as well as information on its operation. The information that you get RedMax HEZ2650F will certainly help you make a decision on the purchase.
If you already are a holder of RedMax HEZ2650F, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime RedMax HEZ2650F.
However, one of the most important roles played by the user manual is to help in solving problems with RedMax HEZ2650F. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device RedMax HEZ2650F along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
