Instruction/ maintenance manual of the product SILH30E-B Heatilator
Go to page of 24
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 1 Owner ’ s Manual Installation and Operation Models: SILH30E-B Electric Fireplace/Insert DO NOT DISCARD THIS MANUAL CAUTION • Important operating and maintenance instructions included. • Leave this manual with party responsible for use and operation.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 2 Read this manual before installing or operating this heater . Please retain this owner ’ s manual for future reference.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 3 T able of Contents 1 Listing and Code Approvals A. Appliance Certifi cation . . . . . . . . . . . . . . . . . . . . . . . . . 4 B. Important Instructions . . . . . . . . . . . . . . . . . . . .
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 4 1 1 Listing and Code Appro vals Not inte nded f or use a s a prim ar y he at source . This heater is teste d and approv ed as a dec orative heater . It should not be factored as a primar y heat sourc e in residential heating c alculations.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 5 2 G etting Star ted A. Design and Installation Considerations Check building codes prior to installation. • Installation MUST comply with local, regional, state and national codes and regulations.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 6 3 F raming and Clearances A. Selecting Heater Location Several options are available to you when choosing a loca- tion for your heater . This heater may be used as a room divider , installed along a wall, across a corner or used in an exterior chase.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 7 D B A 1 in. min. (26 mm) 9-3/4 in. (248 mm) 9-3/4 in. (248 mm) A A C 1/2 in. min. (13 mm) Figure 3.1 Heater Locations Fire Risk • Comply with all minimum clearances to combustibles as specifi ed.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 8 C. Frame the Heater Figure 3.2 shows a typical framing (using 2 x 4 lumber) of the heater , assuming combustible materials are used. All re- quired clearances to combustibles around the heater must be adhered to.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 9 4 4 Installation Sharp Edges • Wear protective gloves and safety glasses during installation. CAUTION Shock Risk Improperly grounded outlets could cause electrical shock. • Always use properly grounded, fused and polarized outlets.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 10 B. As an Insert Pre-installation Preparation This insert and its components are tested and safe when in- stalled in accordance with this manual. Report to your dealer any parts damaged in shipment, particularly the condition of the glass.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 11 Note: This heater must be elect rically w ired and grounded in acc ordance with loc al codes or , in the absence of loc al codes, with National Electric Code ANSI /NFP A 70- latest edition or the Canad ian Ele ctr ic Code, C SA C2.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 12 B R W W NC NO C RW RT Thermistor Sensor Switch Assembly Cable Brown Red Black Black Red White Cable Power Cord W ire with Ribs No Connection Black W ire to Heater Power Cord Black W ire Figure 4.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 13 5 Ac c ess or ie s A. Install the Front Face Install the front face following the instructions packaged with the face. B. Install other Optional Accessories Installation of other optional accessories may be done at this time.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 14 6 Finishing A. Finishing Material • Combustible Material Material which is made of or surfaced with wood, compressed paper , plant fi bers, plastics, or any material capable of igniting and burning, whether fl ame proofed or not, plastered or not plastered.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 15 HOT! DO NOT TOUCH. SEVERE BURNS MA Y RESUL T . CLOTHING IGNITION MA Y RESUL T . • Keep children away . • CAREFULL Y SUPER VISE children in same room as heater . • Alert children and adults to hazards of high temperatures.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 16 8 Tr o u b l e s h o o t i n g Issues Possible Causes Solutions Heater doesn’t turn on with the main switch or remote transmitter . 1. Power switch is off. 1. Turn the power switch to the “ON” position.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 17 9 Maintenance and Ser vice Shock Risk Burn Risk Cleaning, performing maintenance or moving this electric heater without disconnecting power and allowing the heater to cool could create a shock or burn hazard.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 18 E. Maintenance T ask List Handle glass assembly with care. When cleaning glass door: • Avoid striking, scratching or slamming glass. • Do NOT use abrasive cleaners. • Use a hard water deposit glass cleaner on white fi lm.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 19 1 0 10 Reference Materials A. Heater Dimensions 18-5/8 in. (473 mm) 9-1/4 in. (235 mm) 1/2 in. (13 mm) 27-5/8 in. (702 mm) 26 in. (661 mm) 16 in. (407 mm) 4-1/4 in. (108 mm) 22-5/8 in. (575 mm) 22-7/8 in.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 20 B. Optional Components DFEB2824 DFED4432 DFED4028 DFED2824 RF26E (SILH30E-B) Side Refractory RC-ELEC-HTL Remote Control Remote Control Refract.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 21 C. Service Parts Exploded Parts Diagram SILH30E-B Service Parts SILH30E-B Beginning Manufacturing Date: Apr 2005 Ending Manufacturing Date: Ac.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 22 Service Parts List SILH30E-B Service Parts SILH30E-B Beginning Manufacturing Date: Apr 2005 Ending Manufacturing Date: Active # Description of Part SILH30E-B Qty .
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 23 D. Limited W arranty W ARRANTY Hearth & Home T echnologies Inc. (HHT) Electric Fireplaces are tested and inspected prior to shipment and are guaranteed from defect to the purchaser of each new product.
Heatilator • SILH30E-B • 4038-896 Rev C • 1 1/05 24 Hearth & Home T echnologies Inc. 1915 W . Saunders Street Mt. Pleasant, Iowa 52641 www .heatilator .com Please contact your Heatilator dealer with any questions or concerns. For the number of your nearest Heatilator dealer , please call 1-800-927-6841.
An important point after buying a device Heatilator SILH30E-B (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Heatilator SILH30E-B yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Heatilator SILH30E-B - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Heatilator SILH30E-B you will learn all the available features of the product, as well as information on its operation. The information that you get Heatilator SILH30E-B will certainly help you make a decision on the purchase.
If you already are a holder of Heatilator SILH30E-B, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Heatilator SILH30E-B.
However, one of the most important roles played by the user manual is to help in solving problems with Heatilator SILH30E-B. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Heatilator SILH30E-B along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
