Instruction/ maintenance manual of the product OD-100 Pelco
Go to page of 5
custom audio electronics inc. • • • 10648 Magnolia Blvd. North Hollywood, CA. 91601 Phone (818) 763-8898 Fax (818) 763-8890 OD-100 Tube Guitar Amplifiers OPERATING GUIDE.
Start by plugging AC power into the amp after first making sure the amp is set to the proper line voltage. Also, make sure the amp is on “Standby” before applying AC power.
Channel 1 (The “Clean” Channel) For starters, set Channel 1’s switches and controls as follows: Bright switch “in”, Boost switch “out”, Gain=5, Bass=5, Middle=5, Treble=5, Level 1=5 As you can see, we have set all the controls straight up.
Effects Loop The OD-100 effects loop is a tube buffered series loop. The effect send jack is always active and acts as a low impedance tube buffered preamp out capable of driving a wide variety of devices from low level pedals to line level “rack” gear.
To change selected voltage: Open cover using small blade screwdriver or similar tool. Set aside cover/fuse block assembly. Pull voltage selector card straight out of housing, using indicator pin orient selector card so that the desired voltage is readable at the bottom (see above).
An important point after buying a device Pelco OD-100 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Pelco OD-100 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Pelco OD-100 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Pelco OD-100 you will learn all the available features of the product, as well as information on its operation. The information that you get Pelco OD-100 will certainly help you make a decision on the purchase.
If you already are a holder of Pelco OD-100, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Pelco OD-100.
However, one of the most important roles played by the user manual is to help in solving problems with Pelco OD-100. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Pelco OD-100 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center