

Please read these instructions before use. Please read these instructions before use.

See safety instructions below
Feed into paper entry and release
Set to Off (0) and plug in
Set to Off (0)
Auto-On (I) Off (0) Power switch
Hold card/CD at edge
Feed into card/CD entry and release
Shredder doesn’t start:
Paper jam: Set to Off (0) and empty bin. Replace bin and follow any or all of the below procedures.
Yellow - SafeSense™ active
Yellow flashing - SafeSense™ not active
Breakthrough Safety Technology! SafeSense™ stops shredding when hands are too close to the opening.
Make sure bin is pushed in
— To Test SafeSense™ Technology
Press and hold Reverse ( )
Alternate slowly back and forth
Press and hold Reverse ( ) Set to Off (0)
Gently pull uncut paper from paper entry. Plug in.
Wait for motor to cool down
Press Auto-On (I) Touch test area Sensor lights up Insert waste bag (Fellowes #36052) for easy disposal.
Sensor light illuminated–paper jammed SafeSense™ paper jam: If the SafeSense™ feature activates (SafeSense™ light remains on) to cause the user to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense™ feature and clear the paper. Warning – when switch is in override position, the SafeSense™ light will flash and the SafeSense™ feature will NOT function. Once the paper is cleared, reset the SafeSense™ feature.
Will shred: Paper, credit cards, CD/DVDs, staples and small paper clips Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, large paper clips, laminates or plastic other than noted above Paper shred size: Confetti-Cut 5/64” x 5/16” (2 x 8mm) Card/CD shred size: Strip-Cut 5/16” (8mm)
Maximum: Sheets per pass (Confetti-Cut) 7* Cards/CDs per pass 1 Paper width 8.75”/220mm Card/CD width 5”/125mm Continuous operation 8-10 minutes *20lb., 8.5”x11” (75g) paper at 120v, 60 Hz, MS-450Cs–4.5Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 25-50 paper passes; 25 cards; 10 CDs.
Follow oiling procedure below and repeat twice.
Run regularly in reverse for one minute
Press forward *Apply oil across entry
Press and hold Reverse ( ) 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250/3505006
LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from defects in material and workmanship for 5 years from the date of purchase by the original consumer. Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1 year from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED
WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.
MS450Cs.401953.NA.022807.indd 3-4 2/28/07 9:40:15 AM
Owners and our team usually reply within a day — and your question helps the next person too.
Be the first to ask — other owners or our team will answer.