Instruction/ maintenance manual of the product FASTRAC FT1000H APW Wyott
Go to page of 12
Phone: +1 (214) 421-7366 Fax: +1 (214) 565-0976 T oll Free: +1 (800) 527-2100 Website: www .apwwyott.com E-mail: info@apwwyott.com INST ALLA TION AND OPERA TING INSTRUCTIONS INTENDED FOR OTHER THAN HO.
SAFETY PRECAUTIONS Before installing and operating this equipment be sure everyone involved in its operation are fully trained and are aware of all precautions. Accidents and problems can result by a failure to follow fundamental rules and precautions.
3 1. IMPORT ANT SAFETY INSTRUCTIONS ! ! W ARNING: Plug unit into a properly grounded electrical outlet of the correct voltage, size and plug configuration. If the plug and receptacle do not match, contact a qualified electrician to determine the proper voltage and size and install the proper electrical outlet.
GENERAL INFORMA TION I. Consult the rating label for model and serial number . Write this information below before proceeding: A. Model # __________________ B. Serial # __________________ II. Overall Dimensions w/Wire Feeder - 16.1" H (409mm) x 16.
5 III. T oaster Placement A. Locate the toaster near a grounded receptacle of the proper configuration (see below). Plug the cordset directly into receptacle (DO NOT USE AN EXTENSION CORD). 1. In the United States, NEMA 6-20R. 2. In Canada, NEMA 6-20R.
6 D. Slide the reflector/crumb tray out of the toaster by pulling forward. Dispose of crumbs and wash the tray in hot, soapy water . Dry the tray and place it back into the toaster . E. Remove the bottom toast drawer from the toaster by sliding it out and lifting up.
THE PROBLEM THE CAUSE THE SOLUTION Won't toast... a. T oaster cold. a. Allow five (5) minutes for warm up. b. Wrong power switch position. b. Position power switch to full power . c. Wrong conveyor speed setting. c. Reduce conveyor speed. T oasts unevenly .
8 ITEM P/N DESCRIPTION QTY 1 34236 TERMINAL BLOCK END MTG 1 2 34237 TERMINAL BLOCK (6) .250 MALE 3 3 38254 IDLER SHAFT ASSY 1 4 83956 DRIVE SHAFT ASSY 2 5 38278 CRUMB TRA Y/REFLECT OR ASSY 1 6 38129 T.
9 EXPLODED VIEW - FT 1000H 4 28 22 17 18 20 13 14 1 1 9 10 16 1 15 25 26 6 24 2 23 27 21 19 3 12 8 7 5.
10 WIRING DIAGRAM - MODEL FT 1000H ! ! IMPORT ANT NOTICE: The information contained in this section of the manual is intended for individuals possessing backgrounds of electrical and mechanical experience, such as an authorized APW Wyott service technician.
1 1 APW WYOTT EQUIPMENT LIMITED W ARRANTY APW W yott Foodservice Equipment Company warrants it's equipment against defects in materials and workmanship, subject to the following conditions: This warranty applies to the original owner only and is not assignable.
12 APW WYOTT 729 Third Avenue Dallas, TX 75226 Phone: +1 (214) 421-7366 Fax: +1 (214) 565-0976 T oll Free: +1 (800) 527-2100 Website: www .apwwyott.com E-mail: info@apwwyott.
An important point after buying a device APW Wyott FASTRAC FT1000H (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought APW Wyott FASTRAC FT1000H yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data APW Wyott FASTRAC FT1000H - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, APW Wyott FASTRAC FT1000H you will learn all the available features of the product, as well as information on its operation. The information that you get APW Wyott FASTRAC FT1000H will certainly help you make a decision on the purchase.
If you already are a holder of APW Wyott FASTRAC FT1000H, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime APW Wyott FASTRAC FT1000H.
However, one of the most important roles played by the user manual is to help in solving problems with APW Wyott FASTRAC FT1000H. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device APW Wyott FASTRAC FT1000H along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
