Instruction/ maintenance manual of the product 1401 Directed Electronics
Go to page of 44
Remote Start Keyless Entr y Model 1401 Owner’ s Guide © 2011 Directed Electronics, Vista, CA G4102P 2011-03.
.
i © 2011 Directed Electronics. All rights reserved. Contents Government regulations .................................................................................... iii W arning! Safety first ......................................................
ii © 2011 Directed Electronics. All rights reserved. Overriding the optional Starter kill ............................................................ 16 Using the remote start .........................................................................
iii © 2011 Directed Electronics. All rights reserved. Government regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device ma.
iv © 2011 Directed Electronics. All rights reserved. W ar ning! Safety first The following safety warnings must be obser ved at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer .
v © 2011 Directed Electronics. All rights reserved. Use of this product in a manner contrar y to its intended mode of operation may result in property damage, personal injur y , or death. (1) Never remotely start the vehicle with the vehicle in gear , and (2) Never remotely start the vehicle with the keys in the ignition.
vi © 2011 Directed Electronics. All rights reserved..
1 © 2011 Directed Electronics. All rights reserved. What’ s included • T wo five-button/1-way Supercode remotes • The control module (installed out-of-sight) • Control Center with i.
2 © 2011 Directed Electronics. All rights reserved. System maintenance The system requires no specific maintenance. Y our remote is powered by a small coin cell lightweight 3-volt lithium batter y that lasts approximately one year under normal use. The remote uses one CR2032 cell batter y .
3 © 2011 Directed Electronics. All rights reserved. T wo car operation Y ou can use the remote control system for two cars, with full command capabil- ity for both vehicles.
4 © 2011 Directed Electronics. All rights reserved. 1-way remote 1 3 4 5 6 2 8 7 1 2 3 4 5 6 531; ,&$ )&.
5 © 2011 Directed Electronics. All rights reserved. T ransmitter configuration Basic Commands Advanced Commands Function Level 1 Function Level 2 Function Level 3 Function Level 4 Button Level Direc.
6 © 2011 Directed Electronics. All rights reserved. Control Center The Control Center , typically located on the upper par t of the front windshield sends and receives commands or messages to and from your system. It consists of: • The In-vehicle system antenna, for 1-way communication to the system.
7 © 2011 Directed Electronics. All rights reserved. Basic commands Lock Command : Press A U X one time to Lock. Notes: Press/hold for 1.5 seconds to lock the system and then activate the Panic output. For Panic to work, the optional horn honk feature must be connected.
8 © 2011 Directed Electronics. All rights reserved. Advanced commands: function level 1 Silent lock Command : Press A U X one- time and then press A U X . Notes : Locks the system without horn honks* Silent unlock Command : Press A U X one- time and then press A U X .
9 © 2011 Directed Electronics. All rights reserved. Advanced commands: function level 2 V alet mode Command : Press A U X two-times and then A U X . Notes: Prevents the system from automatically activating the Failsafe Starter Kill and locking the door passively .
10 © 2011 Directed Electronics. All rights reserved. Advanced commands: function level 3 Car finder Command : Press A U X three-times and then A U X . Notes : The vehicle emits 1 long horn honk and the parking lights flash 10 times. Lock/Unlock cancels the parking light flashes.
11 © 2011 Directed Electronics. All rights reserved. Advanced commands: function level 4 Rear defogger* Command : Press A U X four times, and then A U X . (after remote start is on.) Notes : Manually turns on the defogger when remote start is on. Aux 4 Command : Press A U X four times and then press AUX .
12 © 2011 Directed Electronics. All rights reserved. Using the system ➢ Locking the vehicle T o lock the vehicle, press the A U X button on the remote control. The horn (if connected) in the vehicle honks one-time, and the parking lights flash one-time.
13 © 2011 Directed Electronics. All rights reserved. ➢ V alet mode Y ou can prevent your system from automatically activating the Failsafe® Star ter Kill. When the system is in V alet mode, the feature is disabled. The doors do not automatically lock.
14 © 2011 Directed Electronics. All rights reserved. Press A U X on the remote again. ➢ Configuring your remote The remote control has a menu for programming user features. Before you start make sure the keypad is unlocked. (See Button Auto Lock ) T o configure the remote user features: 1.
15 © 2011 Directed Electronics. All rights reserved. the A U X button, then press and release while the LED is flashing to continue to perform Car Select.
16 © 2011 Directed Electronics. All rights reserved. 1.5 seconds. The transmit LED turns off. ➢ Overriding the optional Starter kill T o bypass the optional Star ter kill without a remote control: Use the button on the Control Center (see diagram below) to bypass the system.
