Instruction/ maintenance manual of the product CISCO1751 Cisco Systems
Go to page of 34
Corporate Headquarters: Copyright © 2003 Cisco Systems, Inc. All rights reserved. Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA Cisco 1751 Voice-over-IP Quick Start Guide Th.
2 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Conventions Conventions This document uses the f ollow ing con venti ons: • Commands and ke ywords are in bol dface . • Optional k eywords or arguments ar e in square brackets. • V ariables for which you supply v alues are in italic .
3 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Installing WAN a nd Voice Interface Card s Figure 1 V oice Interf ace Card Y ou should install and cable VICs before perfo rming the software conf iguration tasks e xplained later in this guide.
4 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Installing WAN and Voice Interface Cards Figure 2 Inserting a WIC or VIC in the Rout er If you need m ore deta iled installa tion ins tructions, re fer to the C i s c o WA N I n t e r f a c e C a rd s H a rd w a re Installation Gu ide .
5 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Installing WAN a nd Voice Interface Card s Figure 3 Connecting VICs to the Networ k When you are finished, reinstall an y network interf ace cables you removed and turn on po wer to the router .
6 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Installing WAN and Voice Interface Cards Figure 5 sho ws the wiring pattern for an E&M connector , and Ta b l e 2 lists the E&M pinouts. Note The E&M VIC pinout depends on the PBX type and co nnection.
7 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Installing WAN a nd Voice Interface Card s The card is illustrated in Figure 6 . Figure 6 2-P ort ISDN BRI Card F ront P anel Connecting the 2-Port ISDN BRI Card Use the straight-t hrough RJ-45 cable to con nect the 2-port ISDN BRI card to the ISDN netw ork through a telephone wall outlet.
8 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Installing WAN and Voice Interface Cards Note When the interface is configured as NT and is connecti ng to a TE device, the cabl e must ha ve the transmit and receiv e pins swapped (crossover cable).
9 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Cisco Router and Security Devic e Manager Figure 8 Cisco 1 751 Router Slot Number ing Figure 9 sho ws the VIC port numberin g.
10 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Configuring Voice-over-I P T o obtain the SDM release notes, and other SDM d ocumentation, go to http://www .cisco.com/go/sdm and click the T echnical Documentation link. Note If you need to configure V oice-ov er-IP , use the Configuring V oi ce-ov er-IP section of this Quick Start Guide.
11 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Configuring Voice-over-IP If the installer does not start after a few seconds, select Start>Run , and enter d:setup where d is your CD-R OM driv e. Step 5 Follo w the instructio ns on the screen to install the Cisco Conf igMaker application.
12 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Configuring Voice-over-I P Information for International Users International users mu st set the v alues of certain v oice-port commands, like cptone , that are specif ic to their country . Refer to the Cisco 1751 Router Sof twar e Conf iguration Gu ide for details .
13 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Configuring Voice-over-IP For complete in formation about the g lobal configurati on commands and about co nfigurin g LAN and W AN interfaces on your router , refer to the Cisc o IOS configuration gui des and command references.
14 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Configuring Voice-over-I P Dial Plan Use a dial plan to map the destination t elephone numbers with the v oice ports on the router . In North America, the North American Numbering Plan (NANP) is used, which consists of an area code, an off ice code, and a station code.
15 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Configuring Voice-over-IP Y ou can use a period (.) as a wildca rd character representing a single digit in a t elephone number . Y ou can use the show num-exp command to verify the number expansion i nformation.
16 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Configuring Voice-over-I P Note Y ou can name your router by using the g lobal configuration hostname command. (For info rmation about port numbering, refer to th e section on “Determining V oice Port Numbering” earlier in this guide.
17 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Configuring Voice-over-IP Note The telephone numbers used in this guide are only e xamples and are in valid f or public use in the United States. When you conf igure your network, be sure to substit ute your o wn telephone numbers.
18 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Configuring Voice-over-I P Figur e 13 Basic V oice Networ k (East Router) Enter the follo wing commands to configure the l ocal ports on the .
