Instruction/ maintenance manual of the product Digital Camera Canon
Go to page of 9
How To hardwire the CANON SURE SHOT OWL PF DATE 35mm CAMERA Revised 1/12/04 This document outlines the modifi cation of the Canon Sure Shot Owl PF Date Camera so the shutter controls can be operated remotely.
Remove screw inside camera enclo sure #2 Remove Viewfinder Shroud, Battery Door, and Shutter Button Assembly Remove viewfinder shroud by prying shroud Viewfinder shroud removed from away from camera body at the top corner. camera body. Remove shutter button assembly.
#3 Remove the Camera Body from the Camera Cover Remove the camera body from the camera cover by prying the body from the battery compartment. The camera body can be removed completely from the camera cover. The camera body removed from the camera cover.
#4 Modify Wire Route and Attach Wiring Harness Locate camera body side with strap guide. Notch the strap guide for the wire route. Insert wires through lower hole i n camera cover, and hot glue “free” end into strap guide sl ot.
#5 Wiring the Camera Wire the camera with the foll owing positions. One wi re is soldered to the pad that connects to pin 6, (counted from right to left) on the t op pc board of the camera. This is the refresh wire. One wire is soldered to the pad that connects to pin 5, (counted from right to l eft) on the top pc board of the camera.
Better picture of solder pad 4 (common) #6 Reassemble Camera Body and Cover Slide camera body into camera cover i nserting right side of camera body fi rst.
Pry camera cover over door latch and slide camera body back i nto camera cover. Check fit at bottom of camera cover. Check fit on top of camera cover Check wiring harness to make sure wires are not l ocated directly under top screw hole.
#7 Reinstall Shutter Button Assembly, Battery Door, and Viewfi nder Shroud. Reinstall shutter button assembl y, battery door, and viewfinder shroud that were removed in step #2. #8 Reinstall Sc rews Reinstall screws, starti ng with the longest screws at the strap guide holes.
#9 Finish Hardwired Camera and Testing Complete wired camera with “three wi re” setup, showing servo three wire connector. To test camera, refresh wire #6 and shutter wire #5 are solder together. Camera will fire flas h when these two wires are touched to common wire #4.
An important point after buying a device Canon Digital Camera (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Canon Digital Camera yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Canon Digital Camera - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Canon Digital Camera you will learn all the available features of the product, as well as information on its operation. The information that you get Canon Digital Camera will certainly help you make a decision on the purchase.
If you already are a holder of Canon Digital Camera, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Canon Digital Camera.
However, one of the most important roles played by the user manual is to help in solving problems with Canon Digital Camera. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Canon Digital Camera along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
