Instruction/ maintenance manual of the product G5912 Fisher-Price
Go to page of 16
w w w . f i s h e r - p r i c e . c o m Please read these instructions before assembly and use of this product. Adult assembly is required . T ool needed for battery installation: Phillips Screwdriv er (not included). Requires four LR14 alkaline batteries f or operation (not included).
2 T o prevent serious injury or death fr om falls and being strangled in the restraint system: - Alwa ys use the restraint system. - Not recommended f or children who can sit up b y themselv es (6 months appro ximately , until 9 kg, 20 lbs). • Ne ver lea ve child unattended.
3 Parts 3 Link T oy s Seat Back T ube Pad Fr ont T ube Lower S wing Arm Assembly (with Restraint Sy stem) Fr ame 2 Fr ame T ubes Shown Actual Size #6 x 1.9 cm Screws - 4 NO TE: Tighten and loosen all screws with a Phillips screwdriv er . Do not over-tighten the screws .
4 Assembly • Rotate the upper frame tube until it "snaps" into an upright position, as shown. IMPORT ANT! Before assembly , inspect this produc t f or damaged hardware , loose joints, missing par ts or sharp edges. DO NOT use if an y parts are missing or broken.
5 Assembly • Pull the front tube t o be sure it is secure to each lo wer frame tube. • While pressing the buttons on the upper frame tubes , insert them into the holes in the underside of the frame. • Continue to insert the upper frame tubes into the frame until you hear a "click" on both sides.
6 Assembly • Check to be sure the upper frame tubes are secur e in the frame. If you can remov e the upper frame tubes from the frame, you ha ve not properly inserted the tubes into the frame. Remove the upper fr ame tubes from the frame and repeat Assembly step 4.
7 Assembly • Position the seat back tube so that it curves towar d the back of the swing. • While pressing the buttons on the seat back tube , fit the seat back tube into the short tubes on the swing arms. • Push the seat back tube until it “ clicks” into place .
10 8 Assembly • F rom behind the seat, inser t the waist belts into the slots in the pad. • Push to fast en the restraint system to the pad . Assembly is now complete . Slot Slot W aist Belts F astener • F it the top pocket on the pad over the seat back tube .
9 Battery Installation 1.5V x 4 LR14 SHOWN A CTU AL SIZE Hint: W e recommend using alk aline batteries for longer batter y life. • Locate the battery compartment door on the frame. • Loosen the screws in the battery compartment door . • Remove the battery compartment door and the batter y holder from the battery compar tment.
Battery Safety Information Batteries ma y leak fluids that can cause a chemical burn injury or ruin your product. T o av oid batter y leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
11 Set-Up & Use • Place your child in the seat. P osition the crotch belt between your child’ s legs. • F asten the waist belts to the crotch belt. Make sure y ou hear a “ click ” on both sides. • Check to be sure the restraint syst em is securely attached by pulling it away fr om your child .
12 Set-Up & Use Po wer Dial Po wer Dial Star ting the Swing • T urn the power dial to any of eight settings . • Give the seat a light push to start the swinging motion.
Baby A ctivat ed 13 Set-Up & Use Hint: Y our baby can enjoy lights and music with or without swinging . Par ent A ctivated • Slide the lights and music switch to: When baby pulls either toy on the ar ch, one tune plays along with twinkling lights.
14 • F it the link toys to either of the hanging t oys on the swing. Room-to-Room Portability Set-Up & Use • T o pre vent serious injur y or death from f alls and being strangled in the restraint system, alw a ys use the restraint system. • It is dangerous to use this product on an ele vated surf ace.
15 T ake Along • Lift the seat back and seat bottom together . • Tip the swing backwards with the seat back down. • Press both tabs on the fr ame at the same time to release the frame base.
Care • The frame , pad, liner and toys may be wiped clean using a mild cleaning solution and a damp cloth. Do not immerse the frame. • This product has no consumer serviceable par ts. Do not take this product apar t. IMPORT ANT! Never use this product without the provided pad .
An important point after buying a device Fisher-Price G5912 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Fisher-Price G5912 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Fisher-Price G5912 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Fisher-Price G5912 you will learn all the available features of the product, as well as information on its operation. The information that you get Fisher-Price G5912 will certainly help you make a decision on the purchase.
If you already are a holder of Fisher-Price G5912, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Fisher-Price G5912.
However, one of the most important roles played by the user manual is to help in solving problems with Fisher-Price G5912. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Fisher-Price G5912 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
