Instruction/ maintenance manual of the product ECS8P2 Gorenje
Go to page of 20
Glass-ceramic built-in coking hob MT IE GB Instructions for use, installation, and connection.
406342 Glass-ceramic hob is intended for use in households. Our products are packed in environment-friendly materials which can be recycled, disposed of, or destroyed without imposing any burden on the environment. Instructions for use are intended for the user .
406342 • Installation of the appliance into a kitchen worktop and its connection to the power mains and the gas supply may only be performed by an adequately quali fi ed technician. • Do not leave small children unattended when the appliance is in operation.
6 406342 1. Cooking zone rear left 2. Cooking zone front left 3. Cooking hob control unit 4. Cooking zone front right 5. Cooking zone rear right 6. W arming zone 4 Appliance description.
406342 Settings sensor keys: A Hob on/off key B Lock signal light C Lock key D cooking zone selection key E Power level/residual heat displays F Settings slider G Minute minder of power off timer key .
406342 Clean the glass-ceramic surface with a damp cloth and some manual dishwashing detergent. Do not use aggressive detergents such as abrasive cleaners that can scratch the surface, abrasive dishwashing sponges, or stain removers.
406342 Tips on using the cookware Use high-quality cookware with a fl at and stable bottom. • T ransmission of heat is best when the pan bottom and the cooking zone are of the same diameter , and the pan is placed on the middle of the cooking zone.
406342 • The cooking hob is fi tted with electronic sensor keys which are activated, respectively , when the indicated surface of a particular sensor is touched with a fi nger for at least one second. • Activation of a sensor key is con fi rmed by a beep.
406342 • Select the cooking zone by pressing the relevant sensor key (D). The decimal point (H) next to the display for the selected cooking zone will light up. • Slide to the far left end of the slider (F) or touch that part of the slider to set the power level to 0.
406342 “h” will fl ash. This is to warn you that the cooking zone may still be hot, but not necessarily , depending on how long the power supply was out of order .
406342 Dish/cooking mode quantity power level cooking duration (min) Soup/reheating 0,5 – 1 lit A7 - 8 4 - 7 milk/reheating 0,2 – 0,4 lit A1 - 2 4 - 7 rice/simmering 125 – 250 g approx. 300ml - 600ml water A2 - 3 20 - 25 cooked jacket potatoes 750g – 1,5 kg approx.
406342 Power level u123456789 Maximum operation time in hours 666554 1 , 5 1 , 5 1 , 5 1 , 5 The cooking hob features two types of timer functions: A alarm function – countdown without the switch-off option B switch-off function – countdown with the switch-off option for respective cooking zones.
406342 • After the set time has expired, acoustic signal will be activated and the cooking zone will be switched off. »00« will fl ash on the clock display . Switch of the alarm by touching any key; alternatively , it will switch off automatically after a certain period of time.
406342 Deactivating the stay-warm zone • T ouch the (M) key for switching the stay-warm zone on/off. Signal light (N) will be switched off or it will fl ash to indicate that the stay-warm zone is still hot. • If all power levels are set to “00”, the cooking hob will be turned off automatically after 10 seconds.
406342 After each use of the glass-ceramic hob, wait for it to cool down and clean it; otherwise, even the smallest food residue will be burnt onto the hot surface next time you use the appliance.
406342 • Installation of the appliance into a kitchen worktop and its connection to the power mains may only be performed by an adequately quali fi ed technician.
*(…) – SVK7… - 750 mm **(...) – SVK8... - 850 mm 406342 • Cooking hobs can be installed into worktops that are 30 to 50 mm thick. • The kitchen furniture element underneath the hob should not be fi tted with a drawer .
406342 millimeters from the lower surface of the worktop. The space between the partition wall and the hob must be empty; no objects should be placed into that gap. • On the furniture back wall there should be a cutout with width of at least 175 mm along the entire width of the furniture element.
406342 ‘’ The appliances are suitable for photovoltaic electrical power under the condition that electrical voltage will be 220V AC - 240V AC with semi tonic frequency 50 Η z in order the appliance to operate properly (alternative a generator can be used with the same technical characteristic).
WE RESERVE THE RIGHT T O MAKE ANY CHANGES THA T DO NOT AFFECT THE FUNCTIONALITY OF THE APPLIANCE. SVK_SS en (09-12) Rating plate A Serial number B Code C Model D T ype E T rademark F T echnical inform.
An important point after buying a device Gorenje ECS8P2 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Gorenje ECS8P2 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Gorenje ECS8P2 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Gorenje ECS8P2 you will learn all the available features of the product, as well as information on its operation. The information that you get Gorenje ECS8P2 will certainly help you make a decision on the purchase.
If you already are a holder of Gorenje ECS8P2, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Gorenje ECS8P2.
However, one of the most important roles played by the user manual is to help in solving problems with Gorenje ECS8P2. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Gorenje ECS8P2 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center