Instruction/ maintenance manual of the product ADC-EXI06 Aiwa
Go to page of 32
m!r ❑ IGITAL AUDIO ~ ADC-EXI06YU COMPACT DISC CHANGER CAMBIADOR DE DISCOS COMPACTOS B“ . OWNER’S RECORD For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below. Please refer to them when you contact your AIWA dealer in case of difficulty.
Welcome Thank you foryourpurchasmg this AIWAproduct. Tooptimize theperformance ofthisunit, please read through this manual carefully. ● TABLE OF CONTENTS ~ FEATURES ● Tracks from 10 CDs stored in the disc magazine can be selected and played. ● Horizontal, vertical, slanted or suspended installation can be made.
■ PRECAUTIONS ● Do NOT install the unit in a location where it may be subjected to: — Direct sunlight or other sources of excessive heat — Fluid, rain or moisture — Excessive dirt or dust — Excessive vibration ● This unit is designed to be operated on a 12-volt DC negative-ground electrical system only.
■ UNPACKING Compact disc changer Compact disc magazine Connecting cable Supplied mounting kit for the compact disc changer The letters are keyed to those in the instructions. Use only the supplied mounting hardware for safe and secure installation. @ Brackets (1 pair) @ Washer screws @ Plate brackets (4 ea.
● INSTALLATIONS Precautions Select the mounting location very carefully, referring to the following points. ● Make sure that there is no fuel tank, wiring or piping on the other side of the mounting surface. ● Make sure that the installation of the unit will not hinder the movement of the deck lid or interfere with the spare tire, etc.
~ INSTALLATIONS Horizontal installation 1 Construction For details on @@@..., see page 3. Note If the mounting surface needs to be strengthened, secure the plate brackets @to the bottom surfece of the car trunk, etc. with the tapping screws (not supplied).
Vertical installation 1 Construction For details on @@@..., see page 3. Notes ● If the mounting surface needs to be strengthened, secure the plate brackets @ to the bottom surface of the car trunk, etc.
~ INSTALLATIONS Suspended installation Caution When installing the unit in the trunk below the Before drilling the holes, make sure that there is package tray, observe the following.
● CONNECTIONS This unit is designed only for AIWA brand car stereo. Therefore you cannot use the unit with other brand’s equipment. Compact disc changsr to AIWA brand car stereo Caution Note Be sure to disconnect the ground wire terminal of Use only the supplied connecting cable.
● HOW TO USE How to use a compact disc magazine 2 3 With the label side up, inserl a disc all the way. 10 discs, one in each disc tray 7 Recorded side To remove a disc, pull part@ in the direction of the arrow as illustrated.
Notes on the disc magazine ● Be sure to place a disc on the disc tray with the label side up. If a disc is not set properly, it may cause damage to the unit. Disc magazine a ● The disc tray may be taken off from the magazine if you pull the tray forcibly.
Bienvenifios Muchas gracias por su compra de este producto AlWA. Para utilizar este aparato en Ias mejores condiciones posibles, lea cuidadosamente Ias instrucciones de este manual.
● PRECAUCIONES c NO instale el aparato en un Iugar donde pueda quedar expuesto a: — Ios rayos del sol o a temperatures muy altas. — Iiquido, Iluvia o humedad. — demasiada suciedad o polvo — vibration excesiva ● Este aparatofunciona solo con CC de 12voltios con conexion a tierra negativa.
● DESEMBALAJE Cambiador de discos Cargador de discos Cable de conexion compactos compactos @ QQ Juego de montaje suministrado para el cambiador de discos compactos Las Ietras en cfrculos tienen sus referencias a 10 Iargo de Ias instrucciones. Utilice solo Ias piezas para montaje suministradas para que la instalacion sea segura.
~ INSTALACIONES Precauciones Seleccione cuidadosamenteel Iugardondese va a instalar, teniendo en cuenta Ios siguientes puntos. ● Confirme quenohayaun tanquedecombustible detrasde Iasuperficie de montaje yquetampoco haya cables o caries.
~ INSTALAL70NES Instalacion horizontal 1 Diseiio Para mas detalles de @@@..., lea la pagina 3. Nota S fuere necesario reforzar la superficie de instalacion, asegure Ias mensulas de placa @ en la superficie inferior del haul del coche con tornillos autoterrajantes (no incluido).
Instalacion vertical 1 Diseiio Para mas detalles de @@@..., lea la pagina 3. Notas ● Si fuera necesario reforzar la superficie de instalac ion, asegure Ias mensulas de placa @ en la suPeticie inferior del haul del coche con tornillos autoterrajantes (no incluido).
