Instruction/ maintenance manual of the product H200 Hampton Direct
Go to page of 32
FPI FIREPLACE PRODUCTS INTERNA TIONAL L TD. 6988 V enture St., Delta, BC Canada, V4G 1H4 918-427 MODEL: H200 Freestanding W oodstove 05/25/06 Installer : Please complete the details on the back cover and leave this manual with the homeowner . Homeowner: Please keep these instructions for future reference.
Hampton H200 Cast Freestanding Woodstove 2 Thank-you for purchasing a HAMPTON FIREPLACE PRODUCT . The pride of workmanship that goes into each of our products will give you years of trouble-free enjoyment. Should you have any questions about your product that are not covered in this manual, please contact the HAMPT ON DEALER in your area.
Hampton H200 Cast Freestanding Woodstove 3 T ABLE OF CONTENTS SAFETY LABEL Safety Label for H200 .................................................... 4 INST ALLA TION Unit Dimensions ............................................................ 5 Pre-installation Assembly .
Hampton H200 Cast Freestanding Woodstove 4 This is a copy of the label that accompanies each Hampton H200 Freestanding Woodstove. We have printed a copy of the contents here for your review . SAFETY LABEL NOTE: Hampton units are constantly being improved.
Hampton H200 Cast Freestanding Woodstove 5 INST ALLA TION UNIT DIMENSIONS.
Hampton H200 Cast Freestanding Woodstove 6 INST ALLA TION PRE-INST ALLA TION ASSEMBL Y After removing the stove from its packing, open the front door and remove the contents from the fi rebox, leaving the bricks in place. Rotating Elbow This stove can be connected to either a top or rear vent exit by simply reversing the orientation of the elbow .
Hampton H200 Cast Freestanding Woodstove 7 INST ALLA TION RESIDENTIAL INST ALLA TION 1) Please read this entire manual before you install and use your new woodstove. Failure to follow instructions may result in property damage, bodily injury or even death.
Hampton H200 Cast Freestanding Woodstove 8 INST ALLA TION Residential Installation “C” V ent (Single W all) Unit (with Heat Shield) From Unit From From Flue Center-Line Corner A B C D E F H200 17&.
Hampton H200 Cast Freestanding Woodstove 9 MINIMUM ALCOVE CLEARANCE TO COMBUSTIBLE MA TERIALS This Hampton Freestanding model has been alcove approved and must be installed with a listed double wall connector to the ceiling level.
Hampton H200 Cast Freestanding Woodstove 10 FLOOR PROTECTION A combustible fl oor must be protected by non-combustible material (like tile, concrete board, or certifi ed to UL-1618 or as defi ned b.
Hampton H200 Cast Freestanding Woodstove 11 Horizontal Installation Standard Ceiling Installation INST ALLA TION Note: Increasing the chimney height above this minimum level will sometimes help your unit to “breathe” better by allowing a greater draft to be cre- ated.
Hampton H200 Cast Freestanding Woodstove 12 MASONR Y FIREPLACE There are listed kits available to connect a stove to a masonry fi replace. The kit is an adapter that is installed at the location of the fi replace damper . The existing damper may have to be removed to allow installation.
Hampton H200 Cast Freestanding Woodstove 13 Method A : 12" (304.8 mm) Clearance to Combustible W all Member: Using a minimum thickness 3.5" (89 mm) brick and a 5/8" (15.9 mm) minimum wall thickness clay liner , construct a wall pass-through.
Hampton H200 Cast Freestanding Woodstove 14 INST ALLA TION RECOMMENDED HEIGHTS FOR WOODST OVE FLUE Simple rules on draft. See T able 1. 1) At sea level minimum height is 12' straight. 2) Add the following vertical height to compen- sate for: 45 deg.
Hampton H200 Cast Freestanding Woodstove 15 MOBILE HOME INST ALLA TION Once you have properly marked the position of your unit and the fl oor protection as outlined in the Residential Installation items #1 through #8, a supply of fresh air has to be supplied to your unit.
Hampton H200 Cast Freestanding Woodstove 16 AMERI-TECHS Qty .Part # Description 1 6DCC Connector 1 6HSRS-12 Roof Support (6PLRS-12-BK) 1 6F Flashing 1 6HS-36 Chimney Length 1 6HS-18 Chimney Length 1 6HS-RCS Rain Cap (6PL-MPC) SIMPSON DURA-PLUS Qty .Part # Description 1 6DVL8693 Connector Kit 1 6DP-MH9096 Mobile Home Kit SIMPSON DURA-PLUS HTC Qty .
