Instruction/ maintenance manual of the product 9630 LP EchoStar
Go to page of 24
AutoScan Satellite System 9630 9630-LP Inst allation and Operating Instructions 1 1200 Hampshire Avenue South, Bloomington, MN 55438-2453 Phone: (800) 982-9920 Fax: (952) 922-8424 www .
.
Page 1 IMPORT ANT! The satellite TV market is exp anding and changing. The information in this manual was accurate at the time of printing. If your King-Dome does not operate as outlined in this manual please call King Controls at ( 800) 982-9920 or visit our website at www .
Page 2 The King-Dome AutoScan Satellite System includes 2 main components ( Fig. 1) . Dome (Antenna) Unit Located on the roof of the vehicle. The dish is covered by a protective dome that keeps operational component s free from the elements. Controller Located in the vehicle.
Page 3 AZIMUTH: Circular rotation around the vehicle. (like a clock face: front of vehicle is 12:00, rear is 6:00) (Fig. 2) ELEV A TION: Angle in degrees measured from the ground plane (Fig. 3) . SIGNAL STRENGTH: Intensity of electronic signal received from the satellite transmission.
Page 4 KIT CONTENTS: 1. Unpack and identify all component s (Fig. 4) . SECTION 3 INST ALLA TION Fig. 4 TOOLS AND MA TERIALS REQUIRED: - drill and drill bit set - tape measure - 7/16” open end wrench.
Page 5 IMPORT ANT! The tie strap and sp acer , and the bolt s and washers must be removed from the bottom of the dome unit prior to inst allation. DO NOT REMOVE THE DOME COVER TO REMOVE THESE SHIPPING RESTRAINTS. YOU MUST PLUG THE SHIPPING BOL T HOLES WITH THE SUPPLIED PLUGS (A TT ACHED TO TIE STRAP SHIPPING RESTRAINT).
Page 6 DOME LOCA TION 4. Select an area on the roof for the dome unit and the location where the wiring will enter the vehicle through the roof to the satellite receiver , controller , and 12 volt power source inside, using the following criteria: a) The shortest distance between the dome unit and the satellite receiver is most desirable.
Page 7 5. Place dome unit on installation location chosen using the criteria discussed in the previous section. Shipping restraints must be removed (Fig.
Page 8 7. Mount the dome unit. Use the pre-drilled holes in the mounting feet as a guide to install the fasteners into the roof. Use additional fasteners whenever necessary . 8. T est that the dome unit is secure by pulling upward from each foot location.
Page 9 1 1. Run wires from the back of the dome unit to the roof edge, then along edge to location where wiring will be fed into the vehicle. (If installing an optional second receiver , run auxiliary coax to location where it will enter the vehicle.) Secure wiring to roof every 12-18 inches (Fig.
Page 10 14. Inside vehicle, connect main coax from the dome unit directly to the “satellite in” port of the main receiver . Do not go through an “A-B” or any other switch, box, or booster . Connect auxiliary coax directly to optional second receiver .
Page 1 1 SECTION 4 OPERA TION 1. T urn TV and satellite receiver on. 2. Go to the signal meter screen on TV . Choose transponder number: Dish Network #1 1 DIRECTV #19 3. Enter local ZIP code on signal meter screen to determine satellite elevation. If you do not know your local zip code, determine your elevation from the maps on p ages 12-14.
Page 12 Elevation Map for DIRECTV 101 Find your location on the map. Use the elevation lines to determine your approximate elevation..
Page 13 Elevation Map for Dish/DIRECTV 1 10 Find your location on the map. Use the elevation lines to determine your approximate elevation..
Page 14 Elevation Map for Dish/DIRECTV 1 19 Find your location on the map. Use the elevation lines to determine your approximate elevation..
Page 15 While the dish rotates, the direction of the dish in relation to the vehicle’ s position will be displayed on the controller as a clock number . (The windshield is always 12:00 o’clock: see Fig. 2, Page 3.) This information can be used to determine when the dish is close to pointing at the desired satellite.
Store Satellite Position #1 1. Once locked onto a desired satellite, hold LEFT AND RIGHT arrows simultaneously until display flashes. 2. Hold LEFT arrow until 1P (Position 1) appears on display . Position #1 is stored in memory for this position. Store Satellite Position #2 3.
Page 17 SECTION 6 DIAGNOSTICS.
Page 18 The King-Dome Satellite System has been designed to be maintenance and trouble free. For optimum signal strength, keep the dome clean from dirt, bugs, and other debris.
Page 19 Every King Controls Satellite System is thoroughly inspected and tested before leaving the factory . It is covered by a two year part s and one year labor limited warranty from the date of original purchase. This warranty does not cover installation and external wiring or refurbished unit s.
Page 20 Notes.
.
1 1200 Hampshire Avenue South, Bloomington, MN 55438-2453 Phone: (800) 982-9920 Fax: (952) 922-8424 www .kingcontrols.com AutoScan.
An important point after buying a device EchoStar 9630 LP (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought EchoStar 9630 LP yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data EchoStar 9630 LP - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, EchoStar 9630 LP you will learn all the available features of the product, as well as information on its operation. The information that you get EchoStar 9630 LP will certainly help you make a decision on the purchase.
If you already are a holder of EchoStar 9630 LP, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime EchoStar 9630 LP.
However, one of the most important roles played by the user manual is to help in solving problems with EchoStar 9630 LP. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device EchoStar 9630 LP along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
