Instruction/ maintenance manual of the product CD8200 Profile
Go to page of 20
AM/FM HIGH POWER DETACHABLE FACE CD PLAYER CD8200 INSTALLATION INSTRUCTIONS / OWNER S MANUAL ,.
1 Serial # Purchase Date I NTRODUCTION Congratulations on your purchase of a Profile state-of-the-art single disc CD player. Your selection of a Profile car audio product indicates a true appreciation of fine musical reproduction.
2 CD8200 S AFETY PRECAUTIONS Secure the CD player When installing your CD player in the vehicle, make sure it is mounted properly in the dash, using an after market installation kit if needed. When using the supplied mounting sleeve, it is a must that you also use the supplied back brace to support the back of the CD player.
3 C ARE AND MAINTENANCE PROTECTIVE CASE ( FIG.2) Press the OPEN button to detach the face plate, then take the face plate away from the head unit (Fig.1) and put it in the protective case (Fig.2) for safe keeping. FACE PLATE OPEN BUTTON ( FIG.1) Cleaning the CD player When cleaning the vehicle, be sure not to get any water in or on the CD player.
4 CD8200 DISC CARE AND PLAY: Before playing, clean the disc with a clean, lint-free cloth. Wipe the disc in the direction of the arrow. Do not use solvents such as benzine or thinners. Commercially available cleaners or anti static spray will damage the unit.
5 E LECTRICAL AND SIGNAL CONNECTIONS FOUR SPEAKER SYSTEM ! Connect Black wire to chassis ground. ! Connect the Yellow memory backup wire to a Constant +12 Volt power source wire. ! Connect the Red ignition wire to a switched +12 Volt power source wire.
6 CAUTION! Tape unused wires so they do not short against other wires or chassis ground. TWO SPEAKER SYSTEM CD8200 NOT USED NOT USED NOT USED NOT USED + + + + YELLOW ANTENNA CONNECTOR MEMORY +12V BLAC.
7 M OUNTING THE CD PLAYER DIN SLEEVE MOUNTING Insert the mounting sleeve into a standard DIN cutout in the dash kit, dashboard or Console. Bend the mounting tabs of the sleeve with a screwdriver to secure the bracket firmly in place. Insert the CD Player in the mounting sleeve until it locks.
8 CD8200 Attach the back brace to the CD player using the supplied hardware. Then attach the other end of the brace to a firm mounting surface (i.e. Dash brace, fire wall, e.t.c.) This will brace the back of the CD player to ensure solid mounting to prevent theft and provide optimal CD play.
9 R EMOVING THE CD PLAYER Remove the rectangular trim ring by applying pressure with your finger tips, then gently pull out away from the dash. PLACE FINGER TIPS HERE I SO/DIN MOUNTING If you own a Ja.
10 CD8200 LOCATION AND FUNCTION OF CONTROLS.
11 1 POWER To t u r n O N t h e unit, press any button except the and button. To t u r n O F F t h e unit, press the button for more than 2 seconds. 2 DETACH FACE PLATE Press the button to detach the face plate. This will allow you to remove the face plate.
12 In CD play mode, press and hold the 9 or 10 button to fast forward or fast reverse through the song. The CD resumes playing when the button is released. 11 PRESET STATIONS There are 6 numbered buttons to store into memory and recall stations for each band.
13 BEEP - The beep sound when you press a button on the unit can be turned on or off. Press the SEL button for more than 2 seconds to display the DSP function. Press the SEL button again momentarily to display BEEP ON/OFF. Then use 5 button to turn on/off the beep sound.
14 16 RANDOM PLAY In CD play mode, press the RDM 16 button to play all tracks of the disc in random sequence. Press it again to cancel random play. 17 LOUDNESS Press LOU button once to enhance the bass effect. Press again to cancel the loudness effect.
15 T ROUBLE SHOOTING THE SYSTEM The following chart will help in solving most problems that may occur. Should any problem persist after you have made these checks, please consult your nearest Profile retailer. Before going through this check list, refer back to the wiring and operating procedures.
SYMPTOM CAUSE SOLUTION The installation angle is greater than 30 degrees Adjust the angle of the unit to l ess than 30 degrees The disc player is installed incorrectly Check to see if the unit is fastened securely with the back brace supporting the rear of the unit.
S PECIFICATIONS GENERAL Power Supply Requirements...........................................DC 12 Volts, Negative Ground Chassis Dimensions ...................................................................7 (W) x 6 1/2 (D) x 2 (H) Tone Controls.....
LIMITED WARRANTY Profile Consumer Electronics, Inc. warrants this product to be free from defects in material and workmanship for a period of One (1) Year from the date of sale to the original consumer purchaser.
PROFILE CONSUMER ELECTRONICS, INC. 15060 SHOEMAKER AVE SANTA FE SPRINGS, CA 90670 TEL: (562)404-9393 FAX: (562)404-9433 WWW.PROFILEUSA.COM WARRANTY REPAIR POLICY In the unlikely event of product failure, the following procedures should be followed 1) The unit must be under the 1-year warranty period.
An important point after buying a device Profile CD8200 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Profile CD8200 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Profile CD8200 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Profile CD8200 you will learn all the available features of the product, as well as information on its operation. The information that you get Profile CD8200 will certainly help you make a decision on the purchase.
If you already are a holder of Profile CD8200, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Profile CD8200.
However, one of the most important roles played by the user manual is to help in solving problems with Profile CD8200. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Profile CD8200 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
