Instruction/ maintenance manual of the product DV-25-2SG Empire Comfort Systems
Go to page of 20
12434-8-0806 Page 1 DIRECT VENT W ALL FURNACE MODELS DV -25-2SG DV -35-2SG EFFECTIVE DA TE AUGUST 2006 W A R N I N G : I f n o t i n s t a l l e d , o p e r a t e d a n d maintained in accordance with.
12434-8-0806 Page 2 SECTION P AGE Important Safety Information ......................................................................................................................3 Safety Information for Users of LP Gas .............................
12434-8-0806 Page 3 • Due to high temperatures the appliance should be located out of traffic and away from furnitur e and draperies. • Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition.
12434-8-0806 Page 4 Some people cannot smell well. Some people cannot smell the odor of the chemical put into the gas. Y ou must find out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can affect your sensitivity or ability to detect that odor .
12434-8-0806 Page 5 REQUIREMENTS FOR MASSACHUSETTS For all side wall horizontally vented gas fueled equipment installed in every dwelling, building or structure used in whole or in part for residentia.
12434-8-0806 Page 6 Introduction Al w a ys c o ns u lt y o ur l oc a l B u i ld i ng D e pa r tm e n t r e ga r d in g regulations, codes or ordinances which apply to the installation of a direct vent wall furnace. Instructions to Installer 1. Installer must leave instruction manual with owner after installation.
12434-8-0806 Page 7 Locating Gas Supply The gas line can enter the unit either through the floor or outside wall. The gas line opening should be made at this time. Location of the opening will be determined by the position of floor joists and the valve and union used for servicing.
12434-8-0806 Page 8 DV -25-2 SHOWN UNIT IS SUPPORTED BY WALL BRACKET 4 ½”(1 14mm)MIN. WALL DV -25, DV -35 13” (330mm) MAX. WALL DV -25, DV -35 MOUNTING PLA TE (CAULK UNDER FLANGE) VENT CAP FLUE O.
12434-8-0806 Page 9 On solid wall, when using wall stu ds for attac hmen t of wall mountin g bracket, fasten wall mounting bracket to wall studs with (2) #10 x 1 1/2" (38mm) screws provided and fasten (2) additional #10 x 1 1/2" (38mm) screws provided through the wall mounting bracket and into the solid wall.
12434-8-0806 Page 10 cap extension should not exceed a total depth of 13" (330mm) for DV -25 and DV -35. (See Figure 5a) W arning: When vinyl siding vent kit, DV -822 or 2" x 4" (51mm x.
12434-8-0806 Page 1 1 FOR YOUR SAFETY READ BEFORE LIGHTING W ARNING: If you do not follow these instructions exactly , a fire or explosion may result caus- ing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand.
12434-8-0806 Page 12 The correct flame will be almost horizontal, blue and will extend past the thermopile 1/4" (6mm). The flame will surround the thermopile just below the tip. On propane (LP-gas) slight yellow might occur where the pilot flame and burner flame meet.
12434-8-0806 Page 13 1. Lit match goes out as it enters lighter port. a. Certain wind conditions will blow out match. Ignite match, and as it flares, thrust match through opening. b. Open nearby door or window and relight pilot. 2. Pilot flames but goes out when knob is released.
12434-8-0806 Page 14 PLEASE NOTE: When ordering parts, it is very important that part number and description of part coincide. Index Part No. Number Description USE ONL Y MANUF ACTURER'S REPLACEMENT P AR TS. USE OF ANY OTHER P AR TS COULD CAUSE INJUR Y OR DEA TH.
12434-8-0806 Page 15.
12434-8-0806 Page 16 OPTIONAL BLOWER DRB-1 V ented Room Heaters RH-25-(1, 2, 4, 5, 6) and RH-35-(1, 2, 4, 5, 6) Direct V ent W all Furnaces DV -25-(1, 2)SG and DV -35-(1, 2)SG Installing Optional DRB-1 Blower 1. For RH-25-(1, 2, 4, 5, 6) and RH-35-(1, 2, 4, 5, 6), remove casing front.
12434-8-0806 Page 17 Cleaning The blower wheel will collect lint and could require cleaning once a year . If the air output decreases or the noise level increases, it indicates a dirty wheel. Complete removal of the wheel and scrubbing it with a brush under flowing water is recommended.
12434-8-0806 Page 18 SER VICE NOTES.
12434-8-0806 Page 19 SER VICE NOTES.
12434-8-0806 Page 20.
An important point after buying a device Empire Comfort Systems DV-25-2SG (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Empire Comfort Systems DV-25-2SG yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Empire Comfort Systems DV-25-2SG - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Empire Comfort Systems DV-25-2SG you will learn all the available features of the product, as well as information on its operation. The information that you get Empire Comfort Systems DV-25-2SG will certainly help you make a decision on the purchase.
If you already are a holder of Empire Comfort Systems DV-25-2SG, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Empire Comfort Systems DV-25-2SG.
However, one of the most important roles played by the user manual is to help in solving problems with Empire Comfort Systems DV-25-2SG. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Empire Comfort Systems DV-25-2SG along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
