Instruction/ maintenance manual of the product RS-840 CrimeStopper
Go to page of 12
RS-840 Model REMOTE ENGINE STARTING SYSTEM OPERATING INSTRUCTIONS INTRODUCTION Congratulations on your choice of a Crimestopper CoolSt art remote engine starter! This installation Handbook covers the RS-840 Model Remote Start & Keyless Entry System.
TABLE OF CONTENTS Operation Cautions & Warnings…….……………..….…………………………………….…………………………2 Remote Control Diagrams………...…………………………………………………………………………….
REMOTE CONTROL DIAGRAM #3 #1 #2 #4 LOCK T RUNK ENGINE UNLO CK VEHICLE #2 FLA SHL IGHT (A UX.) ST A RT /ST OP RS-840 SYSTEM The transmitter supplied with the RS-840 system has a tota l of 6 buttons. The button configuration of the RS-840 is Factory-set and unchangeable.
REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START: 1) Press the remote start button for at least 1 second. 2) Parking lights flash once; return solid, and the Ignition/Accessory circuits turn on. 3) After a few seconds the Starter Motor engages, Parki ng lights and Accessory circuits will turn off while cranking.
REMOTE ENGINE CONTROL ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock system or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter & Shift out of park.
REMOTE ENGINE CONTROL INFINITY RUN MODE This mode can only be activated when "Idle Down" procedure. The Infinity Run mode allows the vehicle engine to remain running INDEFINITELY after the programmed run time elapses .
TURBO TIMER MODE (OPTIONAL) The optional Turbo Timer mode allows the CoolStart syst em to keep a Turbo or Turbo Diesel vehicle running for 1 to 5 minutes [selectively] after you remove the key, exit the vehicle, and lock the doors rem otely. This is handy for turbo cool-down without the need for expensive turbo timers.
CONVENIENCE AND SAFETY FEATURES KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional) This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) via remote control for safety and convenience. Note: This feature may require extra labor and/or parts to install.
CONVENIENCE AND SAFETY FEATURES HOOD OPEN SAFETY (Requires grounding hood pin installation) This feature prevents the engine from being remote started when hood is open. Helps eliminates risk of injury to someone working under the hood of the vehicle with a properly working hood pin installed.
TRANSMITTER PROGRAMMING TRANSMITTER PROGRAM DIAGRAM: IGN OFF WAIT F O R 4 FLA SHES PRESS 4 X's FLA SH 2, 3, or 4 X's (GRA Y WIRE GR OUNDED) IGN OFF PRESS LOCK BUTTON COMPLETE 10.
2-VEHICLE OPERATION The RS-840 system can be used for 2 vehicle operation. A single remote can control a second vehicle with an RS-840 or other CoolStart system installed. There are some exceptions. See “Multi-Vehicle Notes” section below. VEHICLE #2 Press low er s ide button first, then you hav e 3 seconds to control v ehicle #2.
TROUBLESHOOTING: “BEFORE YOU CALL” SECTION UNIT FLASHES LIGHTS ONCE AND WILL NOT ATTEMPT A START: The unit senses a fault at the Brake (Purple wire is active) or the Hood is OPEN (Gray wire grounded). This is a safety feature of the unit. Check installation for faults and make sure hood is closed and latched and brake wire is not active.
An important point after buying a device CrimeStopper RS-840 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought CrimeStopper RS-840 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data CrimeStopper RS-840 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, CrimeStopper RS-840 you will learn all the available features of the product, as well as information on its operation. The information that you get CrimeStopper RS-840 will certainly help you make a decision on the purchase.
If you already are a holder of CrimeStopper RS-840, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime CrimeStopper RS-840.
However, one of the most important roles played by the user manual is to help in solving problems with CrimeStopper RS-840. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device CrimeStopper RS-840 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
