Instruction/ maintenance manual of the product INTIMIDATOR SCAN LED 300 Chauvet
Go to page of 20
User Manual.
CHAUVET®, 2010, All Rights Reserved Information and specifications in this User Manual are s ubject to change without notice. CHAUVET® assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual. Author: Anthony Chiappone Revision: 01 Release Date: 10-08-2 010 T ABLE OF C ONTENTS 1.
1. Before You Begin 3 10/25/2010 10:23 AM 1. B EFORE Y OU B EGIN What is included • 1 x Intimidator™ Scan LED 300 • 1 x Mounting bracket kit • 1 x Power Cord • 1 x Warranty Card • 1 x User.
1. Before You Begin 4 10/25/2010 10:23 AM Safety Instructions • Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet.
2. Introduction 5 10/25/2010 10:23 AM 2. I NTRODUCTION Product Dimensions.
2. Introduction 6 10/25/2010 10:23 AM Product Overview Bracket Adjustment Knob DMX In DMX Out Power Out Fuseholde r Power In Voltage Selection Switch (115/230 V AC) Safety.
3. Setup 7 10/25/2010 10:23 AM 3. S ETUP AC Power This fixture is switchable and runs on either 115 VAC, 60 Hz or 230 VAC, 50 Hz power. Before powering on the unit, make sure the line voltage to which you are connecting it matches the current setting on the voltage selection switch.
3. Setup 8 10/25/2010 10:23 AM Mounting Orientation The Intimidator™ Scan LED 300 may be mounted in any position provided there is adequate room for ventilation. Rigging Be sure that the structure can support the wei ght of the fixture. Pl ease see the “Technical Specifications” section of this m anual for a detailed weight listing.
4. Operating Instructions 9 10/25/2010 10:23 AM 4. O PERATING I NSTRUCTIONS Using the Control Panel Access control panel functions using the four butto ns located directly underneath the LED display on the included wired remote.
4. Operating Instructions 10 10/25/2010 10:23 AM Operation DMX Operation This is the operating mode which will allow for c ontrol with an external DMX controller.
4. Operating Instructions 11 10/25/2010 10:23 AM Sound-Active This fixture has a preprogramme d, sound triggere d chase. Access this via the control panel on the front of th e fixture. Adjust the microphone s ensitivity from the control panel. Please see the char t below for further explanation.
4. Operating Instructions 12 10/25/2010 10:23 AM DMX Channel Values 11-CH Mode C HANNEL V ALU E F UNCTION C HANNEL V ALUE F UNCTION 1 000 Ù 255 Pan 0°~180° 7 000 Ù 015 016 Ù 127 128 Ù 239 240 Ù.
4. Operating Instructions 13 10/25/2010 10:23 AM 7-CH Mode C HANNEL V ALU E F UNCTION C HANNEL V ALUE F UNCTION 1 000 Ù 255 Pan 0°~180° 6 000 Ù 015 016 Ù 127 128 Ù 239 240 Ù 255 Gobo Rotation S.
5. Appendix 14 10/25/2010 10:23 AM 5. A PPENDIX General Troubleshooting S YMPTOM P OSSIBLE C AUS E ( S ) P OSSIBLE A CTION ( S ) Breaker/Fuse keeps blowing • Excessive circuit load • Check total load placed on the electrical circuit.
5. Appendix 15 10/25/2010 10:23 AM DMX Primer There are 512 channels in a DMX connection. A fixt ure capable of receiving DMX will require one or a number of sequential channels. The user must assign a starting address on the fi xture that indicates the first channel reserved in the cont roller.
5. Appendix 16 10/25/2010 10:23 AM Cable Connectors Cabling must have a male XLR connector on one end and a female XLR connector on the other end. Do not allow contact be twe en the common and the fixture’s ch assis ground. Grounding the common can caus e a ground loop, and y our fixture may perform erra tically.
5. Appendix 17 10/25/2010 10:23 AM 3-Pin to 5-Pin Conversion Chart If you use a controller with a 5-pin DMX output connector, you will ne ed to use a 5-pin t o 3-pin adapter.
5. Appendix 18 10/25/2010 10:23 AM General Maintenance To maintain optimum performance and minimize wear, fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month.
T ECHNICAL S PECIFICATIONS WEIGHT & DIMENSIONS Length .............................................................................................................. 11 in (27 9 mm) Width ............................................................
C ONTACT U S World Wi de General Information CHAUVET® 5200 NW 108 th Ave Sunrise, FL 33351 voice: 954.929.1115 fax: 954.929.5560 toll free: 800.762.1084 Technical Support CHAUVET® 5200 NW 108 th Ave Sunrise, FL 33351 voice: 954.929.1115 (Press 4) fax: 954.
An important point after buying a device Chauvet INTIMIDATOR SCAN LED 300 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Chauvet INTIMIDATOR SCAN LED 300 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Chauvet INTIMIDATOR SCAN LED 300 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Chauvet INTIMIDATOR SCAN LED 300 you will learn all the available features of the product, as well as information on its operation. The information that you get Chauvet INTIMIDATOR SCAN LED 300 will certainly help you make a decision on the purchase.
If you already are a holder of Chauvet INTIMIDATOR SCAN LED 300, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Chauvet INTIMIDATOR SCAN LED 300.
However, one of the most important roles played by the user manual is to help in solving problems with Chauvet INTIMIDATOR SCAN LED 300. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Chauvet INTIMIDATOR SCAN LED 300 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
