Instruction/ maintenance manual of the product TX-8011 Onkyo
Go to page of 24
E n Ster eo Receiv er TX-8011 Instruction Manual Thank you for purchasing an Onkyo Stereo Recei ver . Please read this manual thoroughly before making connections and plugging in the unit. F ollo wing the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your ne w Stereo Recei ver .
2 Impor tant Safeguar ds 1. Read Instructions —All the safety and operating instructions should be read before the appliance is operated. 2. Retain Instructions —The safety and operating instructions should be retained for future reference.
3 Important Safeguards —Continued 17. Overloading —Do not ov erload wall outlets, exten- sion cords, or integral con v enience receptacles as this can result in a risk of fire or electric shock.
4 Precautions 1. Recording Copyright —Unless it’ s for personal use only , recording copyrighted material is illegal with- out the permission of the copyright holder . 2. A C Fuse —The A C fuse inside the TX-8011 Receiv er is not user-serviceable.
5 Features • 50 W/ch min. RMS at 8 ohms, both channels driv en from 20 Hz to 20 kHz, with no more than 0.08% THD. • Discrete output stage circuits for true high-current, low-impedance dri v e.
6 Fr ont & Rear P anels For detailed information, refer to the pages in parentheses. A ST ANDBY/ON button (16) This button is used to set the TX-8011 to On or Standby . B ST ANDBY indicator (16) This indicator lights up when the TX-8011 is in Standby mode, and it flashes while a signal is being receiv ed from the remote controller .
7 Front & Rear P anels —Continued A STEREO MODE A UT O/FM MUTE ON indicators (19) These indicators light up when the tuner is tuned to an FM station and Stereo mode is selected. B STEREO MODE MONO/FM MUTE OFF indicators (19) These indicators light up when the tuner is tuned to an FM station and Mono mode is selected.
8 Front & Rear P anels —Continued A Grounding scre w (14) This screw is for connecting a turntable’ s ground wire. B AM ANTENNA (12, 13) These push terminals are for connecting an AM antenna. C FM ANTENNA (12, 13) This socket is for connecting an FM antenna.
9 Remote Contr oller A PO WER b utton (16) This button is used to set the TX-8011 to On or standby . B INPUT SELECT OR buttons (17, 19) These buttons are used to select the input sources. C DECK-A & DECK-B (works only with Onkyo cassette recorder connected via .
10 Remote Controller —Continued Notes: • The batteries should last for about six months, although this will vary with usage. • If the remote controller doesn’t w ork reliably , try replacing the batteries. • Don’t mix ne w and old batteries or dif ferent types of batteries.
11 Connections Before you connect your speakers, read the follo wing: • Disconnect the po wer cord from the wall outlet. • Read the instructions supplied with your speakers.
12 Connections —Continued Adjusting the P osition of the FM Indoor Antenna The FM indoor antenna is for indoor use only . Extend the antenna fully and point it in various directions to find the best reception. Secure it in that position with thumbtacks or something similar .
13 Connections —Continued If you cannot achiev e good reception with the supplied indoor FM antenna, try a commercially av ailable out- door FM antenna instead. Notes: • Outdoor FM antennas work best outside, b ut usable results can sometimes be obtained when installed in an attic or loft.
14 Connections —Continued Use an RCA audio cable to connect the TX-8011’ s CD IN L/R jacks to the analog audio output jacks on your CD player , as sho wn.
15 Connections —Continued W ith (Remote Interacti ve) you can control your -compatible Onkyo CD player and cassette recorder with the TX-8011’ s remote controller , and use the fol- lowing special.
16 Connections —Continued Notes: • Bef ore connecting the power cord, connect all of y our speakers and components. •T urning on the TX-8011 may cause a momentary po wer surge that might interfere with other electrical equipment on the same circuit.
17 Pla ying Y our Components This chapter explains ho w to use the TX-8011 with your other components. Y ou can use a graphic equalizer by connecting it to the T APE 2 IN/OUT jacks and selecting T APE 2. Y ou can adjust the bass, treble, and balance. Y ou can temporarily mute the TX-8011.
18 Playing Y our Components —Continued W ith the sleep timer , you can set the TX-8011 so that it automatically turns off after a specified period. To cancel the sleep timer , press the remote controller’ s [SLEEP] button repeatedly until the SLEEP indicator disappears.
19 Using the T uner W ith the built-in tuner , you can enjoy AM and FM radio stations, and you can store your fa vorite stations as pre- sets for quick selection. When tuned into a stereo FM station, the TUNED and STEREO indicators appear on the display , as shown.
20 Using the T uner —Continued Y ou can store up to 30 of your fa vorite radio stations as presets, 10 in each group (A, B, C). Presetting Radio Stations 1 T une into the station that you want to store as a preset. 2 Press the [MEMOR Y] b utton. The MEMOR Y indicator appears.
21 Recor ding This chapter explains ho w to record the selected input source to an audio component with recording capability , and how to dub from one cassette recorder to another . The effect of a graphic equalizer connected to the T APE 2 IN/OUT jacks will not be recorded.
22 Tr oubleshooting If you hav e any trouble using your TX-8011, look for a solution in this section. If you can’t resolv e the issue yourself, contact your Onkyo dealer . Can’t turn on the TX-8011? • Make sure that the po wer cord is properly plugged into the wall outlet.
23 Specifications Amplifier Section Power Output Front L/R 50 W + 50 W (8 Ω , 20 Hz–20 kHz, FTC) Dynamic Power 105 W + 105 W (4 Ω ) 70 W + 70 W (8 Ω ) THD (T otal Harmonic Distortion) 0.08 % (Power Rated) Damping Factor 60 (Front, 1 kHz, 8 Ω ) Input Sensitivity and Impedance 150 mV/50 k Ω (LINE) 2.
24 SN 29343912 I0408-1 Sales & Product Planning Div. : 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN Tel: 072-831-8023 Fax: 072-831-8124 ONKYO U.S.A. CORPORATION 18 Park Way, Upper Saddle River, N.J. 07458, U.S.A. Tel: 201-785-2600 Fax: 201-785-2650 http://www.
An important point after buying a device Onkyo TX-8011 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Onkyo TX-8011 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Onkyo TX-8011 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Onkyo TX-8011 you will learn all the available features of the product, as well as information on its operation. The information that you get Onkyo TX-8011 will certainly help you make a decision on the purchase.
If you already are a holder of Onkyo TX-8011, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Onkyo TX-8011.
However, one of the most important roles played by the user manual is to help in solving problems with Onkyo TX-8011. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Onkyo TX-8011 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
