Instruction/ maintenance manual of the product 56-24UVB Chauvet
Go to page of 17
LED PAR 56-24UVB User Manual.
CHAUVET®, 2010, All Rights Reserved Information and specifications in this User Manual are subject to change without notice.
1. Before You Begin 3 9/13/2010 2:33 PM 1. B EFORE Y OU B EGIN What is included • 1 x LED PAR 56-24UVB • 1 x Gel Holder • 1 x Warranty Card • 1 x User Manual Unpacking Instructions Immediately.
1. Before You Begin 4 9/13/2010 2:33 PM Safety Instructions • Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet.
2. Introduction 5 9/13/2010 2:33 PM 2. I NTRODUCTION Product Overview DMX In Power Input Microphone Microphone Sensitivity Adjustment Knob Fuseholder Bracket Adjustment Knob Attachment Bolt (not meant.
3. Setup 6 9/13/2010 2:33 PM 3. S ETUP AC Power This fixture runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line voltage to which you are connecting it is within the range of accepted voltages.
3. Setup 7 9/13/2010 2:33 PM Mounting Orientation The LED PAR 56-24UVB may be mounted in an y position provided there is adequate room for ventilation. Rigging Be sure that the structure can support the wei ght of the fixture. Pl ease see the “Technical Specifications” section of this manual for a detailed weight listing.
4. Operating Instructions 8 9/13/2010 2:33 PM 4. O PERATING I NSTRUCTIONS Configuring the Starting Address The LED PAR 56-24UVB fixture us es two DMX channels. The hi ghest channel that the fixture may be set to in order to function properly is 511. An y address higher than this will prevent access to all of the channels.
4. Operating Instructions 9 9/13/2010 2: 33 PM DMX Operation This operating mode allows control of the fixture with an external DMX controller. You must set the starting address for this mode. If this is your first time using DMX, then it is recommended that you refer to the “DMX Primer” section in the “Appendix” of this manual.
4. Operating Instructions 10 9/13/2010 2:33 PM Automatic This fixture has a preprogrammed pulsating chas e with adjustable speed. Access this via the control panel of the front of the fixture. Please see the instructions below for further d etails. 1.
5. Appendix 11 9/13/2010 2:33 PM 5. A PPENDIX General Troubleshooting S YMPTOM P OSSIBLE C AUS E ( S ) P OSSIBLE A CTION ( S ) Breaker/Fuse keeps blowing • Excessive circuit load • Check total load placed on the electrical circuit. • Short circuit along the power wires • Check for a short in the electrical wiring (internal and/or external).
5. Appendix 12 9/13/2010 2:33 PM DMX Primer There are 512 channels in a DMX connection. A fixt ure capable of receiving DMX will require one or a number of sequential channels. The user must assign a starting address on the fi xture that indicates the first channel reserved in the cont roller.
5. Appendix 13 9/13/2010 2:33 PM Cable Connectors Cabling must have a male XLR connector on one end and a female XLR connector on the other end. Do not allow contact be twe en the common and the fixture’s ch assis ground. Grounding the common can caus e a ground loop, and y our fixture may pe rform erratically.
5. Appendix 14 9/13/2010 2:33 PM 3-Pin to 5-Pin Conversion Chart If you use a controller with a 5-pin DMX outpu t connector, you will ne ed to use a 5-pi n to 3-pin adapter.
5. Appendix 15 9/13/2010 2:33 PM General Maintenance To maintain optimum performance and minimize wear, fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month.
T ECHNICAL S PECIFICATIONS WEIGHT & DIMENSIONS Length ............................................................................................................. 9.2 in (23 4 mm) Width ............................................................
C ONTACT U S World Wi de General Information CHAUVET® 5200 NW 108 th Ave Sunrise, FL 33351 voice: 954.929.1115 fax: 954.929.5560 toll free: 800.762.1084 Technical Support CHAUVET® 5200 NW 108 th Ave Sunrise, FL 33351 voice: 954.929.1115 (Press 4) fax: 954.
An important point after buying a device Chauvet 56-24UVB (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Chauvet 56-24UVB yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Chauvet 56-24UVB - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Chauvet 56-24UVB you will learn all the available features of the product, as well as information on its operation. The information that you get Chauvet 56-24UVB will certainly help you make a decision on the purchase.
If you already are a holder of Chauvet 56-24UVB, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Chauvet 56-24UVB.
However, one of the most important roles played by the user manual is to help in solving problems with Chauvet 56-24UVB. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Chauvet 56-24UVB along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
