Instruction/ maintenance manual of the product WMC36 WMC42 CFM Corporation
Go to page of 24
For Models: WMC36 WMC42 For use in U.S./Canada Underwriter's Laboratories Report No. MH6018 DO NOT DISCARD THIS MANUAL: Retain for future use. 20000583 7/06 Rev .
2 WMC Series W oodbur ning Fireplace 20000583 Safety Information PLEASE READ THIS MANUAL BEFORE INST ALLING AND USING FIREPLACE. IMPORT ANT : Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty .
3 WMC Series W oodb ur ning Fireplace 20000583 50" (1270mm) 42" (1067mm) 35 ¹⁄ ₄ " (895mm) 46" (1 168mm) ⁵⁄₈ " (16mm) ⁵⁄₈ " (16mm) ¹⁄₂ " (13mm).
4 WMC Series W oodb ur ning Fireplace 20000583 Chase Installation Insulation methods shown are optional for cold climate, not a requirement for unit operation.
5 WMC Series W oodb ur ning Fireplace 20000583 D RISE B G H B OFFSET C E 6 FT . G H A HEARTH FLOOR CHIMNEY SECTION CHIMNEY FLUE EXIT ELBOW FPC269 Chimney Requirements -typ.
6 WMC Series W oodb ur ning Fireplace 20000583 Planning Information Preplanning an installation is very important to ensure safety and to save time and money . An installer must predetermine where a fireplace will be set and how the chimney system will be run.
7 WMC Series W oodb ur ning Fireplace 20000583 Chimney Supports The chimney system is supported by the fireplace for vertical chimney heights less than 30' (9 m) above the hearth. Chimney supports are required if the vertical height exceeds 30' (9 m) with SK8 chimneys or 20' (6 m) with 3-wall chimneys.
8 WMC Series W oodb ur ning Fireplace 20000583 Framing Framing can be constructed before or after the fire- place is set in place, however , most installers build the frame before setting the fireplace. Frame fireplace with 2 x 4 lumber or heavier materials.
9 WMC Series W oodb ur ning Fireplace 20000583 Chimney Set-up Since you have already preplanned the chimney run, you should know exactly how the installation is to be accomplished - how much pipe is required, the number of elbows, if any , and type of termination to be used.
10 WMC Series W oodb ur ning Fireplace 20000583 Framing the Ceiling Hole Frame the ceiling chimney hole as shown in Figure 13. It is good practice to use framing lumber that is the same size as the ceiling joists; this is a requirement at attic level.
1 1 WMC Series W oodb ur ning Fireplace 20000583 Installing Outside Air Kit An outside air kit is installed in all WMC Series Fire- places. If desired, or if local codes mandate the use of an air kit, then an AK-MST is required to complete the installation (from air kit to the outdoors).
12 WMC Series W oodb ur ning Fireplace 20000583 FP593 SR/C 11/20/97 Fig. 19 Installing firestop spacer . FP593 Nails (4) Firestop Spacer Joist Attic Installation Ceiling Installation Joist Firestop Spacer Nails (4) FP263 Fig. 20 Attic shield installlation (Canadian requirement).
13 WMC Series W oodb ur ning Fireplace 20000583 adjacent combustible surfaces. (Combustible surfaces include burnable materials such as: ceiling members, joists, flooring, combustible insulation and roof struc- tures.) W ARNING: DO NOT P ACK REQUIRED AIR SP ACES WITH INSULA TION OR OTHER MA TERIALS.
14 WMC Series W oodb ur ning Fireplace 20000583 NOTE: No side wall protection is required for fireplaces installed at 45° to two (2) side walls (corner installation).
15 WMC Series W oodb ur ning Fireplace 20000583 Hearth Installation A hearth extension is required to protect a combustible floor in front of the fireplace. Refer to Figure 24 for minimum dimensions and mounting detail. NOTE: Hearth Extension must not cover the air inlet/outlet opening of a fireplace.
16 WMC Series W oodb ur ning Fireplace 20000583 COMMON MA TERIALS AND F ACTORS MA TERIAL K* R MINIMUM THICKNESS EH2416 Common Brick 0.458 5.0 1.09 0.50 in.** 0.10 5.46 in.** (CFM Corporation) R V alue is for Zx inch. * Units of K = BTU/SQ FT/HR/˚F/IN ** Thickness of Listed Material FP533ADD Addendum 6/1/99 djt 8/4/99 changed .
17 WMC Series W oodb ur ning Fireplace 20000583 Only unvented gas log sets which have been found to comply with the Standard for Unvented Room Heaters, ANSI Z21.
18 WMC Series W oodb ur ning Fireplace 20000583 2-583 Parts page 3/2/99 djt 1 2 3 4 5 6 7 12 8 10 9 1 1 15 14 17a,b 16 18 19 20 OFF L O W 21 13 583 CFM Corporation reserves the right to make changes in design, materials, specificaitons, prices and discontinue colors and products at any time, without notice.
19 WMC Series W oodb ur ning Fireplace 20000583 The following accessories for this appliance are available from your local distributor . Should you need additional in- formation beyond what your distributor can furnish, contact: CFM Corporation, 2695 Meadowvale Blvd.
20 WMC Series W oodb ur ning Fireplace 20000583 Chimney Components Round T op T ermination T op used to terminate chimney at roof. RL TSK8 (SK8) (Flashing not included.) Round T op T ermination - T op used to terminate chimney at chase. RL TSK8L Extended (SK8) (Flashing not included.
21 WMC Series W oodb ur ning Fireplace 20000583 Model Number Description Component (Chimney Components con't.) Square Chase T ermination Square chimney cap used to terminate chimney SL TS8 through chase.
22 WMC Series W oodb ur ning Fireplace 20000583.
23 WMC Series W oodb ur ning Fireplace 20000583 LIMITED W ARRANTY & 30 YEAR PROTECTION PLAN For MAJESTIC FIREPLACES PRE-ENGINEERED Fireplace Systems CFM Corporation warrants its Pre-Engineered Fir.
2695 Meadowvale Blvd. • Mississauga, Ontario, Canada L5N 8A3 800-668-5323 • www .cfmcorp.com CFM Corporation.
An important point after buying a device CFM Corporation WMC36 WMC42 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought CFM Corporation WMC36 WMC42 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data CFM Corporation WMC36 WMC42 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, CFM Corporation WMC36 WMC42 you will learn all the available features of the product, as well as information on its operation. The information that you get CFM Corporation WMC36 WMC42 will certainly help you make a decision on the purchase.
If you already are a holder of CFM Corporation WMC36 WMC42, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime CFM Corporation WMC36 WMC42.
However, one of the most important roles played by the user manual is to help in solving problems with CFM Corporation WMC36 WMC42. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device CFM Corporation WMC36 WMC42 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
