






® 63Cb


Please read these instructions before use. Do not discard: keep for future reference.

E.
A.

F. B.
G.
A. SafeSense® Technology B. Paper entry C. Pull-out Bin D. Window
E. Disconnect power switch 1. OFF 2. ON F. See safety instructions
G. Control Switch and Indicator lights 1. Reverse 2. OFF 3. Auto On (blue) 4. SafeSense® indicator (yellow) 5. Overheat (red) 6. Door open (red) 7. Remove Paper (red)

Maximum: Sheets per pass 10* Cards per pass 1* Paper entry width 9 in. (230mm)
Will not shred: Adhesive labels, CD/DVDs, continuous form paper, transparencies, newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than noted above
*8.5 in. x 11 in., 20lb., (75g) paper at 120V/60 Hz, 2.5Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 200 sheets; 5 credit cards. 10 sheets per pass.
Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
2 1 3 4
Plug in and put disconnect power switch in ON (I) position
Press Auto On ( ) to activate
Feed paper/card straight into paper entry and release
When finished shredding set to OFF ( )
www.fellowes.com features an extensive on-line support section with a number of self-service options

Energy Saving System Optimal energy efficiency 100% of the time – in use and out of use.
Jam BlockerTM Blocks jams before they start
Patented SafeSense® Technology Stops shredding immediately when hands touch the paper opening
If Remove Paper icon illuminates during the shredding process (due to paper misfeed or wrinkle) follow the procedures below.
If Remove Paper icon ( ) is illuminated, there is too much paper for the shredder to power through
Reduce paper quantity to an acceptable amount and refeed into paper entry
Shredder pauses for 3 seconds
Set to Reverse ( ) and remove paper
Set to Auto On ( ) and refeed into paper entry
ENERGY SAVING SYSTEM
Optimal energy efficiency 100% of the time – in use and out of use.
Stops shredding immediately when hands touch the paper opening.
1 3 4 2
Set to Auto On ( ) Touch test area and look for the SafeSense® indicator to illuminate
SafeSense® is active and working properly
If hand is held on SafeSense® area more than 3 seconds shredder will shut off
In sleep mode To get out of sleep mode set to OFF ( ), then Auto On ( )
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
OILING SHREDDER
All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.
*Apply oil across entry Set to OFF ( ) Set to Reverse ( ) for 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will .not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
Remove Paper: When illuminated, set to reverse ( ) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding. If SafeSense® is active for 3 seconds, the shredder will automatically turn off and the user must set the switch to OFF ( ), then Auto On ( ) to resume shredding.
or · Insert paper



® 63Cb

Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 1 year from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for 5 years from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on the label), or unauthorized repair. Fellowes reserves the right to charge the
consumers for any additional costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.
Customer Service & Support Troubleshooting Replacement parts General questions
©2012 Fellowes, Inc. Part No. 406868
Pages referenced in this manual — manufacturer, support and downloads.
Owners and our team usually reply within a day — and your question helps the next person too.
Be the first to ask — other owners or our team will answer.