~ INSTALACIONES Instalacion colgada Precaution Cuando se instala el aparato en el haul, debajo Verifique que no haya nadadetrasdel Iugarde la de la bandeja para paquetes, tenga en cuenta Ios instalacion antes de abrir Ios orificios. siguientes puntos.
● CONEXIONES Este aparato fue disefiado solo para Ios estereos de coche AlWA. Por 10 tanto, no utilice este aparato con equipos de otra marca. Cambiador de discos compactos al estereo de coche de la marca AIWA Precaution Nota Desconecte el terminal del cable a tierra de la Utilice solo el cable de conexion suministrado.
~ UTILIZATION Utilization del cargador de discos compactos 1 Coloq.eeldiscocompacto hastaelfondo con ei Iado de la etiqueta hacia arriba. e&”eta - 10 discos, uno en t cada bandeja de Lado grabado Para sacar un disco compacto, tire de la parte @ en discos el sentido de la flecha, tal como se puede apreciar en la figura.
~ ESPECIFICACIONES Notas sobre el cargador de discos ● Asegtirese de colocar un disco en la bandeja de discos con el Iado de Iaetiqueta hacia arriba. Si uno de Ios discos no esta bien puesto, puede dahar el aparato. Cargador de discos ● La bandeja de discos puede salirse del cargador si se tira con fuera de la bandeja.
Nous vous remercions d’avoir choisi ce produit AlWA. Pour optimiser ses performances, veuillez Iire attentivement ce mode d’emploi. ~ TABLE DES MATIERES ● CARACTERISTIQUES ● Les pistes des 10 CD stockes clans Ie magasin ATTENTION a disques peuvent &re selectionnees et Iues.
■ PRECAUTIONS ● NE PAS installer I’appareil a un endroit ou il pourrait 6tre soumis: —aux rayons directs du soleil ou a d’autres formes de temperature elevee. — a des Iiquides, a la pluie ou a I’humidlte. — a une salete ou poussiere excessive.
~DEBALLAGE Changeurdedisque Magasin a disques Cable de raccordement compact Kit de montage fourni pour Ie changeur de disque compact Les Iettres correspondent a celles du mode d’emploi. Utiliser uniquement Ies fixations de montage fournies pour assurer une installation silre.
■ mTAtiATIoN Precautions Choisir I’emplacement de montage tres soigneusement en verifiant Ies points suivants: ● Verifier qu’il n’y a pas de reservoir a carburant, c~blage ou tuyauterie derribre la surface de montage.
~ INSTALLATION Installation horizontal 1 Construction s Pour Ies details sur @@@... voir la page 3. K { Angle effectif de I’appareil H >1 @: Position du levier @ ----- P. Remarque Si la surface de montage doit 6tre renforcee, fixer Ies plaques de soutien @ sur Ie dessous du coffre de la voiture, etc.
Installation verticale 1 Construction Pour Ies details sur @@@... voir la page 3. Rema ● Si Iasurfacede montage dolt ~tre renforcee, fixerles plaques de soutien @ sur Ie dessous du coffre de la voit.
~ INSTALLATION Installation suspendue Precaution A I’installation de I’appareil clans Ie coffre sous la Verifier qu’il n’y a rien de I’autre c6te de la surface planche a paquets, respecter Ies points suivants. de montage avant de perter Ies trous.
● RAuORDEMENTs Cet appareil est conguseulement pour unestereo automobile AlWA. II ne peut pas @tre utilise avec des equipments d’autres marques. Changeur de disque compact a une stereo auto de marque AIWA Attention Remarque Bien deconnecter la borne du fil de mise ala Utiliser uniquement Iecablede raccordement fourni.
~ UTILISATION Comment utiliser Ie magasin a disques 1 lns6rer Ie disque a fond, son ctie etiquete dirige vers Ie haut, e+ e 10 disques, un clans chaque C6te enregistre plateau a disque Pour retirer un disque, firer la partie @ clans Ie sene de la fleche comme indique.
Remarques sur Ie magasin a disques ● Bien placer Ie disque sur Ie plateau a disque avec I’etiquette dirigee vers Ie haut. Un disque mal place peut endommager I’appareil. ● Le plateau a disque peut se detacher du magasin s’il est tire avec force.
8Z-KM3-901-01 980902ATM-O-U Printed in Japan AIWA CO.,LTD..
An important point after buying a device Aiwa ADC-EXI06 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Aiwa ADC-EXI06 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Aiwa ADC-EXI06 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Aiwa ADC-EXI06 you will learn all the available features of the product, as well as information on its operation. The information that you get Aiwa ADC-EXI06 will certainly help you make a decision on the purchase.
If you already are a holder of Aiwa ADC-EXI06, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Aiwa ADC-EXI06.
However, one of the most important roles played by the user manual is to help in solving problems with Aiwa ADC-EXI06. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Aiwa ADC-EXI06 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
