Instruction/ maintenance manual of the product TSTATBBP250-LA Bryant
Go to page of 8
CONTENTS Page SAFETY CONSIDERA TIONS ........................1 GENERAL .......................................1 INST ALLA TION .................................1 - 7 I. Select Thermostat Location ..................1 II. Install Thermostat ............
II. INST ALL THERMOST A T W ARNING: Before installing thermostat, turn of f all power to the unit. There may be more than one power disconnect. Electrical shock can cause injury or death. 1. T urn of f all power to unit. 2. If an existing thermostat is being replaced: a.
LEGEND W2 — Second-Stage Heat Y2 — Second-Stage Compressor RS2 — Second Remote Sensor (Not Used) RS+5 — +5 vdc for 2 Sensors RS1 — Remote Sensor RS GND — Ground for 2 Sensors W1/O/B — Fi.
A. Heat Pump Configuration (Steps 3 and 4) T o set the thermostat for heat pump operation, Advanced Setup Step 3 must be configured to ON. Use the UP and DOWN ARROW buttons to configure the step. The default is OFF . Press the mode button to continue to Step 4.
Security Minimum Cool Set Point (Step 17) If the Security Level is not set to 0, the minimum cooling set point will be in ef fect. The user will not be allowed to set the cooling set point below the specified value. The range of val- ues is 35 to 99 F (1 to 37 C).
1 1. The Copy command can be used to copy the previous day’ s schedule if the schedules are the same. The copy command becomes available after all the occupied pe- riods are programmed in a day . Use the UP ARROW to change the copy command to YES. Use the DOWN AR- ROW to change the copy command to NO.
T able 3 — Daily Schedule Planner DA Y OF THE WEEK SCHEDULE Occupied 1 Occupied 2 Occupied 3 Unoccupied Start / Stop / Heat / Cool Start / Stop / Heat / Cool Start / Stop / Heat / Cool Heat / Cool M.
IX. REMOTE TEMPERA TURE SENSOR A remote temperature sensor is available to read the tem- perature from a space. If a remote temperature sensor is connected, the thermostat will ignore the reading of its in- ternal sensor . When the thermostat is using a reading from a remote sensor , the degree symbol above the tempera- ture reading will blink.
An important point after buying a device Bryant TSTATBBP250-LA (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Bryant TSTATBBP250-LA yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Bryant TSTATBBP250-LA - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Bryant TSTATBBP250-LA you will learn all the available features of the product, as well as information on its operation. The information that you get Bryant TSTATBBP250-LA will certainly help you make a decision on the purchase.
If you already are a holder of Bryant TSTATBBP250-LA, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Bryant TSTATBBP250-LA.
However, one of the most important roles played by the user manual is to help in solving problems with Bryant TSTATBBP250-LA. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Bryant TSTATBBP250-LA along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
