Instruction/ maintenance manual of the product FAW-55IP Empire Products
Go to page of 20
Installer: Leave this manual with the appli- ance. Consumer: Retain this manual for futur e refer - ence. — Do not store or use gasoline or other flamma- ble vapors and liquids in the vicinity of this or any other appliance. — WHA T TO DO IF YOU SMELL GAS • Do not try to light any appliance.
12429-10-0408 Page 2 T ABLE OF CONTENTS INTRODUCTION .................................................................................................................. 3 SAFETY INFORMA TION FOR USERS OF LP-GAS .........................................
12429-10-0408 Page 3 Introduction Al w ay s c o ns u lt y o ur lo c al Bu i ld in g D e pa r tm en t r e ga r di n g regulations, codes or ordinances which apply to the installation of a vented wall furnace. Instructions to Installer 1. Installer must leave instruction manual with owner after installation.
12429-10-0408 Page 4 Some people cannot smell well. Some people cannot smell the odor of the chemical stench put into the gas. Y ou must find out if you can smell the odorant in pr opane. Smoking can decrease your ability to smell. Being around an odor for a time can affect your sensitivity or ability to detect that odor .
12429-10-0408 Page 5 V entilation and Combustion Air W all furnaces shall be installed in a location in which the facilities for ventilation permit satisfactory combustion of gas and proper venting under normal conditions.
12429-10-0408 Page 6 Figure 2 Figure 3 Figur e 3A VENT CENTER TO COMBUSTIBLES MINIMUM CLEARANCE 9/16” (40mm) 4”(102mm) OVAL TYPE “B” CONNECTION 7/1/2” (191mm) MINIMUM CLEARANCE TOP T O COMBU.
12429-10-0408 Page 7 Locating Furnace On W all The furnace is to be located on a wall. The furnace is 16 inches (406mm) in width and normal 16 inches (406mm) on center studs will not allow the furnace to be recessed into the wall unless a stud is repositioned.
12429-10-0408 Page 8 Figure 6 Electrode and pilot must be kept clean. Clean through pilot access hole with a small brush (toothbrush) and water . Proper Main Burner Flame The correct flame will be a short blue inner flame with a much larger light blue outer flame.
12429-10-0408 Page 9 V ent Safety Shutoff System This appliance must be properly connected to a venting system. This appliance is equipped with a vent safety shutoff system.
12429-10-0408 Page 10 FOR YOUR SAFETY READ BEFORE OPERA TING W ARNING: If you do not follow these instructions exactly , a fire or explosion may r esult causing property damage, personal injury or loss of life. A. This appliance is equipped with an ignition devi ce which automatically lights the pilot.
12429-10-0408 Page 1 1 CALL SER VICEMAN SER VICE AND MAINTENANCE SUGGESTIONS GENERAL: All furnaces have been fire-tested to check for proper operation. This includes, main burner flame, pilot flame, fan operation, fan control, limit control and automatic valve operation.
12429-10-0408 Page 12 If the pilot does not light, or the pilot flame current is not at least 1.0 uA and steady , the module will not energize the second main valve and the main burner will not light. Safety Lockout S8600H provides 100 percent shutoff, or safety lockout.
12429-10-0408 Page 13 Important 1. The following service procedures are provided as a general guide. 2. Meter readings between gas control and ignition module must be taken within the trial for ignition period. Once the ignition module locks out, the system must be reset by setting the thermostat down for at least one minute before continuing.
12429-10-0408 Page 14 S8600H TROUBLESHOOTING GUIDE.
Gr een LED Status Codes Green LED Flash Code (X + Y) a Indicates Next System Action Recommended Service Action OFF No “Call for Heat” Not applicable None Flash Fast Startup-Flame sense calibration Not applicable None Heart Beat Normal operation Not applicable None 3 Recycle - Flame failed during run Initiate new trial for ignition.
12429-10-0408 Page 16 PLEASE NOTE: When ordering parts, it is very important that part number and description of part coincide. 1 WF A-115 Baseplate Gasket 2 1 1763 Outer Casing T op 3 632024 Motor Mo.
12429-10-0408 Page 17 Empire Comfort Systems, Inc. Nine Eighteen Freeburg A ve. Belleville, Illinois 62222-0529 P AR TS VIEW.
12429-10-0408 Page 18 Model No. F A W -55 may be vented as shown. The vent cap must be at least 12 feet (3.7m) above the floor . Clearance to combustible construction is held by the fixed spacers at 1 inch (25mm) with B-1 vent pipe. Installation must conform to local codes.
12429-10-0408 Page 19 SER VICE NOTES.
12429-10-0408 Page 20 EMPIRE EMPIRE Comfo r t Systems Empire Comfort Systems Inc. 918 Freeburg A ve. Belleville, IL 62220 If you have a general question about our products, please e-mail us at info@empirecomfort.com. If you have a service or repair question, please contact your dealer .
An important point after buying a device Empire Products FAW-55IP (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Empire Products FAW-55IP yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Empire Products FAW-55IP - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Empire Products FAW-55IP you will learn all the available features of the product, as well as information on its operation. The information that you get Empire Products FAW-55IP will certainly help you make a decision on the purchase.
If you already are a holder of Empire Products FAW-55IP, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Empire Products FAW-55IP.
However, one of the most important roles played by the user manual is to help in solving problems with Empire Products FAW-55IP. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Empire Products FAW-55IP along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
