Instruction/ maintenance manual of the product STD6.1 Baumatic
Go to page of 20
STD6.1 Cooker Hood.
1 User Manual for your Baumatic STD6.1 Cooker Hood 11/07/05 NOTE : This User Instruction Man ual contains imp ortant information, including safety & installation points, w hich will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available fo r future reference.
2 YOUR COOKER HOOD’S SPECIFICATIONS ….……………..………….3 IMPORTANT SAFETY INFO RMATION……………………………….…4-5 ENVIRONMENTAL NO TE ………….…………………………………………6 USING YOUR COOKER HOOD……………………………….
3 Congratulations on purchasing a Baumatic Cooker Hood! To fully enjoy using your app liance long into the future, please firstly familiarise yours elf with its specifications, safety advice and operational in structions included in this manual. You will also need this manual to ensure that your Cooker Hood has been installed properly.
4 o Any installation work must be carried out by a qualified electrician or competent person. o The hood must be installed in accordance with the installation instructions and all measurements followed.
5 o Ensure the ducting for the extractor function has the same diameter as the outlet hole all the way through. o Keep young children from using, playing with or tampering with the cooker hood. Older children and infirm persons should be supervised if they are using the cooker hood.
6 Note : Before discarding an old appliance, switch off and disconnect it from the power supp ly. Cut off and render any plug useless. Cut the cable off directly behind th e appliance to prevent misuse. This should be under taken by a competent person.
7 To use your cooker hood: 1) Make sure it has been properly installed. 2) Find the CONTROL PANEL. It is located on the hood’s front surface near the upper right corner of the unit. 3) The CONTROL PANEL contains switches as shown in the Figure below.
8 * IMPORTANT! : Before cleaning, always ensure that you have switched your cooker hood OFF at the omni-polar switch, set at the wall from t he cable: Cleaning  Clean the external p arts with mild liquid deterg ents on a damp cloth.  Never use abrasive powder, corrosive solvents or brushes.
9 First remove the anti- grease filter by sliding the securing nibs at the sides of the grille on the underside of the hood. You can now clean the anti-grease grille: To clean the grille by hand: 9 Soak it for about one hour in hot water with a grease- loosening detergent then rinse off thoroughly with hot water.
10 a) Changing the light bulb 9 Before changing the light bulb, en sure that the appliance is not live (i.e., ensure that you have switched it off at the omni-polar switch on the wall switch plate). 9 Open the grease filt er support grille (see previous page).
11 Your Baumatic Cooker Hood uses a CARBON FILTER to purify the air for the air recirculation function. You will find that one filter will attach over the front of the fan motor (please see figu re at bottom of page). The active carbon filter must be replaced regularly, at least once every three months, to allow normal operation.
12 Before installation and usage, read all t he instructions and ma ke sure that the voltage (V) and th e frequency (Hz) indicated on th e identification p late (found inside your Cooker Hood) and all the dat a inside the ap pliance are exactly the same as the voltage and frequency in your home.
13 : The cooker hood must not be fitted above stoves with a radiant top plate. : We recommend that at least two people install this hood. Your Baumatic Cooker Hood should only be fitted on a wall on the underside of a cabinet unit. Do NOT position it any less than 700 mm (70 cm) above the hob.
14 7) KITCHEN UNIT / UNDERSIDE OF CABINET INSTALLATION NOTE: Ensure that the grease filter grille has been removed. 1) (E) – Extraction Functio n only If you are using the top exhaust outlet (meanin.
15 If something has gone wrong with your Cooker Hood, checking against this chart might keep you from having to call for service. Symptom Solution The cooker hood will not start! • Check that the hood is connected to the electricity supply. • Check that the fan speed control is set properly.
16 BAUMATIC LTD. - CONDITIONS OF GUARANTEE. Dear Customer, The conditions of guarantee whic h apply to your Baumat ic appliance are as follows: This product is guaranteed for 12 months from the date of original purchase. Baumatic Ltd will repair any defect that arises due to faulty materi als or workmanship free of charge during this period.
17 Baumatic Ltd Make-up for your kit chen Headquarters Baumatic Ltd. Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX, United Kingdom Sales Telephon e +44 118 933 6900 Sales Fax +44 118 9.
18.
19.
An important point after buying a device Baumatic STD6.1 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Baumatic STD6.1 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Baumatic STD6.1 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Baumatic STD6.1 you will learn all the available features of the product, as well as information on its operation. The information that you get Baumatic STD6.1 will certainly help you make a decision on the purchase.
If you already are a holder of Baumatic STD6.1, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Baumatic STD6.1.
However, one of the most important roles played by the user manual is to help in solving problems with Baumatic STD6.1. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Baumatic STD6.1 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
