Instruction/ maintenance manual of the product PHW Dacor
Go to page of 16
I N S TA L L AT I O N I N S T R U C T I O N S P R E F E R E N C E ® WA L L M O U N T R A N G E H O O D For use with model: PHW Part No. 101745 Rev . B Preliminary For Review Only.
.
1 T ABLE OF CONTENTS What Y ou Need to Know About Safety Instructions The Important Safety Instructions and warnings in these instructions are not meant to cover all possible problems and conditions that can occur . Use common sense and caution when installing, maintaining or operating this or any other appliance.
2 IMPOR T ANT SAFETY INSTRUCTIONS W ARNING Do not install or operate this hood if it has been damaged, dropped, has damaged electrical conduit or wires or is not working properly . If the product is damaged when received, immediately contact the dealer or builder .
3 IMPOR T ANT SAFETY INSTRUCTIONS W ARNING TO REDUCE THE RISK OF INJUR Y TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE: SMOTHER FLAMES with a close-fitting lid, cookie sheet or metal tray , then turn off the burner . BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately , EV ACUA TE AND CALL THE FIRE DEP ARTMENT .
4 PREP ARING FOR INST ALLA TION NOTE: The mounting hardware included with the hardware packet is suitable for mounting to brick and masonry only . If mounting the range hood to drywall, Dacor strongly recommends the using an anchoring system designed for use with drywall.
5 T o prevent back-drafts, a damper at the duct outlet may also be required. When planning new duct work, always look for the shortest, most direct route to the outside. V enting can be done through the roof or directly through the back wall to the outside.
6 Locate the chimney mounting bracket and position it against the ceiling as shown. Center it on the vertical center line drawn on the wall. Mark the ceiling in two places through the holes in the top of the bracket. Remove the bracket from the ceiling.
7 Drill the mounting holes... Attach the blower assembly mounting bracket and the “L” brackets securely to the wall (5 places). 5. 6. INST ALLA TION INSTRUCTIONS If mounting the hood to brick or masonry: Drill five 5/16” X 1 1/2” holes in the locations marked.
8 INST ALLA TION INSTRUCTIONS Hanging the Blower Assembly W ARNING Do not use screws to attach the duct work to the exhaust outlet. Use duct tape only . Screws may prevent the damper flaps on the top of the hood from opening. • Inside the exhaust outlet on the top of the blower assembly , there are metal or plastic damper flaps.
9 Electrical Connection W ARNINGS T o avoid electrical shock or fire hazard, make sure the power supply at the fuse or junction box is turned off before proceeding with final installation. Improper connection of the hood electrical wiring may create an electric shock or fire hazard and may result in damage to the hoods electrical system.
10 Carefully put the chimney over the blower assembly , taking care not to scratch the surfaces. Make sure the wiring is tucked in behind the chimney . Lock the tabs inside the chimney bottom into the slots on the bottom of the blower assembly . Slide the top of the chimney up toward the ceiling.
1 1 Installation Checklist W ARNING T o ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the homeowner .
12 NOTES.
.
Copyright © 2007 Dacor , All rights reserved. Specifications contained within are subject to change without notice. No liability is assumed by Dacor for changes in specifications.
An important point after buying a device Dacor PHW (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Dacor PHW yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Dacor PHW - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Dacor PHW you will learn all the available features of the product, as well as information on its operation. The information that you get Dacor PHW will certainly help you make a decision on the purchase.
If you already are a holder of Dacor PHW, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Dacor PHW.
However, one of the most important roles played by the user manual is to help in solving problems with Dacor PHW. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Dacor PHW along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
