Instruction/ maintenance manual of the product CA-MXGT91R JVC
Go to page of 43
For Customer Use: Enter below the Model No. and Serial No. which are located either on the rear , bottom or side of the cabinet. Retain this information for future reference.
IMPORT ANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appro- priate safety approved extension lead or consult your dealer .
– G-2 – SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured.
– 1 – Introduction About This Manual This manual is org anized as follows: • The manual mainly explains operations using the b uttons and controls on the unit. Y ou can also use the b uttons on the remote control if they ha ve the same or similar names (or marks) as those on the unit.
– 2 – Contents Location of the Buttons and Controls ....................... 3 Front Panel ................................................................. 3 Remote Control .......................................................... 5 Getting Started .
– 3 – Location of the Buttons and Controls Become familiar with the b uttons and controls on your unit. Front Panel Front Panel PLA Y & EXCHANGE ST ANDBY/ON CD-R / RW PL A YBA CK ST ANDBY 1 2 5 6 7 8 9 p q w e r t y u i 3 4 z / l h k f s o ; a d g j EN01-14.
– 4 – See pages in the parentheses for details. Front Panel 1 Disc trays 2 ST ANDBY/ON b utton and ST ANDBY lamp (9, 24, 25) 3 Remote sensor 4 ECO b utton (9) 5 PRESET + / – control (12) 4 / ¢ .
– 5 – When using the remote control, point it at the remote sensor on the front panel. Remote Control Remote Control 1 Disc number buttons (CD1, CD2, and CD3) (16, 17) Pr essing one of these buttons also turns on the unit.
– 6 – Getting Started Supplied Accessories Make sure that you ha ve all the follo wing items. The number in the parentheses indicates the quantity of the pieces supplied. • AM (MW/L W) loop antenna (1) • FM antenna (1) • Remote control (1) • Batteries (2) If anything is missing, consult your dealer immediately .
– 7 – 1 Connect the AM (MW/L W) loop antenna to the AM LOOP terminals as illustrated. • If the AM (MW/L W) loop antenna wire is cover ed with vinyl, remov e the vinyl by twisting it as shown in the dia gram. 2 T urn the AM (MW/L W) loop antenna until you ha ve the best reception.
– 8 – Connecting Other Equipment Y ou can connect both analog and digital equipment. • DO NOT connect any equipment while the power is on. • DO NOT plug in any equipment until all connections are complete.
– 9 – Common Operations T urning On or Off the Power T o turn on the unit, press ST ANDBY/ON so that the ST ANDBY lamp goes off. T o turn off the unit (on standby), press ST ANDBY/ON again so that the ST ANDBY lamp lights up. • The clock appears on the display (if Ecology Mode is not activated).
– 10 – Continued D.CLUB (Dance CLUB) OFF (Canceled) HALL STADIUM ROCK POP CLASSIC MANUAL 1 MANUAL 2 MANUAL 3 * The SOUND MODE indicator also lights up on the display . Reinforcing the Bass Sound Y ou can select one of the 4 subwoofer lev els. This function only affects the pla yback sound, but does not af fect your recording.
– 11 – Surround modes ** : D.CLUB : Increases resonance and bass. HALL : Adds depth and brilliance to the sound. ST ADIUM : Adds clarity and spreads the sound, like in an outdoor stadium. SEA (Sound Effect Amplifier) modes: R OCK : Boosts lo w and high frequency .
– 12 – Listening to FM and AM (MW/L W) Broadcasts T uning in a Station 1 Pr ess FM/AM. The unit automatically turns on and tunes in the pre viously tuned station (either FM or AM — MW/L W). • Each time you press the button, the band alternates between FM and AM (MW/L W).
– 13 – Receiving FM Stations with RDS RDS (Radio Data System) allo ws FM stations to send an additional signal along with their regular pr ogram signals. For e xample, the stations send their station names, as well as information about what type of program the y broadcast, such as sports or music, etc.
