


Please read these instructions before use Veuillez lire ce Mode d’emploi avant utilisation
Favor de leer estas instrucciones antes del uso

















Product Profile This product is built to shred p a p e r, staples, small paper clips and credit cards. It is n o t built to take large paper clips, con- tinuous forms, adhesive labels, transparencies, newspaper, cardboard or any plastic other than credit cards. Using it for these purposes is likely to cause irreparable damage.

Strip-cut Confetti Cut OD1200 OD1200C Sheet capacity* 12 sheets 8 sheets Paper shred size 7/32" 5/32" x 1-3/8" (5.8 mm) (3.9 x 35 mm) Maximum paper width 9" (229 mm) Recommended daily capacity 25-50 shredding passes Maximum running time 10-12 minutes Automatic cool-down period 20 minutes Voltage (120 V / 60 Hz) 2.5A 5.0 A
*Based on 20 lb., 8-1/2" x 11" (70gsm, A4) paper with shredder operating at rated voltage; heavier paper, high humid- i t y, or other than rated voltage may reduce sheet capacity.
I M P O R TANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING
N OT E: Do not use flammable synthetic oil, petroleum-based prod- ucts or aerosols of any kind on or near product at any time.

Set-Up This shredder will only operate when used with the supplied basket. The supplied bas- ket has a built-in safety feature which prevents the shredder from operating if used with any other basket or if improperly assembled.
N OT E: To disassemble, pull out basket, hold cabinet down by placing foot on bottom shelf, and firmly pull up on shredder head. Operation For convenience, your shredder is equipped with an a u t o m a t i c -start sensor (4). This means that when the control switch (5) is in the automatic [I] position, the shredder will start running when paper is fed into it. The shredder stops a few seconds after the paper has passed through. Because the sensor cannot tell the difference between paper and other objects, this feature can be a hazard, especially to children and pets. To avoid accidents, turn off the shredder as soon as you are finished. Unplug shredder if it will not be used for an extended period.
In case of a paper jam, which may occur if the sheet capacity is exceeded or if paper is not put in straight, turn off and empty the basket if full. Then:
If you are unable to clear the jam using this method, turn off and unplug the shred- der; remove wastebasket from the cabinet and carefully remove any paper extending below the cutting cylinders; insert wastebasket and repeat jam clearing procedure.

Maintenance Regular emptying of the baske t is important to ensure the smooth operation of the cutting cylinders. If you can see paper in the basket window (7), turn off the shredder, pull out basket and empty basket contents.
Regular oiling of the confetti-cut model (OD1200C) is also necessary to ensure proper performance. If you are running the shredder at or near capacity, we recommend oiling it monthly. Using Fellowes Powershred Lubricant #35250 or other non-aerosol vegetable-based oil in a long-nozzle container:
R E M I N D E R : Do not use flammable synthetic oil, petroleum-based products or aerosol lubricants of any kind in or near the shredder at any time. Troubleshooting If you have a problem with your shredder, check the symptoms and remedies below. If you cannot solve the problem this way, contact Fellowes Customer Service. Do not open shredder head to attempt repair: It could expose you to serious electric shock and will void your warranty.
S y m p t o m Shredder does not start or stops while shredding.
Re m e d y • Make sure shredder is plugged in and switch is in automatic [I] position.
Red display light (9) turns on and shred- der will not operate.
Shredder squeaks, grinds or runs below capacity.
Shredder continues to run for a few sec- onds after paper has cleared the cutting cylinders.
No action required. This is a self-clean- ing function.

Customer Service Fellowes offers a toll-free help line for customers living in the United States, Canada, Mexico and Australia. If you live outside these regions or are otherwise unable to use our help line, please call the Fellowes location nearest you, send a letter or email, or contact your local dealer. All of our customer service phone numbers and other points of contact are listed on the back of this manual. Limited Warranty Fellowes, Inc. warrants the cutting cylinders of the machine to be free from defects in material and workmanship for 5 years from the date of purchase by the original con- sumer. Fellowes warrants all other parts of the machine to be free of defects in materi- al and workmanship for 1 year from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defec- tive part.
This warranty does not apply in cases of abuse, mishandling or unauthorised repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRI- ATE WARRANTY PERIOD SET FORTH ABOVE. IN NO EVENT SHALL FELLOWES BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES ATTRIBUTABLE TO THIS PRODUCT. This warranty gives you specific legal rights. You may have other legal rights that vary. The duration, terms and conditions of this warranty are valid worldwide, except where different limitations, restrictions or conditions may be required by local law.
For more details or to obtain service under this warranty, please contact us (see back cover) or your dealer.

United States + 1-800-955-0959
United Kingdom + 44-(0)-1302-836836


© 2003 Fellowes Printed in China. Form No. 400476
Owners and our team usually reply within a day — and your question helps the next person too.
Be the first to ask — other owners or our team will answer.