17 © 2011 Directed Electronics. All rights reserved. Using the remote star t Read this user guide, including the W arnings section at the beginning of this guide before using the remote start . Ensure that the vehicle is parked in an open area, not in a garage.
18 © 2011 Directed Electronics. All rights reserved. ➢ Manual transmission vehicles When installed into a manual transmission vehicle, the system requires that the MTS mode is properly set when parking. If MTS mode is not properly set or is defeated after being properly set the system will not start the engine.
19 © 2011 Directed Electronics. All rights reserved. 2. Insert the ignition key and turn it to the On position. 3. Now , step on the brake. The remote start tur ns off. The vehicle is ready to drive. ➢ Timer mode This unit can be programmed to start and run the engine ever y three hours, for a maximum of six cycles.
20 © 2011 Directed Electronics. All rights reserved. T o exit timer mode without the transmitter: 1. Make sure the remote start system is not operating the engine. 2. T ur n the ignition on. Timer Mode is exited and the parking lights flash slowly four times.
21 © 2011 Directed Electronics. All rights reserved. remains running for the programmed runtime. (The remote start feature is still enabled). Y ou can still remote star t the vehicle after the turbo timer has timed out and shut Off the vehicle.
22 © 2011 Directed Electronics. All rights reserved. Use one of the below methods to exit Smart Star t mode: • Perform the same steps you followed to activate Smar t Start mode • T ur n the ignition On • Press the brake pedal The parking lights flash 5 times slowly to confirm the remote has exited Smart Start mode.
23 © 2011 Directed Electronics. All rights reserved. Note : T o use Pit Stop mode with a manual transmission, open the door when going into MTS mode. The parking lights flash five-times to confirm entr y into Pit Stop mode. After you exit the vehicle you can lock the system with the remote and the car remains running.
24 © 2011 Directed Electronics. All rights reserved. Safety features This system has several important safety features to ensure proper operation of the motor and prevent accidental damage to the engine or its components.
25 © 2011 Directed Electronics. All rights reserved. Diagnostics The microprocessor at the heart of the system is constantly monitoring the switches that are connected to the main unit.
26 © 2011 Directed Electronics. All rights reserved. Owner recognition Owner recognition lets up to four users of the system have unique settings to meet their specific needs. It is almost like having four separate systems in your vehicle, one for each user .
27 © 2011 Directed Electronics. All rights reserved. Programming options Y our system has many custom programmable options. Some may require instal- lation labor . Ask your authorized dealer for details. The following is a list of the programmable options, with the factor y settings in Bold .
28 © 2011 Directed Electronics. All rights reserved. Convenience expansions Listed below are some of the expansion options available. Please consult your dealer for a complete explanation of all the options available to you.
29 © 2011 Directed Electronics. All rights reserved. Glossar y of ter ms Control Center: The Control Center contains the system’ s radio-frequency antenna, the Control button, and the Status LED. For maximum remote-control range, the Control Center is usually located at the top of the windshield, centered near the rear-view mirror .
.
31 © 2011 Directed Electronics. All rights reserved. Quick reference guide • Locking T o lock press A U X for one second. The doors lock. The LED on the Control Center flashes and the horn honks one time. (if connected). The parking lights flash once to confirm locking.
32 © 2011 Directed Electronics. All rights reserved. • Remote Start Press A U X . The parking lights turns on (if connected). The vehicle starts and runs for the programmed duration. • Rear Defogger* Press A U X four-times, and then press A U X (only after remote start is On.
33 © 2011 Directed Electronics. All rights reserved. Limited lifetime consumer warranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’ .
34 © 2011 Directed Electronics. All rights reserved. WITHOUT LIMIT A TION, LIABILITY FOR THEFT , DAMAGE AND/OR V ANDALISM. THIS W ARRANTY DOES NOT COVER LABOR COSTS FOR MAINTENANCE, REMOV AL OR REINST ALLA TION OF THE UNIT OR ANY CONSEQUENTIAL DAMAGES OF ANY KIND.
.
G4102P 2011-03 Vista, CA 92081 www .directed.com © 2011 Directed Electronics—All rights reser ved The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available.
An important point after buying a device Directed Electronics 1401 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Directed Electronics 1401 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Directed Electronics 1401 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Directed Electronics 1401 you will learn all the available features of the product, as well as information on its operation. The information that you get Directed Electronics 1401 will certainly help you make a decision on the purchase.
If you already are a holder of Directed Electronics 1401, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Directed Electronics 1401.
However, one of the most important roles played by the user manual is to help in solving problems with Directed Electronics 1401. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Directed Electronics 1401 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
