Instruction/ maintenance manual of the product Twist-n-Stow Rudder Hobie
Go to page of 4
.
T wist and Stow Rudder Replacement Use the following instructions to replace your twist and stow rudder . T o remove the rudder that is cur- rently on the boat, bend and pull the cotter pins that are at the bottom of the rudder pin and push the pin out of the top.
4. WIth the line already passed though the housing, pick up the rudder section and feed the line though the upper most hole located along the circular drum. Y ou will notice two Phillips heads screws very close to one another . Loosen the screws a few turns and pull the line up and around the forward most Phillips head screw and tighten it down.
Steering Control Lines 1. The two lines that exit the sides of the boat are for the steering. Before running the lines to the rud- der , place the steering handle in the close to center position. On the Mirage Adventure, keep the steer- ing handle turned slightly to the right.
An important point after buying a device Hobie Twist-n-Stow Rudder (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hobie Twist-n-Stow Rudder yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hobie Twist-n-Stow Rudder - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hobie Twist-n-Stow Rudder you will learn all the available features of the product, as well as information on its operation. The information that you get Hobie Twist-n-Stow Rudder will certainly help you make a decision on the purchase.
If you already are a holder of Hobie Twist-n-Stow Rudder, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hobie Twist-n-Stow Rudder.
However, one of the most important roles played by the user manual is to help in solving problems with Hobie Twist-n-Stow Rudder. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hobie Twist-n-Stow Rudder along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
