Instruction/ maintenance manual of the product Country 8B Charnwood
Go to page of 9
Operating and Installation Instructions CHARNWOOD COUNTRY 8B WOODBURNER WITH BOILER Bishop's Way, Newport, Isle Of Wight, PO3O 5WS, U.K. Tel: (01983) 527552 Fax: (01983) 821267.
Before lighting the stove check with the installer that the work and checks described in the Installation Instructions have been carried out correctly and that the chimney has been swept, is sound and free from any obstructions. FUELS Wood Wood must be dry and well seasoned.
the grate and cover with approximately 2 inches of fuel. Open the air slides in the doors and open the airwash control fully (see Fig. 1). Light the paper or fire lighters. Close the doors until the fuel is well ignited then load with fuel and adjust the air controls to the required setting.
poke the fire, load with fuel, and then close the door air slides. The airwash control should be kept slightly open to help keep the door glass clean. Some experimentation may be necessary to find the setting most suitable for the type of fuel being used and the draw on the chimney.
chimney is warm a draught reading of at least 2.5 mm (0.10 inches) water gauge should be obtained. When burning coal some blackening of the glass may occur below the level of the front fence. This will not obscure the view of the fire or affect its performance.
or externally. These chimneys must be fitted in accordance with the manufacturers instructions and Building Regulations. Single wall flue pipe is suitable for connecting the stove to the chimney but is not suitable for using for the complete chimney.
inches) each side and 300mm (12 inches) above the appliance should give sufficient air circulation. If a wooden mantelpiece or beam is used in the fireplace it should be a minimum of 460mm (18 inches), and preferably 600mm (24 inches) from the appliance.
If the appliance is used to heat a very small central heating system then the heat output to the room from the fire will be reduced. Fig. 3. shows the ratio of space heating to water heating which can be expected.
in the roof of the appliance. The location and positioning of the throat plate is shown in Fig. 2. Before initial lighting check that the front fence is fitted correctly and that the doors tighten properly.
An important point after buying a device Charnwood Country 8B (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Charnwood Country 8B yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Charnwood Country 8B - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Charnwood Country 8B you will learn all the available features of the product, as well as information on its operation. The information that you get Charnwood Country 8B will certainly help you make a decision on the purchase.
If you already are a holder of Charnwood Country 8B, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Charnwood Country 8B.
However, one of the most important roles played by the user manual is to help in solving problems with Charnwood Country 8B. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Charnwood Country 8B along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
