Instruction/ maintenance manual of the product C1095M Pelco
Go to page of 4
PELCO Manual C1095M — 4/94 1 INSTALLATION MANUAL ICIDRD INTERFACE CABLE FOR INTER-CHECK P.O.S. SYSTEMS 1.0 SCOPE This manual covers the interface for the ICIDRD interface cable for the Wayne Dresser Plus 1, Plus 2, and Plus 3 registers. The following should be noted prior to installation: 1.
2 PELCO Manual C1095M — 4/94 Listed below are the parameters the must be pro- grammed into the Inter-Check unit for proper operation. Table I. Typical Inter-Check Parameters (for Wayne Dresser Display) Inter-Check Channel Parameters Protocol 9600 baud RS232 Standard Printer 8 Bits Off parity NRZ ASCII Data Non-Invert 2.
PELCO Manual C1095M — 4/94 3 Figure 2. Wiring Configuration for Two (2) Wayne Dresser Registers (Displays).
4 PELCO Manual C1095M — 4/94 3.0 WARRANTY AND RETURN INFORMATION Pelco, the Pelco logo, Camclosure, Esprit, Genex, Legacy, and Spectra are registered trademarks of Pelco. Endura and ExSite are trademarks of Pelco. © Copyright 1994, Pelco. All rights reserved.
An important point after buying a device Pelco C1095M (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Pelco C1095M yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Pelco C1095M - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Pelco C1095M you will learn all the available features of the product, as well as information on its operation. The information that you get Pelco C1095M will certainly help you make a decision on the purchase.
If you already are a holder of Pelco C1095M, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Pelco C1095M.
However, one of the most important roles played by the user manual is to help in solving problems with Pelco C1095M. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Pelco C1095M along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