19 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Configuring Voice-over-IP Checking Dial Peer Configuration If you conf igured PO TS dial peers on your router b y following these e xamples, you can place calls between telephones c onnected to the same router .
20 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Configuring Voice-over-I P Construct a table similar to Ta b l e 1 0 for your o wn routers, assigning your o wn telephone numbers, IP addresses, and dial-peer tags. Note The IP addresses sho wn in this guide are meant only as examples.
21 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Configuring Voice-over-IP Enter the follo wing information o n the East router to create the dial-peer configuration gi ven in Ta b l e 1 1 : East(config)# num-exp 5.... 1408555.... East(config)# dial-peer voice 801 voip East(config-dial-peer)# destination-pattern 1408555.
22 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Configuring Voice-over-I P Figure 18 FX O Gatew ay t o PSTN T o create a PO TS dial peer for an FXS interface as explained earlier , you enter the complete telephone number of the attached telephone as the desti nation pattern for incoming calls.
23 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Configuring Voice-over-IP Checking FXO Configuration If you conf igured your FXO interf ace according to this example, y ou can place outgoing calls over the PSTN. If you ha ve troub le placing calls, use the sh ow voi ce port command to make sure that the VIC is installed co rr ectly .
24 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Configuring Voice-over-I P Both PBXs in this e xample use E&M interface T ype 2, with four -wire operation and immed iate-start signaling. The v alues for your conf iguration depend on your PBX and are av ailable from your telecommunications d epartment or the PBX manufacturer .
25 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Configuring Voice-over-IP Note For these commands to take ef fect, you hav e to cycle the port b y using the shutdown and no shutdo wn commands. Note Configure th e PBX to pass all dual-tone multifrequenc y (DTMF) signals to the router .
26 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Configuring Voice-over-I P • Multilink Point-to Point Protocol (PPP) interleaving • Real-T ime T ransport Protocol (R TP) header compression Cisco IOS software provides many other tools fo r ensuring QoS, such as custom queu ing, priority queuing, and w eighted fair queuin g.
27 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Configuring Voice-over-IP RSVP Resource Reserv ation Protocol (RSVP) enables routers to reserve enough bandwidth on an interface for reliable and quality perfo rmance. RSVP works well on PPP , HDLC, and similar serial line interfaces.
28 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Configuring Voice-over-I P Configuring Multilink PPP Interleaving T o conf igure multilink PPP and interlea ving on a dial er, ISDN PRI or I .
29 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Configuring Voice-over-IP Configuring Frame Relay for VoIP Config uring V oIP on a Frame Relay li nk in volv es ce rtain special considerati ons to ensure acceptable voi ce quality .
30 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 List of Terms List of Terms This section def ines some of the V oIP terms and co ncepts used in this guide.
31 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Obtaining Documentation RT P —Real-Time T ransport Proto col, a network protocol used to carry audio and video packet traf f ic ov er an IP network. session target —A remote IP or DNS address specif ied for a dial peer .
32 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Documentation Fe edback Documentation Feedback Y ou can send comments about technical documentation to bug-doc@cisco.
33 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Obtaining Additional Publ ications and Information T o open a service req uest by telephone, use one of the fo llowi ng numbers: Asia-Pacif ic.
34 Cisco 1751 Voice-over-I P Quick Start Guide 78-11259-05 Obtaining Additional Pub lications and Information • iQ Magazine is the quarterly pub lication from Cisco Syst ems designed to help gro wing compan ies learn ho w they can use technology to in crease rev enue, streamline their b usiness, and expand services.
An important point after buying a device Cisco Systems CISCO1751 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Cisco Systems CISCO1751 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Cisco Systems CISCO1751 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Cisco Systems CISCO1751 you will learn all the available features of the product, as well as information on its operation. The information that you get Cisco Systems CISCO1751 will certainly help you make a decision on the purchase.
If you already are a holder of Cisco Systems CISCO1751, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Cisco Systems CISCO1751.
However, one of the most important roles played by the user manual is to help in solving problems with Cisco Systems CISCO1751. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Cisco Systems CISCO1751 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
