Instruction/ maintenance manual of the product VFP36SP32EN-2 Empire Comfort Systems
Go to page of 40
INST ALLA TION INSTRUCTIONS AND OWNER'S MANUAL SEE-THROUGH FIREPLACE MODELS: VFP36SP32EN-2 VFP36SP32EP-2 PENINSULA FIREPLACE MODELS: VFP36PP32EN-2 VFP36PP32EP-2 U.
26670-0-01 10 Page 2 T ABLE OF CONTENTS Carton Contents ...................................................................................................................... 3 Hardware Package .........................................................
26670-0-01 10 Page 3 CAR T ON CONTENTS Fireplace Assembly Lava Rock Package Soot W arning Sheet Installation Package Rockwool Packet Installation Instructions Serial Number T ag W arranty Card .
26670-0-01 10 Page 4 When used without adequate combustion and ventilation air, heater may give off CARBON MONOXIDE, an odorless, poi - so no us ga s. Do not install heater until all necessary provisions are made for combustion and ventilation air .
26670-0-01 10 Page 5 Some people cannot smell well. Some people cannot smell the can smell the odorant in propane.
26670-0-01 10 Page 6 Installation on Rugs and T ile If this appliance is installed directly on carpeting, tile or other combustible material other than wood ooring the appliance shall be installed on a metal or wood panel extending the full width and depth of the appliance.
26670-0-01 10 Page 7 Model VFP36(SP ,PP)32EN (NA T) VFP36(SP ,PP)32EP (LP) Input Maximum 38,000 38,000 Minimum 25,000 30,000 Overall Dimensions Height without standoff 37 3/4" 37 3/4" W idth.
26670-0-01 10 Page 8 W ater vapor is a by-product of gas combustion. An unvented room heater produces approximately one (1) ounce (30ml) of water for every 1,000 BTU's (.3KW's) of gas input per hour . Unvented room heaters are recommended as supplemental heat (a room) rather than a primary heat source (an entire house).
26670-0-01 10 Page 9 The space in the above example is a conned space because the actual BTU/Hr used is more than the maximum BTU/HR the space can support. Y ou must provide additional fresh air . Y our options are as follows: A. Rework worksheet, adding the space of an adjoining room.
26670-0-01 10 Page 10 Check all local codes for requirements, especially for the size and type of gas supply line required. Note: Never use plastic pipe.
26670-0-01 10 Page 1 1 CLEARANCES Figure 4a - See Through Fir eplace Clearances 36” MIN. 42” MIN. (CEILING TO TO P O F H OOD) 1 3/4 ” M IN. PERPENDICULAR COMBUSTIBLE SIDEWALL 36” MIN.
26670-0-01 10 Page 12 Figure 6a - Mantel Clearances with Standard Hood Figure 6b - Mantel Clearances with Optional Extended Hood MANTEL ST ANDARD HOOD 17 ½” 10” 12” MAX 42” MIN. (CEILING TO TO PO F HOOD) 4 ½ ” MIN.
26670-0-01 10 Page 13 Fireplace Framing Framing can be built before or after the replace is set in place. Framing should be constructed to accommodate wall covering and replace facing material. The replace framing should be constructed of 2 x 4 lumber or heavier .
26670-0-01 10 Page 14 Fireplace Dimensions .
26670-0-01 10 Page 15 Locating Fireplace Place replace in framed opening. Attach the framing brackets to the replace and secure to framing. Different hole locations can be used for nishing materials with thicknesses of 3/8", 1/2" and 3/4".
26670-0-01 10 Page 16 Extended Hoods If your non-combustible facing material is over 1" in thickness and will be used to nish this replace, extended hoods are available that will extend out 2" farther into the room. Extended hoods are not available for the peninsula open ends.
26670-0-01 10 Page 17 The replace is designed to accept a gas line for connection to the gas valve. Have the line installed by a qualied service person in accordance with all building codes. Consult local building codes to properly size the gas supply line leading to the connection of the valve.
26670-0-01 10 Page 18 Place ment of the glowing embers (rockwoo l) is very indiv idual and light coverage of the areas indicated will provide your best effects. W e recommend separation of the rockwool by hand and to make your coverage as light and uffy as possible.
26670-0-01 10 Page 19 Before you begin: Do not handle the logs with your bare hands! Always wear gloves to prevent skin irritation. After handling logs, wash your hands gently with soap and water . All Logs The positioning of the logs is critical to the safe and clean opera- tion of this heater .
26670-0-01 10 Page 20 1. ST OP! Read the safety information label. 2. Open bottom louver assembly . 3. Set REMOTE/OFF/ON switch to "OFF ." 4. T urn off all electric power to the appliance (if applicable). 5. Push in gas control knob slightly and turn clockwise to "OFF .
26670-0-01 10 Page 21 Check the following items during installation prior to lighting the multisided burner: • Check all carryover ports for blockage from the ceramic media o If there is blockage, use a small pointed tool to move the ceramic media away from the carryover port.
26670-0-01 10 Page 22 Figure 16 show a correct pilot ame pattern. The correct ame will be blue and will extend beyond the thermocouple. The ame will surround the thermocouple just below the tip. A slight yellow ame may occur where the pilot ame and main burner ame meet.
