Instruction/ maintenance manual of the product RS900ER CrimeStopper
Go to page of 9
OPERATING INSTRUCTIONS RS900ER/RS901 SERIES II INTRODUCTION CONGRATULATIONS on your choice of a CoolStart™ Remote Engine Starter by Crimestopper Security Products Inc. This system is the most advanced and reliable Remote Start system ava ilable on the market today.
OPERATION CAUTIONS AND WARNINGS CRIMESTOPPER SECURITY PRODUCTS, INC. and its VENDOR shall not be liable for any accident resulting from the use of this equipment.
REMOTE ENGINE CONTROL The system has three remote modes of controlling the engine: • Remote starting the engine , Turning of f a remote started engine, and Idle Down/Infinity Run modes REMOTE ENGINE STARTING - SUCCESSFUL START: 1) Press Remote Start button.
TURNING OFF A REMOTE STARTED ENGINE: IDLE DOWN MODE This mode allows the unit to take over operation of the parked vehicle while the ignition key is removed and you exit the vehicle. The vehicle is put into a remote running condition before you exit and it will remain running for the programmed run time or until you come back.
IDLE DOWN MODE - EXITING THE VEHICLE: ENTERING A VEHICLE DURING “IDLE - DOWN” or “INFINITY RUN” MODES: 1) With engine running in "IDLE DOWN" (parking lights ON), unlo ck door or (Rem.
INFINITY RUN MODE – EXITI NG THE VEHICLE: 1) With engine running, press and hold the brake pedal down, then press the Start button on the transmitter two times within 4 seconds or activate Green input wire 2x’s within 4 seconds (RS901). 2) Parking Lights will start flashing, and doors wi ll unlock.
only with lock/unlock buttons. If an anti - grind/starter kill relay is installed on a vehicl e without power door locks, the lock and unlock buttons on the remote control still have to be utilized to operate the Anti - grind/starter kill.
accidentally remote starting the vehicle. !! WARNING !!: Remove main power fuse before jump starting or charging a dead or low vehicle battery TRANSMITTER PROGRAMMING TRANSMITTER PROGRAMMING: Note: All transmitter codes must be learned at time of programming!! The RS900 allows storage of up to 4 different transmitter codes.
RS900I OP REVA.
An important point after buying a device CrimeStopper RS900ER (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought CrimeStopper RS900ER yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data CrimeStopper RS900ER - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, CrimeStopper RS900ER you will learn all the available features of the product, as well as information on its operation. The information that you get CrimeStopper RS900ER will certainly help you make a decision on the purchase.
If you already are a holder of CrimeStopper RS900ER, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime CrimeStopper RS900ER.
However, one of the most important roles played by the user manual is to help in solving problems with CrimeStopper RS900ER. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device CrimeStopper RS900ER along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
