Instruction/ maintenance manual of the product DV-210-7SG Empire Comfort Systems
Go to page of 20
12433-7-0107 Page 1 DIRECT VENT W ALL FURNACE MODELS DV -210-7SG DV -215-7SG EFFECTIVE DA TE JANUAR Y 2007 This appliance may be installed in an after - market, permanently located, manufactured home (USA only), or mobile home, wher e not prohibited by state or local codes.
12433-7-0107 Page 2 SECTION P AGE Important Safety Information ......................................................................................................................3 Safety Information for Users of LP Gas .............................
12433-7-0107 Page 3 • Due to high temperatures the appliance should be located out of traffic and away from furnitur e and draperies. • Childr en and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition.
12433-7-0107 Page 4 Some people cannot smell well. Some people cannot smell the odor of the chemical put into the gas. Y ou must find out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can af fect your sensitivity or ability to detect that odor .
12433-7-0107 Page 5 REQUIREMENTS FOR MASSACHUSETTS For all side wall horizontally vented gas fueled equipment installed in every dwelling, building or structure used in whole or in part for residentia.
12433-7-0107 Page 6 Introduction Al w ay s co n su lt y ou r l oc al B u il di ng D ep ar t me nt r eg ar d in g regulations, codes or ordinances which apply to the installation of a direct vent wall furnace. Instructions to Installer 1. Installer must leave instruction manual with owner after installation.
12433-7-0107 Page 7 Locating Gas Supply The gas line can enter the unit either through the floor or outside wall. The gas line opening should be made at this time. Location of the opening will be determined by the position of floor joists and the valve and union used for servicing.
12433-7-0107 Page 8 The vent terminal of a direct vent appliance, with an input of 10,000 Btu per hour (3 kW) or less shall be located at least 6" (150mm) from any air opening into a building, and such an appliance with an input over 10,000 Btu per hour (3 kW) but not over 50,000 Btu per hour (14.
12433-7-0107 Page 9 3" (76mm) diameter flue outlet tube. Attach vent cap to outside wall plate with (3) #10 x 1/2" (13mm) screws provided. 5 . Reassembly and resealing vent-air intake system is completed. Ins tal lin g a V ent Near a Wind ow Ledge , Oth er T ype of Proj ection or on Siding (vinyl, aluminum, etc.
12433-7-0107 Page 10 These heating thermostats are specially designed for use on self- generating systems. They should never be used on line or low voltage A.
12433-7-0107 Page 1 1 1. STOP! Read the safety information above. 2. Set the thermostat to lowest setting. 3. T urn off all electric power to the appliance (if appli - cable). 4. Remove control access panel (front panel). 5. Push in gas control knob slightly and turn clockwise to "OFF".
12433-7-0107 Page 12 On the main burner , the burning gas forms a primary flame and a secondary flame. The primary flame is blue and about 3/16" (5mm) high. The secondary flame is very pale blue, 3 inches (76mm) to 5 inches (127mm) high. Dust in the combustion air will produce an orange flame.
12433-7-0107 Page 13 1. Lit match goes out as it enters lighter port. a. Certain wind conditions will blow out match. Ignite match, and as it flares, thrust match through opening. b. Open nearby door or window and relight pilot. 2. Pilot flames but goes out when knob is released.
12433-7-0107 Page 14 Parts can be ordered only through your service person or dealer . For best results, the service person or dealer should order parts through the distributor . Parts can be shipped directly to the service person/dealer . All parts listed in the Parts List have a Part Number .
12433-7-0107 Page 15 P AR TS VIEW.
12433-7-0107 Page 16 DVB-1 For Direct V ent W all Furnaces DV -210-(7, 9)SG and DV -215-(7, 9)SG BLOWER MOUNTING T A B Cleaning the Blower Wheel In some areas, such as near bedrooms and on floors with a hard surface, the blower wheel will be filled with lint very quickly .
12433-7-0107 Page 17 SER VICE NOTES.
12433-7-0107 Page 18 SER VICE NOTES.
12433-7-0107 Page 19 SER VICE NOTES.
12433-7-0107 Page 20 Empire Comfort Systems, Inc. 918 Freeburg A ve. Belleville, IL 62220 PH: 618-233-7420 or 800-851-3153 F AX: 618-233-7097 or 800-443-8648 info@empirecomfort.
An important point after buying a device Empire Comfort Systems DV-210-7SG (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Empire Comfort Systems DV-210-7SG yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Empire Comfort Systems DV-210-7SG - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Empire Comfort Systems DV-210-7SG you will learn all the available features of the product, as well as information on its operation. The information that you get Empire Comfort Systems DV-210-7SG will certainly help you make a decision on the purchase.
If you already are a holder of Empire Comfort Systems DV-210-7SG, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Empire Comfort Systems DV-210-7SG.
However, one of the most important roles played by the user manual is to help in solving problems with Empire Comfort Systems DV-210-7SG. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Empire Comfort Systems DV-210-7SG along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center