– 14 – Switching to a Program T ype of Y our Choice T emporarily By recei ving EON (Enhanced Other Networks) data sent by FM RDS stations, the EON function allo ws the unit to switch temporarily to a broadcast program of your choice (T A, NEWS, or INFO) from a dif ferent station.
– 15 – Playing Back CDs (CD/CD-R/CD-RW) This unit has been designed to playback the follo wing CDs: • CD (Audio CD) • CD-R (CD-Recordable) • CD-R W (CD-ReWritable) Continued use of irregular shape CDs (heart-shape, octagonal, etc.) can damage the System.
– 16 – Playing Back the Entire Discs — Continuous Play 1 Load CDs. 2 Pr ess one of the disc number b uttons (CD1, CD2, and CD3) f or the disc you want to play . CD play starts from the f ir st track of the selected disc and the disc number lamp starts flashing.
– 17 – Programming the Playing Order of the T racks — Program Play Y ou can arrange the order in which tracks play before y ou start playing. Y ou can program up to 32 tracks. • T o use Repeat play (see page 18) for Program play , press REPEA T after starting Program play .
– 18 – Playing at Random — Random Play The tracks of all loaded CDs will play at random. • T o use Repeat play for Random play , press REPEA T after starting Random play . 1 Load CDs. • If the current playing source is not the CD player , pr ess CD 3¥8 , then 7 before going to the next step.
– 19 – Y ou can play back type I, type II, and type IV tapes without changing any settings. Playing Back a T ape 1 Pr ess EJECT ( 0 ) for the deck y ou want to use. 2 Put a cassette in with the exposed part of the tape down. 3 Close the cassette holder gently .
– 20 – Recording Recording a T ape on Deck B 1 Press EJECT 0 f or the deck B. 2 Put a recorda ble cassette into deck B. 3 Close the cassette holder gently . 4 Check the tape direction of deck B. • If the tape direction is not correct, press T APE 2 3 twice then 7 to change the tape direction.
– 21 – CD Direct Recording Everything on the CD goes onto the tape in the order it is on the CD, or according to the order you hav e made for Program play . On the unit ONL Y : 1 Put a recorda ble cassette into deck B. 2 Load CDs. 3 Press one of the disc number buttons (CD1, CD2, and CD3) to select the disc, then 7 .
– 22 – Auto Edit Recording By using Auto Edit Recording, you can record the CD tracks to f it the tape. Auto Edit Recording makes a program by selecting the CD tracks in numerical order . Howe ver , to prev ent the end of the last track on the front side from being cut off , the last track is selected so as to fit on the remaining tape length.
– 23 – Using the T imers There are three timers a vailable — Daily Timer , Recording T imer , and Sleep T imer . Before using the timers, you need to set the clock built in the unit. (See page 9.) Using Daily Timer W ith Daily T imer , you can wake to your fa vorite music or radio program.
– 24 – 5 Tu r n 4 / ¢ to select the sour ce to play , then press SET/DISPLA Y . • The source changes as follows: TUNER FM : tunes into a specified preset FM station. = Go to step 6. TUNER AM : tunes into a specified preset AM (MW/L W) station. = Go to step 6.
– 25 – 4 Set the on-time y ou want the unit to turn on at. 1) Tu r n 4 / ¢ to set the hour , then press SET/DISPLA Y . 2) Tu r n 4 / ¢ to set the minute, then press SET/DISPLA Y . “OFF TIME” appears for 2 seconds, then the unit enters of f- time setting mode.
– 26 – T imer Priority Since each timer can be set separately , you may wonder what happens if the setting for these timers ov erlaps. Here are examples. Recording Timer has priority over Daily Timer and Sleep Timer . • If Daily T imer is set to come on while Recording T imer is operating, Daily T imer will not come on at all.
– 27 – Classification of the PTY codes for some FM stations may be different from the above list. Description of the PTY codes: NEWS : News. AFF AIRS : T opical program expanding or enlarging upon the news — debate, or analysis. INFO : Program the purpose of which is to impart advice in the widest sense.
