Instruction/ maintenance manual of the product SP4 Faber
Go to page of 8
THESE INST RUCTIONS SHO ULD BE READ CAREFULLY AND RET AINED FOR FUT URE RE FERENCE. Dimensions (millimetres) Inst allation and Operating Instructions Electrical 08/18936/0 Issue 0 Fig.
Inst allation Recommended Fixing Dimensions - Fig. 2 Fig. 3 Fig. 4 Fig. 5 Mark the bottom hole position (see Fig. 5), remove the heater ensuring that the bottom fixing bracket is rotated up. Drill and fit wall plug. Refit the heater to the wall fixing bracket (i.
Manual Operation The S tandby Switch (Switch 1) must be first turned ‘ON’ and the AUTO/MAN (Switch 2) switch set to ‘MANUAL ’ to operate the manual controls - see Fig 6. Note : When the fire is put in Manual mode the first time the flame effect will come on indicated by the Bottom neon coming on for 3 seconds - see Fig 7.
Remote Control Operation LCD display The LCD display shows the following functions: • Main menu points: OFF , FLAME, HEA T , TEMP , TIMER, PROG , and TIME . • Brightness of the flame effect shown as a bar chart in 4 steps (50 steps internally). • Remote control set temperature in °C (thermostat function).
Replacing the remote control The new remote control must be set up as follows: Press switch 1 to ON . Press switch 2 to AUTO (see Fig. 6). Press switch 3 to O for more than 3 seconds until both LED’s are on (see Fig. 7). Press the remote control’s enter button or the e f buttons.
The front surround will need to be removed in order to change lamps. W arning - The front surround is heavy and easily damaged !. The front surround is fixed with 4 spring loaded pins and is supported at the top by the chassis.
T o refit the surround back to the chassis: 1. Refit the rotisserie making sure that the rubber grom- mets are carefully pushed back into the slotted holes on the axial brackets (see Fig 1 1). 2. Place the surround on the chassis bracket and align the pins with the spring slots.
After Sales Service Y our appliance is guaranteed for one year from the date of purchase. We undertake to rep air or exchange free of charge within this period, any part with the exception of a lamp found to be defective due to a manufacturing fault.
An important point after buying a device Faber SP4 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Faber SP4 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Faber SP4 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Faber SP4 you will learn all the available features of the product, as well as information on its operation. The information that you get Faber SP4 will certainly help you make a decision on the purchase.
If you already are a holder of Faber SP4, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Faber SP4.
However, one of the most important roles played by the user manual is to help in solving problems with Faber SP4. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Faber SP4 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