26670-0-01 10 Page 23 Label all wires prior to disconnection when servicing controls. W iring errors can cause improper and dangerous operation. V erify proper operation after servicing. Milli volt thermopi le is self powere d, gas valve does not requir e 1 10 volts.
26670-0-01 10 Page 24 .
26670-0-01 10 Page 25 .
26670-0-01 10 Page 26 Attention: Install blower assembly before connecting gas in- let supply line. Wiring The appliance, when installed, must be electrically grounded in accordance with local codes or , in the absence of local codes, with the National Electrical Code, ANSI/NFP A 70 , if an exter- nal electrical source is utilized.
26670-0-01 10 Page 27 4. Insert blower assembly into interior , bottom of rebox. Note: On peninsula models, the blower must be installed at the end which has the brick panel installed.
26670-0-01 10 Page 28 Wiring The appliance, when installed, must be electrically grounded in accor dance with loca l co des o r , i n th e abs ence of lo cal c odes, with the National Electrical Code, ANSI/NFP A 70 , if an external electrical source is utilized.
26670-0-01 10 Page 29 MAINTENANCE Keep the control compartment, logs and burner area surround- ing the logs clean by vacuuming or brushing area at least twice a year . THE LOGS CAN GET VER Y HOT - HANDLE ONL Y WHEN COOL. Always turn off gas to the pilot before cleaning.
26670-0-01 10 Page 30 USE ONL Y MANUF ACTURER'S REPLACEMENT P AR TS. USE OF ANY OTHER P AR TS COULD CAUSE INJUR Y OR DEA TH. NOTE: SEE LOG INSTRUCTION MANUAL FOR DET AILS ON LOGS AND EMBERS A TTENTION: When ordering parts, it is very important that part number and description of part coincide.
26670-0-01 10 Page 31 Parts can be ordered only through your service person or dealer . For best results, the service person or dealer should order parts through the distributor . Parts can be shipped directly to the service person/dealer . All parts listed in the Parts List have a Part Number .
26670-0-01 10 Page 32 SEE-THROUGH FIREPLACE P AR TS VIEW 1 4 6 5 16 8 9 12 14 4 5 6 8 12 14 9 7 3 2 24 25 20 17 18 31 41 40 21 23 29 33 30 19 22 34 28 26 Nat Gas 36 37 35 27 42 32 38 39 24 25 43 44 45 46 47 44 21 NA T.
26670-0-01 10 Page 33 PENINSULA FIREPLACE P AR TS VIEW 1 4 5 6 8 9 11 10 12 13 14 15 16 8 12 14 9 7 3 2 24 25 20 17 18 31 41 40 21 23 29 33 30 19 22 34 28 26 Nat Gas 36 37 35 27 42 32 38 39 24 LP BURNER 25 43 44 45 46 47 44 21 NA T.
26670-0-01 10 Page 34 Accessory Description Model Numbers 1 2 Designed to provide forced air ow . FBB5 .
26670-0-01 10 Page 35 Accessory Description Model Numbers Optional light kit that installs in top of rebox to enhance logset. Operates with a Rheostat control to vary brightness of light for desired effect.
26670-0-01 10 Page 36 SER VICE NOTES.
26670-0-01 10 Page 37 Web Site: www .empirecomfort.com Premium V ent-Free Fireplaces SEE-THROUGH FIREPLACE MODELS: VFP36SP32EN-2 VFP36SP32EP-2 PENINSULA FIREPLACE MODELS: VFP36PP32EN-2 VFP36PP32EP-2 E.
26670-0-01 10 Page 38 Web Site: www .empirecomfort.com Premium V ent-Free Fireplaces SEE-THROUGH FIREPLACE MODELS: PENINSULA FIREPLACE MODELS: VFP36SP32EN-2 VFP36PP32EN-2 VFP36SP32EP-2 VFP36PP32EP-2 E.
26670-0-01 10 Page 39 Premium V ent-Free Fireplace Framing Dimensions (inches) "A" "B" "C"* Model Framing Height Framing Width Framing Depth VFP36SP 41 1/2" 40".
26670-0-01 10 Page 40 EMPIRE EMPIRE C o mfo r t Systems Empire Comfort Systems Inc. 918 Freeburg A ve. Belleville, IL 62220 If you have a general question about our products, please e-mail us at info@empirecomfort.com. If you have a service or repair question, please contact your dealer .
An important point after buying a device Empire Comfort Systems VFP36SP32EN-2 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Empire Comfort Systems VFP36SP32EN-2 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Empire Comfort Systems VFP36SP32EN-2 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Empire Comfort Systems VFP36SP32EN-2 you will learn all the available features of the product, as well as information on its operation. The information that you get Empire Comfort Systems VFP36SP32EN-2 will certainly help you make a decision on the purchase.
If you already are a holder of Empire Comfort Systems VFP36SP32EN-2, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Empire Comfort Systems VFP36SP32EN-2.
However, one of the most important roles played by the user manual is to help in solving problems with Empire Comfort Systems VFP36SP32EN-2. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Empire Comfort Systems VFP36SP32EN-2 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
