Instruction/ maintenance manual of the product 4KUIS185S KitchenAid
Go to page of 8
I I I.
CHANGING THE BIN DOOR AND LOWER PANEL The storage bin door and lower panel are designed to accept an optional decorative wood panel of your choice. The wood panel should be no more than VI inch (6 mm) thick. Cut it to the same size as the production metal panel.
GENERAL INFORMATION . UNPACK INTERIOR PACKING OPEN BOTTOM FLAPS FIGURE 3 FIGURE 4 1 Lay carton on rear face and break open bottom flaps. 2 Set carton upright with all four flaps outward. See Figure 3. 3 Lift carton up and off of machine. 4 Remove all tape and packaging material from the outside and inside of the cabinet.
FOR THE PLUMBER . CONNECT TO WATER . CONDENSATE PUMP (observe local codes) 1 Use l/4” (6 mm) OD soft copper tubing for the cold water supply. 2 Provide a convenient manual shut-off valve in the water line. 3 Position the t b’ u rng so it can enter the access hole located in the right-hand rear of the cabinet.
- SCREWS FIGURE 5B REMOVE SHUNT PLUG IN CONDENSATE PUMP FIGURE 5C FOR THE ELECTRICIAN ELECTRICAL REQUIREMENTS A 115 Volt, 60 Hz, AC only, 15 Amp fused electrical sup- ply is required (time delay fuse or circuit breaker is recommended). It is recommended that a separate circuit, serving only this appliance, be provided.
eleCtriCal inspector), a temporary adaptor may be plugged into the existing 2-prong wall receptacle to mate with the Bprong power supply cord. See HOWEVER, IS NOT RECOMMENDED.
THINGS TO REMEMBER 0 Water enters only during the defrost cycle. Therefore the first cycle will be completed without water in the system. 0 As the room and water temperatures vary, so will the amount of ice produced. This means that higher operating temperatures will result in reduced ice production.
CUBELET CUTTER GRIDS 19mmx19mm b CUBE CUTTER GRID l-114” x l-114” Cube Grid (32 mm x 32 mm) CHECK OPERATION Start the unit by turning the service switch to “ON” and opening the line water valve. NOTE: Left is “OFF”-Middle is “ON”--Right is “CLEAN.
An important point after buying a device KitchenAid 4KUIS185S (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought KitchenAid 4KUIS185S yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data KitchenAid 4KUIS185S - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, KitchenAid 4KUIS185S you will learn all the available features of the product, as well as information on its operation. The information that you get KitchenAid 4KUIS185S will certainly help you make a decision on the purchase.
If you already are a holder of KitchenAid 4KUIS185S, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime KitchenAid 4KUIS185S.
However, one of the most important roles played by the user manual is to help in solving problems with KitchenAid 4KUIS185S. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device KitchenAid 4KUIS185S along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center