Instruction/ maintenance manual of the product SA-HE100 Panasonic
Go to page of 20
A V Control Receiver Operating Instructions Model No . SA-HE100 Dear customer Thank you for purchasing this product. Before connecting, operating or adjusting this product, please read these instructions completely. Please keep this manual for future reference.
2 RQT6208 IMPOR T ANT SAFETY INSTRUCTIONS Safety 1. Power source — Connect the unit to a power source of the type described in these instructions or as marked on the unit. 2. Polarization — The unit is equipped with a polarized power plug where one blade is wider than the other.
3 RQT6208 Please check and identify the supplied accessories. 1 AC power supply cord (RJA0065-A) 1 AM loop antenna set (N1DAEYA00006) (AM loop antenna, antenna stand, antenna wall bracket) Use the numbers indicated in parentheses when asking for replacement parts.
L R L R FM ANT AM ANT GND LOOP EXT 75 Ω AC IN ∼ AC OUTLET OUT IN IN IN IN IN OUT FRONT OPTICAL1 (CD) IN OPTICAL2 (TV) IN OPTICAL3 (DVD) IN COAXIAL IN OPTICAL OUT SURROUND FRONT CENTER 6-8 Ω 6-8 .
5 RQT6208 Peripheral equipment and cables sold separately unless otherwise indicated. Speaker cable Step 1 Step 2 Step 3 Step 4 Before use Others Reference Do not short circuit.
L R L R FM ANT AM ANT GND LOOP EXT 75 Ω AC IN ∼ AC OUTLET OUT IN IN IN IN IN OUT FRONT OPTICAL1 (CD) IN OPTICAL2 (TV) IN OPTICAL3 (DVD) IN COAXIAL IN OPTICAL OUT SURROUND FRONT CENTER 6-8 Ω 6-8 .
L R L R FM ANT AM ANT GND LOOP EXT 75 Ω AC IN ∼ A C O U TLET OUT IN IN IN IN IN OUT FRONT OPTICAL1 (CD) IN OPTICAL2 (TV) IN OPTICAL3 (DVD) IN C O A X IA L IN OPTICAL OUT SURR O UN D F R O N T C E .
8 RQT6208 Settings Change the settings to suit your speakers and units to the environment in which you are using them. Before making any changes, read the descriptions of the settings, note the factory settings and ranges, and refer to the equipment ’ s instructions.
9 RQT6208 Select “ SIZE ” . Select the speaker . Change the setting. Press at the same time to exit the setting mode. SPEAKERS A SPEAKERS AB Select “ DIST ANCE ” . Select “ FIL TER ” . Select the speaker . Change the setting. Change the setting.
10 RQT6208 When you finish listening Be sure to reduce the volume and press [ ] to switch the unit to standby. For your reference In rare cases, the unit may have trouble recognizing the digital signals on discs. ¡ With the PCM signals on CDs, this may cause the beginning of a track to be cut off.
11 RQT6208 You can adjust the sound field by adjusting the level of the speakers and the delay time of the surround speakers. These adjustments can be made for each SFC mode.
12 RQT6208 Contr ol guide POWER SPEAKERS AB DOWN DSP SOUND MODE PHONES - HELP – RESET - BAND – FM MODE MEMOR Y ENHANCED SURROUND TUNING PRESET NEO:6 DOLBY PRO LOGIC 2 8 21 Standby/on button [POWER, 8 ] Press to switch the unit from on to standby mode or vice versa.
13 RQT6208 UP T APE (MONITOR) TV D VD INPUT CD TUNER PHONO VCR1/VCR2 VOLUME INPUT SELECTOR D VD 6CH INPUT SUBWOOFER T APE MONITOR BASS/TREBLE 34 BALANCE L R DIGIT AL INPUT VIDEO IN VCR2 L AUDIO IN R V.
14 RQT6208 Change this setting to listen to software recorded with Dolby Digital at low volume (such as late at night) and maintain audio clarity. It reduces the peak level in loud scenes without affecting the sound field. OFF: The software is played with the original dynamic range (factory setting).
15 RQT6208 L R L R FM ANT AM ANT GND LOOP EXT 75 Ω OUT IN IN IN IN IN OUT FRONT OPTICAL1 (CD) IN OPTICAL2 (TV) IN OPTICAL3 (DVD) IN COAXIAL IN OPTICAL OUT SURROUND 6-8 Ω EACH SPEAKER CHAQUE R L DI.
16 RQT6208 T roub leshooting guide Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem: In the U.S.A., contact the Panasonic Customer Call Center at 1-800-211-7262, or e-mail consumerproducts@panasonic.
17 RQT6208 Specifications (IHF’78) ■ AMPLIFIER SECTION Rated minimum sine wave RMS power output 40 Hz – 20 kHz both channels driven 0.9 % total harmonic distortion 100 W per channel (6 Ω ) 1 kHz continuous power output both channels driven 0.
18 RQT6208 W arranty (U .S.A.) Panasonic Consumer Electronics Company, Division of Matsushita Electric Corporation of America One Panasonic Way Secaucus, New Jersey 07094 P anasonic/T echnics A udio P.
19 RQT6208 Servicenter List (U .S.A.) Step 1 Step 2 Step 3 Step 4 Before use Others Reference.
Panasonic Consumer Electronics Company, Division of Matsushita Electric Corporation of America One Panasonic Way Secaucus, New Jersey 07094 http://www.panasonic.com Panasonic Sales Company, Division of Matsushita Electric of Puerto Rico, Inc. ( “ PSC ” ) Ave.
An important point after buying a device Panasonic SA-HE100 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Panasonic SA-HE100 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Panasonic SA-HE100 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Panasonic SA-HE100 you will learn all the available features of the product, as well as information on its operation. The information that you get Panasonic SA-HE100 will certainly help you make a decision on the purchase.
If you already are a holder of Panasonic SA-HE100, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Panasonic SA-HE100.
However, one of the most important roles played by the user manual is to help in solving problems with Panasonic SA-HE100. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Panasonic SA-HE100 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