– 28 – If you are ha ving a pr oblem with your unit, check this list for a possible solution before calling for service. If you cannot solve the problem from the hints gi ven here, or the unit has been physically damaged, call a qualif ied person, such as your dealer , for service.
– 29 – Maintenance T o get the best perfor mance of the unit, keep your discs, tapes, and mechanism c lean. Handling cassette tapes • If the ta pe is loose in its cassette, take up the slack by inserting a pencil in one of the reels and rotating.
– 30 – Specifications CA-MXGT91R Amplifier section Output Po w er (IEC 268-3/DIN) SUBWOOFERS: 86 W per channel, min. RMS, both channels dri ven into 6 Ω at 63 Hz with no more than 0.9% total harmonic distortion. MAIN SPEAKERS: 21 W per channel, min.
MEMO MEMO 01.1.18, 8:40 PM 2.
MEMO MEMO 01.1.18, 8:40 PM 2.
GV40234-001A NOTICE/ BEMERKUNG/ A VIS/ OPMERKING/ NOTIS/ HUOMIO/ BEMÆRKE/ A VISO/ A VVISO English Note on Recording an RDS FM Station If you start recording an FM station while its RDS information is.
0201MWMMDWJEM EN VICT OR COMP ANY OF JAP AN, LIMITED CA-MXGT91R&G71R[B]Coverf 2/15/01, 12:03 PM 2.
1 Grazie per aver acquistato questi altoparlanti della JVC. Prima di cominciare l’uso degli altoparlanti, leggete attentamente le istruzioni per assicurare le migliori prestazioni. Qualora sorgessero dei dubbi, rivolgetevi al vostro rivenditore JVC.
2 BLUE BLA U BLEU BLA UW AZUL BLU BLA BLA SININEN BLUE BLA U BLEU BLA UW AZUL BLU BLA BLA SININEN BLACK SCHW ARZ NOIR ZW ART NEGRO NERO SV ART SORT MUST A BLACK SCHW ARZ NOIR ZW ART NEGRO NERO SV ART .
3 ANSCHLUSS • Verwenden Sie zum Betrieb dieses Lautsprechersystems keinen anderen Verst ä rker, ausgenommen CA-MXGT91R. • Schalten Sie vor dem Anschlu ß der Lautsprecher an den Verst ä rker die Spannungsversorgung des gesamten Systems aus.
4 AANSLUITINGEN • Gebruik GEEN andere versterker dan de CA-MXGT91R om dit luidsprekersysteem aan te sturen. • Schakel de spanning van alle aangesloten komponenten uit alvorens de luidsprekers met de versterker te verbinden. • Het maximale vermogen van de SP-MXGT91R hoofdluidspreker is 55 W en van de subwoofer 130 W.
5 COLLEGAMENTO • NON usare un amplificatore diverso dal modello CA-MXGT91R per utilizzare questo sistema di altoparlanti. • Spegnete la corrente dell ’ intero sistema prima di collegare gli altoparlanti all ’ amplificatore.
6 TILSLUTNING • Anvend IKKE anden forst æ rker end CA-MXGT91R til drift af dette h ø jttalersystem. • Sluk for str ø mmen til hele systemet f ø r h ø jttalerne forbindes til forst æ rkeren. • Den maksimale belastningskapacitet for SP-MXGT91R hovedh ø jttaleren er 55 W/for subwooferen 130 W.
An important point after buying a device JVC CA-MXGT91R (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought JVC CA-MXGT91R yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data JVC CA-MXGT91R - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, JVC CA-MXGT91R you will learn all the available features of the product, as well as information on its operation. The information that you get JVC CA-MXGT91R will certainly help you make a decision on the purchase.
If you already are a holder of JVC CA-MXGT91R, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime JVC CA-MXGT91R.
However, one of the most important roles played by the user manual is to help in solving problems with JVC CA-MXGT91R. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device JVC CA-MXGT91R along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