Hampton H200 Cast Freestanding Woodstove 17 DOOR REMOV AL INST ALLA TION BRICK INST ALLA TION Firebrick is included to extend the life of your stove and to radiate heat more evenly . Check to see that all fi rebricks are in their correct positions and have not become misaligned during shipping.
Hampton H200 Cast Freestanding Woodstove 18 CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation.
Hampton H200 Cast Freestanding Woodstove 19 1) Secure 2 Support Gussets to each Side Shelf using 2 screws per gusset. 2) Secure the Brackets to the middle of the Side Shelves using 2 screws and washers. 4) Mount side shelf to stove and secure in place using the allen key provided to secure the 2 set screws.
Hampton H200 Cast Freestanding Woodstove 20 OPERA TING INSTRUCTIONS 13) All fuel burning appliances consume oxygen during operation. It is important that you supply a source of fresh air to your unit while burning. A slightly opened window is suffi cient for the purpose.
Hampton H200 Cast Freestanding Woodstove 21 SAFETY GUIDELINES AND W ARNINGS 1) Never use gasoline, gasoline type lantern fuels, kerosene, charcoal lighter fuel, or similar liquids to start or ‘freshen up’ a fi re in your heater . Keep all such liquids well away from the heater while it is in use.
Hampton H200 Cast Freestanding Woodstove 22 1) Remove the andirons and bricks from within the fi rebox. Andiron 2) Remove bottom tray by undoing the 4 bolts.
Hampton H200 Cast Freestanding Woodstove 23 OPERA TING INSTRUCTIONS ASH DISPOSAL During constant use, ashes should be removed every few days. The Ash Drawer features a convenient ash drawer for easy removal of ashes. Safety Precautions 1) Do not allow ashes to build up to the loading doors! Only remove ashes when the fi re has died down.
Hampton H200 Cast Freestanding Woodstove 24 GLASS INST ALLA TION/ REPLACEMENT 1) Remove door from unit. 2) T o replace the glass remove the 12 screws highlighted in the diagram below . 3) Lift off the glass retainer and carefully re- move glass. 4) Place new glass in the door , make sure that the glass gasketing will properly seal your unit.
Hampton H200 Cast Freestanding Woodstove 25 If position of bracketry needs to be changed after adjustment: The bracketry should start from the highest point, as seen below . If needed, bring the bracketry down 1/16" each time, until fi nding the best locking position.
Hampton H200 Cast Freestanding Woodstove 26 H200 MAIN ASSEMBL Y P ARTS LIST P ART # DESCRIPTION 1) 200-301 TOP CHARCOAL GREY 200-305 TOP TIMBERLINE BROWN 2) 200-522 FIREBOX TOP ASSEMBL Y 3) 200-514 BA.
Hampton H200 Cast Freestanding Woodstove 27 P ARTS LIST 1 2 36 4 5 7 6 8 9 11 12 13 14 17 15 16 18 19 21 22 23 24 25 26 27 28 29 30 31 32 33 34 10 20 35 3 37 38.
Hampton H200 Cast Freestanding Woodstove 28 H200 DOOR ASSEMBL Y P ARTS LIST P ART# DESCRIPTION 1 2 3 7 8 9 10 11 12 13 14 1) 200-218F GLASS RETENTION TOP 2) 200-219F GLASS RETENTION SIDE (x2) 3) 200-2.
Hampton H200 Cast Freestanding Woodstove 29 P ARTS LIST H200 ASH DRA WER ASSEMBL Y P ART# DESCRIPTION 200-911 ASH DRAWER PACKAGE 1) 942-110 ASH PLUG 2) 936-236 1/2" ROPE GASKET 3) 200-232 ASH DRA.
Hampton H200 Cast Freestanding Woodstove 30 P ARTS LIST RED --- LOW WHITE --- COMMON CONNECTION DIAGRAM BLACK --- HIGH 115V. 60HZ. 1.1A J250-150-O44003 T.
Hampton H200 Cast Freestanding Woodstove 31 W ARRANTY Hampton Fireplace Products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance T eam carefully inspects each unit thoroughly before it leaves our facility .
Installer: Please complete the following information Dealer Name & Address: ______________________________________________ ___________________________________________________________________ Insta.
An important point after buying a device Hampton Direct H200 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hampton Direct H200 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hampton Direct H200 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hampton Direct H200 you will learn all the available features of the product, as well as information on its operation. The information that you get Hampton Direct H200 will certainly help you make a decision on the purchase.
If you already are a holder of Hampton Direct H200, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hampton Direct H200.
However, one of the most important roles played by the user manual is to help in solving problems with Hampton Direct H200. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hampton Direct H200 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
