Instruction/ maintenance manual of the product PZ40X Nikon
Go to page of 10
NE 使用説明書 INSTRUCTION MANUAL ISTRUZIONI MANUAL DE USUARIO English Italiano Español 日本語.
Please read and follow these essential safety procedures to prevent accidents, injury to yourself and others, as well as property damage. Read all these instructions carefully to insure the safe use of your Sunpak flash unit. W ARNING Do not attempt to open, repair , or modify this unit.
3 Welcome to the worldwide family of Sunpak Owners. Y our Sunpak PZ40X is specially designed for NIKON AF-SLRs as well as some Nikon type digital cameras.
Description of Parts Flashtube Housing Accessory (optional) Mounting Guide Battery Compartment Cover Autofocus Infrared Flash Knurled Lock Ring Dedicated/Hot Shoe Contact LCD Display Bounce angle disp.
Installing the batteries 5 1. Before installing the batteries, please check that the power switch is in the "OFF" position. T o unlock the battery compartment, push lightly on the center of the cover . 2. T o open the battery compartment slide the cover back (toward the rear of the unit) as shown.
TTL Mode 3D Multi Flashing Mode (3D MULT-Mode) Manual Mode Press the Mode Select Button Press the Zoom button With A-group cameras, repeated pressing of the mode button will cycle the flash display from 3DMUL T Mode to TTL and through the manual power ratio settings, returning to the 3DMUL T Mode.
7 With digital cameras (such as the Nikon D-100), both TTL Autoflash Mode and Manual Mode are available. Please refer to Page 6. When taking a picture, the Ready light blinks at first and then lights steadily .
There are five power-output settings available with the PZ40X in manual mode, from full power to 1/16 power . First, push the Mode Selector button continually until “M” is displayed. The flash will t hen be in the Manual mode. Please refer to the Chart 1 on page 15 for details on setup.
9 Auto OK When the subject is within the Auto Effective Range and there is enough light, the "Auto OK" symbol in the LCD display will blink for about 2 seconds after the flash has been fired. If the symbol goes out, then there was not enough light for an exposure.
Continuous Use Do not use the flash continuously for more than the number of times stipulated in the table below , in order to prevent damage to the unit. Once the maximum number of flashes has been reached, allow the flash to rest for at least 10 minutes before using it again.
An important point after buying a device Nikon PZ40X (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Nikon PZ40X yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Nikon PZ40X - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Nikon PZ40X you will learn all the available features of the product, as well as information on its operation. The information that you get Nikon PZ40X will certainly help you make a decision on the purchase.
If you already are a holder of Nikon PZ40X, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Nikon PZ40X.
However, one of the most important roles played by the user manual is to help in solving problems with Nikon PZ40X. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Nikon PZ40X along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
