Instruction/ maintenance manual of the product PN 906-2001-00 Garmin
Go to page of 9
TR-1 Gold Basic Operation Guide PN 906-2001-00 Version 061207.
Press and release Deckmount (on/off) button, usually found on stern of boat close to the out board. The deckmount light and standby LED on the hand held will both blink, the autopilot system is in a start-up mode and no operations are available for 30 seconds.
When the button is pressed the LED next to 9 will come on, the system will drop out of autopilot and put you in a starboard remote turn. To return to autopilot press and release the right straight arrow button. When the button is pressed the LED next to 6 will come on, the system will drop out of autopilot and put you in a port remote turn.
Press and hold to change feature options. Turn back light on or off LED’s Bright or Dim Step Turns to Port Circle Turns to Port Remote Turn to Port Step Turns to Starboard Circle Turns to Starboard Remote Turn to Starboard Man Over Board Idle/Resume Zig-Zag patterns GPS Reverse How to Select Feature Operations 1.
The following will lead through the following features step by step, Reverse, MOB, Idle/Resume, Zig- Zags, Step Turns, Circles and Remote Steer. Reverse: The Autopilot will attempt to perform any of it’s steering functions when the boat is backing in reverse gear.
System SETUP and Codes Push and release to access setup mode. Select code numbers 1, 2, or 3 Select code numbers 7, 8, or 9 Increase value of code settings Select code numbers 4, 5, or 6 Save setup ch.
Setup Action Code # Range of Settings or Responses Factory Default Setting Tach on/off 34 2 Settings: on or off on Show motor RPM 36 Hold Down Select Load Button: 1000’s blink on up arrow 100’s bl.
Compass Calibration, Autopilot Tuning and Setup 1) Calibrate your Compass. Compass calibration is a very important step and must be done. (North needs to be set also for GPS functions.) Find some smooth water where you can drive in circles without running into anything.
Compass Calibration Example of button sequence below; Autopilot in Standby 3) Press and hold the button, now press and release the Deckmount (on/off) button quickly, the Up Arrow LED will now come on now release button 2) Now press button the 4 LED will now be on.
An important point after buying a device Garmin PN 906-2001-00 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Garmin PN 906-2001-00 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Garmin PN 906-2001-00 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Garmin PN 906-2001-00 you will learn all the available features of the product, as well as information on its operation. The information that you get Garmin PN 906-2001-00 will certainly help you make a decision on the purchase.
If you already are a holder of Garmin PN 906-2001-00, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Garmin PN 906-2001-00.
However, one of the most important roles played by the user manual is to help in solving problems with Garmin PN 906-2001-00. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Garmin PN 906-2001-00 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
