Instruction/ maintenance manual of the product 08E92-SNA-100B Honda
Go to page of 20
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 1 of 21 08E92-SNA-1B00-91 FEB 2008 200 6-2008 CIVIC 4-DOOR (A/T ONLY) REMOTE ENGINE STARTER SYSTEM INSTALLATION INSTRUCTIONS Accessory Application Publications No.
2 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 7 Foam cushion tapes Flange nut Clip Green relay (5-pin) Template Illustration of the Engine Starter System.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 3 of 21 Setting the Control Unit 3. Get the control unit. Using a small flat-tip screwdriver, adjust the switches on the control unit to the locations shown. Using a isopropyl alcohol on a shop towel, clean the area where the protective tape will attach.
4 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 8. Remove the driver’s dashboard lower cover (eight clips). 5202121T DRIVER’S DASHBOARD LOWER COVER 8 CLIPS 7. If equipped, remove the driver’s dashboard under cover (turn the knob counterclockwise, and release two clips and pin).
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 5 of 21 9. Lower the tilt lever, and pull the steering wheel toward you. Insert a long blade flat-tip screwdriver along the guide of the column lower cover, and pry the retaining tab of the column upper cover.
6 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 1 3. Remove the sunvisor holders. Using a small flat- tip screwdriver, push the hook, and turn the holder 90°, then pull it out.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 7 of 21 1 8. Pull away the weatherstrip from the left front pillar trim. Remove the left front pillar trim (two clips). 5202100T 2 CLIPS LEFT FRONT PILLAR TRIM WEATHERSTRIP 1 9 .
8 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 23. Measure the antenna cable as shown. Attach the three foam cushion tapes to the antenna cable in the measurement shown. 2 4. Using isopropyl alcohol on a shop towel, clean the area where the antenna will attach.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 9 of 21 27. Route the antenna cable under the roof liner towards the driver’s side of vehicle, and down along the vehicle harness. Be careful not to crease the roof liner.
10 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 3 4. Install the four relays to the engine starter harness relay blocks. Be careful to install the relays properly, or a malfunction will result. Routing the Engine Starter Harness 3 3.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 11 of 21 3 7. Disconnect the vehicle 8-pin connector on the rear of the wiper switch and plug the engine starter harness 8-pin connector into the vehicle 8-pin connector.
12 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 3 9. Wrap the vehicle 7-pin connector with one foam cushion tape, then place the vehicle 7-pin connector into the gap of the column. 6D01111T VEHICLE 7-PIN CONNECTOR (brown) (Squeeze into this area.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 13 of 21 4 6 . Secure the engine starter harness to the vehicle harness using a wire tie. • With driver's dashboard under cover: Secure in the hole you made in the instrument panel.
14 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 5 0. Wrap foam cushion tape to the vehicle 2-pin and 4-pin connectors and secure them with a wire tie. Then, secure the vehicle harness with a wire tie. Reconnect the vehicle 42-pin connector.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 15 of 21 5 3. Install the clip from the engine starter harness to the fuse box bracket behind the fuse box. 6D01181T ENGINE STARTER HARNESS FUSE BOX BRACKET CLIP FRONT GROUND BOLT (Reuse.
16 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 6 0. Check that all wire harnesses are routed properly and all connectors are plugged in. 6 1. Reinstall all removed parts. Check that all clips and other fasteners are installed securely.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 17 of 21 752501AS CAR ICON 752502AS CHECK BUTTON Input the VIN and other required information. 752504AS Select “R/C ENG STARTER.” CHECK BUTTON 752503AS Select “Honda Systems.
18 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 752505AS “REMARKS” message CHECK BUTTON 752506AS Select “REGISTER REMOTE CONTROL ENGINE STARTER UNIT.” CHECK BUTTON 752507AS “Obtain PCM-code" message CHECK BUTTON 752509AS Input the PCM code.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 19 of 21 752510AS "Registration" message CHECK BUTTON 752511AS “Check that the engine can be started by the Transmitter” CHECK BUTTON 1 1.
20 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 732904A Y DISPLAY COMMAND BUTTON START BUTTON TRANSMITTER STOP BUTTON FUNCTION CHECK Operating Conditions • The hood is closed. • Shift lever is in Park.
An important point after buying a device Honda 08E92-SNA-100B (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Honda 08E92-SNA-100B yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Honda 08E92-SNA-100B - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Honda 08E92-SNA-100B you will learn all the available features of the product, as well as information on its operation. The information that you get Honda 08E92-SNA-100B will certainly help you make a decision on the purchase.
If you already are a holder of Honda 08E92-SNA-100B, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Honda 08E92-SNA-100B.
However, one of the most important roles played by the user manual is to help in solving problems with Honda 08E92-SNA-100B. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Honda 08E92-SNA-100B along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
