Instruction/ maintenance manual of the product DIALOG/4 Dialogic
Go to page of 2
D IALOG/4 ™ n Configuration n Installation n Warranty Period n RMA Process n Regulatory Notices 05-0408-003 Copyright © 1997 Dialogic Corporation. All Rights Reserved.
Setting the Initial Hook Switch State (SW1:4) SW1 switch 4 (SW 1:4 in Figure 2) sets the initial hook switch state for the DIALOG/4 board. This setting is active only when the PC is powered on but the firmware has not yet been downloaded to the board.
An important point after buying a device Dialogic DIALOG/4 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Dialogic DIALOG/4 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Dialogic DIALOG/4 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Dialogic DIALOG/4 you will learn all the available features of the product, as well as information on its operation. The information that you get Dialogic DIALOG/4 will certainly help you make a decision on the purchase.
If you already are a holder of Dialogic DIALOG/4, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Dialogic DIALOG/4.
However, one of the most important roles played by the user manual is to help in solving problems with Dialogic DIALOG/4. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Dialogic DIALOG/4 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
